Combustion, performance and emissions characteristics of a spark-ignition engine fueled with isopropanol-n-butanol-ethanol and gasoline blends

Abstract Among primary alcohols, bio- n -butanol is considered as a promising alternative fuel candidate. However, relatively low production efficiency and high cost of component recovery from the acetone- n -butanol-ethanol (ABE) or isopropanol- n -butanol-ethanol (IBE) fermentation processes hinders industrial-scale production of bio- n -butanol. Hence it is of interest to study the intermediate fermentation product, i.e. ABE and IBE as a potential alternative fuels. However, for fuel applications, the IBE mixture appears to be more attractive than ABE due to more favorable properties of isopropanol over acetone, such as being less corrosive to engine part, higher energy density and octane number. In this study, an experimental investigation on the performance, combustion and emission characteristics of a port fuel-injection SI engine fueled with IBE-gasoline blends was carried out. By comparisons between IBE-gasoline blends with various IBE content (0–60 vol.% referred to as G100-IBE60) and more commonly used alternative alcohol fuels (ethanol, n -butanol and ABE)-gasoline blends, it was found that IBE30 performed well with respect to engine performance and emissions, including brake thermal efficiency (BTE), brake specific fuel consumption (BSFC), carbon monoxide (CO), unburned hydrocarbons (UHC) and nitrogen oxides (NO x ). Then, IBE30 was selected to be compared with G100 under various equivalence ratio ( Φ  = 0.83–1) and engine load (300 and 500 kPa BMEP). Overall, higher BTE (0.04–4.3%) and lower CO (4%), UHC (15.1–20.3%) and NO x (3.3–18.6%) emissions were produced by IBE30 compared to G100. Therefore, IBE could be a good alternative fuel to gasoline due to the environmentally benign fermentation process (from non-edible biomass feedstock and without recovery process) and the potential to improve energy efficiency and reduce pollutant emissions.

[1]  Yu-Cheng Chang,et al.  Green energy: Water-containing acetone–butanol–ethanol diesel blends fueled in diesel engines , 2013 .

[2]  Hongming Xu,et al.  Laminar Burning Velocities of 2,5-Dimethylfuran Compared with Ethanol and Gasoline , 2010 .

[3]  Karthik Nithyanandan,et al.  Investigating the Impact of Acetone on the Performance and Emissions of Acetone-Butanol-Ethanol (ABE) and Gasoline Blends in an SI Engine , 2015 .

[4]  O. Doğan.  The influence of n-butanol/diesel fuel blends utilization on a small diesel engine performance and emissions , 2011 .

[5]  R. Marchal,et al.  Simultaneous production of isopropanol, butanol, ethanol and 2,3-butanediol by Clostridium acetobutylicum ATCC 824 engineered strains , 2012, AMB Express.

[6]  S. Szwaja,et al.  Combustion of n-butanol in a spark-ignition IC engine , 2010 .

[7]  E. Green.  Fermentative production of butanol--the industrial perspective. , 2011, Current opinion in biotechnology.

[8]  Zuo-hua Huang,et al.  Comparative Study of High-Alcohol-Content Gasoline Blends in an SI Engine , 2015 .

[9]  Zuo-hua Huang,et al.  Emission characteristics of a spark-ignition engine fuelled with gasoline-n-butanol blends in combination with EGR , 2012 .

[10]  Il Moon,et al.  Advances in diesel–alcohol blends and their effects on the performance and emissions of diesel engines , 2013 .

[11]  Ronald K. Hanson,et al.  Shock tube determination of ignition delay times in full-blend and surrogate fuel mixtures , 2004 .

[12]  Özer Can,et al.  Effects of ethanol addition on performance and emissions of a turbocharged indirect injection Diesel engine running at different injection pressures , 2004 .

[13]  Lennox Siwale,et al.  Performance, combustion and emission characteristics of n-butanol additive in methanol–gasoline blend fired in a naturally-aspirated spark ignition engine , 2014 .

[14]  Zunqing Zheng,et al.  Effect of two-stage injection on combustion and emissions under high EGR rate on a diesel engine by fueling blends of diesel/gasoline, diesel/n-butanol, diesel/gasoline/n-butanol and pure diesel , 2015 .

[15]  S. Hochgreb,et al.  Measurements of laminar flame speeds of acetone/methane/air mixtures , 2011 .

[16]  Haji Hassan Masjuki,et al.  Effect of ethanol–gasoline blend on NOx emission in SI engine , 2013 .

[17]  Chao Jin,et al.  Progress in the production and application of n-butanol as a biofuel , 2011 .

[18]  Mingfa Yao,et al.  Time-resolved spray, flame, soot quantitative measurement fueling n-butanol and soybean biodiesel in a constant volume chamber under various ambient temperatures , 2014 .

[19]  Y. Jang,et al.  Metabolic engineering of Clostridium acetobutylicum for the enhanced production of isopropanol‐butanol‐ethanol fuel mixture , 2013, Biotechnology progress.

[20]  P. Aleiferis,et al.  Characterisation of flame development with ethanol, butanol, iso-octane, gasoline and methane in a direct-injection spark-ignition engine , 2013 .

[21]  Yakup Sekmen,et al.  The effects of ethanol―unleaded gasoline blends on engine performance and exhaust emissions in a spark-ignition engine , 2009 .

[22]  F. Egolfopoulos,et al.  Studies of n-propanol, iso-propanol, and propane flames , 2011 .

[23]  Charles K. Westbrook,et al.  A comparative experimental and computational study of methanol, ethanol, and n-butanol flames , 2010 .

[24]  Jingping Liu,et al.  The heat release analysis of bio-butanol/gasoline blends on a high speed SI (spark ignition) engine , 2013 .

[25]  Karthik Nithyanandan,et al.  Impacts of Acetone–Butanol–Ethanol (ABE) ratio on spray and combustion characteristics of ABE–diesel blends , 2015 .

[26]  Tsung-Lin Wu,et al.  Engine performance and pollutant emission of an SI engine using ethanol–gasoline blended fuels , 2002 .

[27]  Alessio Frassoldati,et al.  An Experimental and Kinetic Modeling Study of Pyrolysis and Combustion of Acetone–Butanol–Ethanol (ABE) Mixtures , 2012 .

[28]  Derek Dunn-Rankin,et al.  Lean Combustion Technology and Control , 2011 .

[29]  P. Claassen,et al.  "In situ" removal of isopropanol, butanol and ethanol from fermentation broth by gas stripping. , 2013, Bioresource technology.

[30]  Ming Huo,et al.  Different percentage of acetone-butanol-ethanol (ABE) and diesel blends at low temperature condition in a constant volume chamber , 2014 .

[31]  Mingfa Yao,et al.  Effects of n-butanol, 2-butanol, and methyl octynoate addition to diesel fuel on combustion and emissions over a wide range of exhaust gas recirculation (EGR) rates , 2013 .

[32]  Lisa Graham,et al.  Emissions from light duty gasoline vehicles operating on low blend ethanol gasoline and E85 , 2008 .

[33]  N. M. Likhterova,et al.  Problems in production of high-octane, unleaded automotive gasolines , 2006 .

[34]  Reda M. Bata,et al.  The performance and emission characteristics of C1-C5 alcohol-gasoline blends with matched oxygen content in a single-cylinder spark ignition engine , 1998 .

[35]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[36]  F. Halter,et al.  Evaluation of Butanol–Gasoline Blends in a Port Fuel-injection, Spark-Ignition Engine , 2010 .

[37]  Thomas Wallner,et al.  Analytical Assessment of C2–C8 Alcohols as Spark-Ignition Engine Fuels , 2013 .

[38]  Zunqing Zheng,et al.  Experimental and simulation investigation of the combustion characteristics and emissions using n-butanol/biodiesel dual-fuel injection on a diesel engine , 2014 .

[39]  Michael Wang,et al.  Assessment of potential life‐cycle energy and greenhouse gas emission effects from using corn‐based butanol as a transportation fuel , 2008, Biotechnology progress.

[40]  J. Heywood.  Pollutant formation and control in spark ignition engines , 1975 .

[41]  Kenneth Kar,et al.  Measurement of Vapor Pressures and Enthalpies of Vaporization of Gasoline and Ethanol Blends and Their Effects on Mixture Preparation in an SI Engine , 2008 .

[42]  Wenming Yang,et al.  Development of a skeletal mechanism for biodiesel blend surrogates with varying fatty acid methyl esters proportion , 2016 .

[43]  Vladimir A. Alekseev,et al.  Laminar burning velocity of gasoline and the gasoline surrogate components iso-octane, n-heptane and toluene , 2013 .

[44]  Karthik Nithyanandan,et al.  Improved SI engine efficiency using Acetone–Butanol–Ethanol (ABE) , 2016 .

[45]  Zunqing Zheng,et al.  Experimental study on diesel conventional and low temperature combustion by fueling four isomers of butanol , 2015 .

[46]  C. Lee,et al.  Soot Emissions of Various Oxygenated Biofuels in Conventional Diesel Combustion and Low-Temperature Combustion Conditions , 2012 .

[47]  Jingping Liu,et al.  Combustion and emissions study on motorcycle engine fueled with butanol-gasoline blend , 2015 .

[48]  A. Ota,et al.  The Effect of Ethanol Fuel on a Spark Ignition Engine , 2006 .

[49]  Philippe Soucaille,et al.  Metabolic engineering of Clostridium acetobutylicum ATCC 824 for the high-yield production of a biofuel composed of an isopropanol/butanol/ethanol mixture. , 2013, Metabolic engineering.

[50]  Sang Yup Lee,et al.  Metabolic Engineering of Clostridium acetobutylicum ATCC 824 for Isopropanol-Butanol-Ethanol Fermentation , 2011, Applied and Environmental Microbiology.

[51]  Shengming Liao,et al.  Effect of water-containing acetone–butanol–ethanol gasoline blends on combustion, performance, and emissions characteristics of a spark-ignition engine , 2016 .

[52]  John B. Heywood,et al.  An Overview of Hydrocarbon Emissions Mechanisms in Spark-Ignition Engines , 1993 .