Dynamic identification of an ancient masonry bell tower using a MEMS-based acquisition system

In this paper results of dynamic tests performed on a bell tower located in Ficarolo (Italy) are reported. After the Emilia earthquake that occurred in 2012, the bell tower reported a serious damage pattern and, as a consequence, retrofitting interventions were carried out. Dynamic tests before and after the strengthening were performed to investigate the modal properties of the bell tower and to evaluate possible changes in dynamic behavior due to the intervention. Accelerations during ambient vibrations were recorded by means of an advanced MEMS-based system, whose main features are the transmission of the data in digital form and the possibility of performing some system analyses directly on-board of the sensors. Accelerations were acquired using 11 biaxial MEMS units. First 8 modes are clearly identified, with natural frequencies in the range 0.5-9.0 Hz. Finally, a comparison between the performances of the installed MEMS-based system and a traditional analog (piezoelectric) system is carried out and results are critically compared.

[1]  Loris Vincenzi,et al.  A surrogate-assisted evolutionary algorithm for dynamic structural identification , 2014 .

[2]  Laura Scognamiglio,et al.  The 2012 Pianura Padana Emiliana seimic sequence: locations, moment tensors and magnitudes , 2012 .

[3]  L. Mulder.  Applied frequency-domain system identification in the fieldof experimental modal analysis , 2017 .

[4]  Marco Savoia,et al.  Coupling Response Surface and Differential Evolution for Parameter Identification Problems , 2015, Comput. Aided Civ. Infrastructure Eng..

[5]  C. Van Hoof,et al.  A 3-axis accelerometer and strain sensor system for building integrity monitoring , 2011, 2011 16th International Solid-State Sensors, Actuators and Microsystems Conference.

[6]  R. Stephenson.  A and V , 1962, The British journal of ophthalmology.

[7]  Rune Brincker,et al.  Modal identification of output-only systems using frequency domain decomposition , 2001 .

[8]  Julius S. Bendat,et al.  Engineering Applications of Correlation and Spectral Analysis , 1980 .

[9]  Amy L. Murphy,et al.  Wireless sensor networks for permanent health monitoring of historic buildings , 2010 .

[10]  Loris Vincenzi,et al.  Identification of the Manhattan bridge dynamic properties for fatigue Assessment , 2013 .

[11]  Gabriele Milani,et al.  Lesson learned after the Emilia-Romagna, Italy, 20–29 May 2012 earthquakes: A limit analysis insight on three masonry churches , 2013 .

[12]  Roberto Guidorzi,et al.  Structural monitoring of a tower by means of MEMS-based sensing and enhanced autoregressive models , 2014, Eur. J. Control.

[13]  Iunio Iervolino,et al.  Engineering seismic demand in the 2012 Emilia sequence: preliminary analysis and model compatibility assessment , 2012 .

[14]  Charles R. Farrar,et al.  Damage identification and health monitoring of structural and mechanical systems from changes in their vibration characteristics: A literature review , 1996 .

[15]  Carlos E. Ventura,et al.  Damping estimation by frequency domain decomposition , 2001 .

[16]  G. Roeck,et al.  Structural damage identification of the highway bridge Z24 by FE model updating , 2004 .

[17]  Gaetano Manfredi,et al.  Robust output-only modal identification and monitoring of buildings in the presence of dynamic interactions for rapid post-earthquake emergency management , 2012 .

[18]  Matthew J. Whelan,et al.  Wireless Monitoring of a Multispan Bridge Superstructure for Diagnostic Load Testing and System Identification , 2011, Comput. Aided Civ. Infrastructure Eng..