Improve dtc performance for IPMSM by fuzzy-controller and auto-tuning PI compensator

To improve the outputting performance of conventional direct torque control (DTC) system for interior permanent magnet synchronous motor (IPMSM), a new synthesizing DTC method was presented in this paper, which adopted fuzzy controller and auto-tuning proportional-integral (PI) compensator to reduce the flux and torque ripples. The improvement of motor performance by proposed schemes was analyzed in detail. In compared with conventional DTC, The simulation results proved that the PI estimator could track the stator resistance and diminish the influence of flux and torque due to the stator resistance change, the ripples of the flux and the torque were reduced greatly by compensator and fuzzy controller, and the static and dynamic performance of the system was improved, especially strengthened tracking ability and robustness of the system. So the method was very effective and feasible.

[1]  Jun Liu,et al.  Application of fuzzy control in direct torque control of permanent magnet synchronous motor , 2004, Fifth World Congress on Intelligent Control and Automation (IEEE Cat. No.04EX788).

[2]  Lin Hui.  Direct Torque Control System of Induction Motor Based on Fuzzy Control , 2010 .

[3]  Pasi Pohjalainen,et al.  The Next Generation Motor Control Method: Direct Torque Control (DTC) , 1995 .

[4]  D. S. Zinger,et al.  PI and fuzzy estimators for tuning the stator resistance in direct torque control of induction machines , 1994 .

[5]  Dong-Seok Hyun,et al.  Direct Torque Control of induction motor with reduction of torque ripple , 2000, 2000 26th Annual Conference of the IEEE Industrial Electronics Society. IECON 2000. 2000 IEEE International Conference on Industrial Electronics, Control and Instrumentation. 21st Century Technologies.

[6]  Byeong-Seok Lee,et al.  Adaptive stator resistance compensator for high performance direct torque controlled induction motor drives , 1998, Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242).

[7]  P. Tiitinen,et al.  The next generation motor control method, DTC direct torque control , 1996, Proceedings of International Conference on Power Electronics, Drives and Energy Systems for Industrial Growth.

[8]  Jianping Xu,et al.  A new control method for permanent magnet synchronous machines with observer , 2004, 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551).

[9]  Toshihiko Noguchi,et al.  A New Quick-Response and High-Efficiency Control Strategy of an Induction Motor , 1986, IEEE Transactions on Industry Applications.