Radio frequency current-voltage probe for impedance and power measurements in multi-frequency unmatched loads.

A broad-band, inline current-voltage probe, with a characteristic impedance of 50 Ω, is presented for the measurement of voltage and current waveforms, impedance, and power in rf systems. The probe, which uses capacitive and inductive sensors to determine the voltage and current, respectively, can be used for the measurement of single or multi-frequency signals into both matched and unmatched loads, over a frequency range of about 1-100 MHz. The probe calibration and impedance/power measurement technique are described in detail, and the calibrated probe results are compared with those obtained from a vector network analyzer and other commercial power meters. Use of the probe is demonstrated with the measurement of power into an unmatched capacitively coupled plasma excited by multi-frequency tailored voltage waveforms.

[1]  J. Booth,et al.  Control of the ion flux and ion energy in CCP discharges using non-sinusoidal voltage waveforms , 2012 .

[2]  J. Booth,et al.  Separate control of the ion flux and ion energy in capacitively coupled radio-frequency discharges using voltage waveform tailoring , 2012 .

[3]  R. Boswell,et al.  Enhanced sheath heating in capacitively coupled discharges due to non-sinusoidal voltage waveforms , 2012 .

[4]  J. Booth,et al.  Microcrystalline silicon solar cells deposited using a plasma process excited by tailored voltage waveforms , 2012 .

[5]  U. Czarnetzki,et al.  The electrical asymmetry effect in multi-frequency capacitively coupled radio frequency discharges , 2011 .

[6]  J. Vanel,et al.  Nanocrystalline silicon film growth morphology control through RF waveform tailoring , 2010 .

[7]  U. Czarnetzki,et al.  The electrical asymmetry effect in capacitively coupled radio frequency discharges – measurements of dc self bias, ion energy and ion flux , 2009 .

[8]  Zoltan Donko,et al.  PIC simulations of the separate control of ion flux and energy in CCRF discharges via the electrical asymmetry effect , 2009 .

[9]  U. Czarnetzki,et al.  On the possibility of making a geometrically symmetric RF-CCP discharge electrically asymmetric , 2008 .

[10]  U. Czarnetzki,et al.  Numerical Modeling of Electron Beams Accelerated by the Radio Frequency Boundary Sheath , 2008, IEEE Transactions on Plasma Science.

[11]  A. Wendt,et al.  Arbitrary substrate voltage wave forms for manipulating energy distribution of bombarding ions during plasma processing , 2006 .

[12]  D. Gahan,et al.  In-line sensor for accurate rf power measurements , 2005 .

[13]  William G. Graham,et al.  Electrical characterization of radio frequency discharges , 2005 .

[14]  A. Lichtenberg,et al.  Principles of Plasma Discharges and Materials Processing: Lieberman/Plasma 2e , 2005 .

[15]  D. Mataras,et al.  Power dissipation and impedance measurements in radio‐frequency discharges , 1996 .

[16]  Michael P. Splichal,et al.  Electrical isolation of radio‐frequency plasma discharges , 1992 .

[17]  V. Godyak,et al.  In situ simultaneous radio frequency discharge power measurements , 1990 .

[18]  Carl Ekdahl,et al.  Voltage and current sensors for a high-density z-pinch experiment , 1980 .