Numerical analysis on dynamic behavior of solid oxide fuel cell with power output control scheme

Abstract The present paper discusses the dynamic behavior of a solid oxide fuel cell (SOFC) system under the load-following operation with adoption of four control schemes, conducting dynamic simulation. The dynamic modeling of the SOFC, which consists of a cell stack and reformer, was firstly carried out to predict the dynamic behavior to load change. Secondly, a control circuit model was implemented into the dynamic model. For the load-following operation, the SOFC DC power output, operating temperature, fuel utilization factor and steam-to-carbon ratio were employed as the controlled variables. The current density, air, fuel and steam flow rates were chosen for manipulated variables in the SOFC control schemes for the load-following operation. Feedback control methodology was adopted to achieve adequate operation of the SOFC. The dynamic simulation was conducted by assuming the rapid change of the power. The simulation results showed the capability of the multivariable control of the SOFC operation. The cell temperature control is quite important, however the direct measure of the cell temperature is difficult. In the proposed control scheme, the air temperature at the cathode outlet is employed as a controlled variable, and then the cell temperature can be indirectly adjusted with controlling the cathode outlet temperature.

[1]  William J. Wepfer,et al.  A Mathematical Model of a Tubular Solid Oxide Fuel Cell , 1995 .

[2]  Y. Inui,et al.  Analytical investigation on cell temperature control method of planar solid oxide fuel cell , 2006 .

[3]  R. Rengaswamy,et al.  A Review of Solid Oxide Fuel Cell (SOFC) Dynamic Models , 2009 .

[4]  E. Achenbach.  Three-dimensional and time-dependent simulation of a planar solid oxide fuel cell stack , 1994 .

[5]  Randall Gemmen,et al.  Effect of load transients on SOFC operation—current reversal on loss of load , 2005 .

[6]  Raghunathan Rengaswamy,et al.  Dynamic modeling and validation studies of a tubular solid oxide fuel cell , 2009 .

[7]  N. Bessette,et al.  A Mathematical Model of a Solid Oxide Fuel Cell , 1995 .

[8]  Shinji Kimijima,et al.  A Performance Analysis of a Solid Oxide Fuel Cell - Micro Gas Turbine Hybrid System Using Biogas , 2009 .

[9]  Kevin Tomsovic,et al.  Development of models for analyzing the load-following performance of microturbines and fuel cells , 2002 .

[10]  J. Szmyd,et al.  An Analysis of Biogas Reforming Process on Ni/YSZ and Ni/SDC Catalysts , 2012 .

[11]  Stefano Campanari,et al.  Full Load and Part-Load Performance Prediction for Integrated SOFC and Microturbine Systems , 1999 .

[12]  Olav Bolland,et al.  Finite-volume modeling and hybrid-cycle performance of planar and tubular solid oxide fuel cells , 2005 .

[13]  Tong Seop Kim,et al.  Performance analysis of a tubular solid oxide fuel cell/micro gas turbine hybrid power system based on a quasi-two dimensional model , 2005 .

[14]  E. Riensche,et al.  Methane/steam reforming kinetics for solid oxide fuel cells , 1994 .

[15]  Miriam Kemm,et al.  Steady state and transient thermal stress analysis in planar solid oxide fuel cells , 2005 .

[16]  Peiwen Li,et al.  Numerical Modeling and Performance Study of a Tubular SOFC , 2004 .

[17]  Ching-ju Wen,et al.  Design and evaluation of combined cycle system with solid oxide fuel cell and gas turbine , 2000 .

[18]  Lars Imsland,et al.  Control strategy for a solid oxide fuel cell and gas turbine hybrid system , 2006 .

[19]  Faryar Jabbari,et al.  Novel solid oxide fuel cell system controller for rapid load following , 2007 .

[20]  Kevin Huang,et al.  Performance of a commercial cathode-supported solid oxide fuel cells prepared by single-step infiltration of an ion-conducting electrocatalyst , 2012 .

[21]  Aristide F. Massardo,et al.  Design and part-load performance of a hybrid system based on a solid oxide fuel cell reactor and a micro gas turbine , 2001 .

[22]  Fabian Mueller,et al.  On the intrinsic transient capability and limitations of solid oxide fuel cell systems , 2009 .

[23]  Shinji Kimijima,et al.  Cycle Analysis of Gas Turbine–Fuel Cell Cycle Hybrid Micro Generation System , 2004 .

[24]  Fabian Mueller,et al.  On control concepts to prevent fuel starvation in solid oxide fuel cells , 2008 .

[25]  Shinji Kimijima,et al.  Performance analysis for the part-load operation of a solid oxide fuel cell–micro gas turbine hybrid system , 2008 .

[26]  S. Chan,et al.  A complete polarization model of a solid oxide fuel cell and its sensitivity to the change of cell component thickness , 2001 .

[27]  Raymond Anthony George,et al.  Status of tubular SOFC field unit demonstrations , 2000 .

[28]  F. Jabbari,et al.  Feedback control of solid oxide fuel cell spatial temperature variation , 2010 .

[29]  E. Iglesia,et al.  Isotopic and kinetic assessment of the mechanism of reactions of CH4 with CO2 or H2O to form synthesis gas and carbon on nickel catalysts , 2004 .

[30]  J.P.P. Huijsmans,et al.  Intermediate temperature SOFC – a promise for the 21st century , 1998 .

[31]  Takafumi Nishino,et al.  Numerical Analysis of a Cell-Based Indirect Internal Reforming Tubular SOFC Operating With Biogas , 2010 .

[32]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[33]  Grzegorz Brus,et al.  Numerical modelling of radiative heat transfer in an internal indirect reforming-type SOFC , 2008 .

[34]  Alessandro Zampieri,et al.  Cathode Polarizations of a Cathode-Supported Solid Oxide Fuel Cell , 2010 .

[35]  H. Iwai,et al.  Comprehensive Numerical Modeling and Analysis of a Cell-Based Indirect Internal Reforming Tubular SOFC , 2006 .