Two-phase flow boiling of R134a in a multi-microchannel heat sink for microprocessor cooling

The following study concentrates on two-phase flow boiling of refrigerant R134a inside two similar copper multi-microchannel heat sinks, one of which was designed for singlephase water cooling of microprocessors. The two-phase heat sink was composed of 100 parallel microchannels, 100 µm wide, 680 µm high, 15 mm long with 72 µm-thick fins, and 63 parallel microchannels. Base heat fluxes and channel-based mass fluxes were varied from 2.57 to 190 W/cm2 and from 205 to 1000 kg/m2 s, all at a nominal saturation temperature of 63°C. Local heat transfer coefficients were measured at 35 locations using localized heaters and temperature sensors. The main trend identified was that the heat transfer coefficient increased with heat flux at all vapor qualities and mass fluxes tested. Heat transfer coefficients as high as 250'000 W/m2K (relative to the base area) were reached, keeping the chip under 85°C. Backflow and flow instabilities were the main issues with the single-phase heat sink when used in flow boiling, leading to flow mal-distribution and jet impingement effects.

[1]  John R. Thome,et al.  High heat flux flow boiling in silicon multi-microchannels – Part III: Saturated critical heat flux of R236fa and two-phase pressure drops , 2008 .

[2]  John R. Thome,et al.  An analysis of experimental data and prediction methods for two-phase frictional pressure drop and flow boiling heat transfer in micro-scale channels , 2006 .

[3]  A. E. Bergles,et al.  On the Nature of Critical Heat Flux in Microchannels , 2003 .

[4]  J. Thome,et al.  Saturated critical heat flux in a multi-microchannel heat sink fed by a split flow system , 2010 .

[5]  I. Mudawar,et al.  Two-phase flow in high-heat-flux micro-channel heat sink for refrigeration cooling applications: Part II—heat transfer characteristics , 2005 .

[6]  J. Thome,et al.  Investigation of saturated critical heat flux in a single, uniformly heated microchannel , 2006 .

[7]  J. Thome,et al.  State of the Art of High Heat Flux Cooling Technologies , 2007 .

[8]  R. Shah.  Laminar Flow Forced convection in ducts , 1978 .

[9]  John R. Thome,et al.  A theoretical model for the prediction of the critical heat flux in heated microchannels , 2008 .

[10]  John R. Thome,et al.  Heat Transfer Model for Evaporation in Microchannels, Part I: Presentation of the Model , 2004 .

[11]  John R. Thome,et al.  Critical heat flux in multi-microchannel copper elements with low pressure refrigerants , 2010 .

[12]  John R. Thome,et al.  High heat flux flow boiling in silicon multi-microchannels – Part II: Heat transfer characteristics of refrigerant R245fa , 2008 .

[13]  B. Michel,et al.  High Heat Flux Two-Phase Cooling in Silicon Multimicrochannels , 2008, IEEE Transactions on Components and Packaging Technologies.