Stress corrosion cracking behaviour of 8090 Al–Li alloy in a chloride containing medium

Abstract Studies of the stress corrosion cracking behaviour of an Al–Li alloy (8090) in the underaged, peak aged and overaged conditions were conducted using a constant load technique in a chloride containing solution. The stress corrosion tests were carried out using a range of applied stress values under both anodic and cathodic polarisation. It was observed that the material is susceptible to stress corrosion cracking in all aged conditions. However, the peak aged alloy displayed the lowest resistance to stress corrosion cracking, while the underaged material had the greatest resistance to stress corrosion cracking among the three conditions studied. The presence of δ precipitates throughout the matrix of the peak aged material imparts constraint to plastic deformation, making it more susceptible to stress corrosion cracking when compared to materials in the underaged or overaged conditions. Study of the effect of polarisation on the stress corrosion response of the material has revealed that no cracking occurs when the material is cathodically polarised, while anodic polarisation accelerates the stress corrosion cracking. Initial stress corrosion crack propagation occurs intergranularly, but final failure is transgranular. It has been noted that the initiation of stress corrosion cracking is associated with the dissolution of grain boundary precipitates. However, hydrogen induced localised plasticity may contribute at a later stage to the propagation of cracks.

[1]  M. Talianker,et al.  Effect of retrogression and reaging on the precipitates in an 8090 Al–Li alloy , 1998 .

[2]  F. Wall,et al.  The evaluation of the critical electrochemical potentials influencing environmentally assisted cracking of Al-Li-Cu alloys in selected environments , 1997 .

[3]  R. Braun.  Evaluation of the stress corrosion cracking behaviour of damage-tolerant AlLi sheet using the slow strain rate testing technique , 1995 .

[4]  D. B. Goel,et al.  δ Precipitation in an AlLiCuMgZr alloy , 1994 .

[5]  Y. L. Liu,et al.  Corrosion Behavior of 8090 Al-Li Alloy , 1993 .

[6]  J. Schijve,et al.  Stress Corrosion Cracking Behavior of Al Li 2090-T83 in Artificial Seawater , 1992 .

[7]  E. Meletis,et al.  The role of the T1 phase in the pre-exposure and hydrogen embrittlement of AlLiCu alloys , 1991 .

[8]  E. Lavernia,et al.  Strength, deformation, fracture behaviour and ductility of aluminium-lithium alloys , 1990 .

[9]  T. Devine,et al.  Influence of Aging at 200 C on the Corrosion Resistance of Al-Li and Al-Li-Cu Alloys , 1989 .

[10]  J. Lumsden,et al.  The Stress Corrosion Cracking Behavior of AlLi Alloy 8090 , 1988 .

[11]  E. Meletis.  Microstructure and stress-corrosion cracking relationship in an AlLiCuZr alloy , 1987 .

[12]  R. Dorward,et al.  Stress Corrosion Cracking Behavior of an AlLiCuMg Alloy , 1987 .

[13]  P. Gregson,et al.  Solid state phase transformations in aluminium alloys containing lithium , 1987 .

[14]  C. J. Peel,et al.  Aluminium alloys for airframes – limitations and developments , 1986 .

[15]  M. O. Speidel,et al.  Stress corrosion cracking of aluminum alloys , 1975 .