Synthesis of hydrophobic resorcinol–formaldehyde xerogels by grafting with silanes

[1]  Wei Zhao,et al.  One-pot solvothermal synthesis of robust ambient-dried polyimide aerogels with morphology-enhanced superhydrophobicity for highly efficient continuous oil/water separation , 2017 .

[2]  B. Kiskan.  Adapting benzoxazine chemistry for unconventional applications , 2017, Reactive and Functional Polymers.

[3]  J. A. Menéndez,et al.  Desiccant capability of organic xerogels: Surface chemistry vs porous texture , 2016 .

[4]  D. Vollet,et al.  Structure and diffuse-boundary in hydrophobic and sodium dodecyl sulfate-modified silica aerogels , 2016 .

[5]  J. A. Menéndez,et al.  Effect of methanol content in commercial formaldehyde solutions on the porosity of RF carbon xerogels , 2015 .

[6]  A. Ślosarczyk,et al.  Synthesis and characterisation of silica aerogel/carbon microfibers nanocomposites dried in supercritical and ambient pressure conditions , 2015, Journal of Sol-Gel Science and Technology.

[7]  F. Carrasco-Marín,et al.  Effect of dilution ratio and drying method of resorcinol–formaldehyde carbon gels on their electrocapacitive properties in aqueous and non-aqueous electrolytes , 2015, Journal of Sol-Gel Science and Technology.

[8]  J. A. Menéndez,et al.  Simultaneous adjustment of the main chemical variables to fine-tune the porosity of carbon xerogels , 2014 .

[9]  H. Zipse,et al.  The Lewis base-catalyzed silylation of alcohols--a mechanistic analysis. , 2014, The Journal of organic chemistry.

[10]  S. Zhai,et al.  Preparation of superhydrophobic materials for oil/water separation and oil absorption using PMHS–TEOS-derived xerogel and polystyrene , 2014, Journal of Sol-Gel Science and Technology.

[11]  Saffa Riffat,et al.  Toward aerogel based thermal superinsulation in buildings: A comprehensive review , 2014 .

[12]  R. Moliner,et al.  Fuel cell performance of Pt electrocatalysts supported on carbon nanocoils , 2014 .

[13]  J. A. Menéndez,et al.  Carbonisation of resorcinol–formaldehyde organic xerogels: Effect of temperature, particle size and heating rate on the porosity of carbon xerogels , 2013 .

[14]  L. Pilato.  Phenolic resins: 100Years and still going strong , 2013 .

[15]  J. A. Menéndez,et al.  High energy ultracapacitor based on carbon xerogel electrodes and sodium sulfate electrolyte , 2012 .

[16]  P. B. Wagh,et al.  Thermally stable and transparent superhydrophobic sol–gel coatings by spray method , 2012, Journal of Sol-Gel Science and Technology.

[17]  G. McHale,et al.  The superhydrophobicity of polymer surfaces: Recent developments , 2011 .

[18]  J. A. Menéndez,et al.  Fast microwave-assisted synthesis of tailored mesoporous carbon xerogels. , 2011, Journal of colloid and interface science.

[19]  Sung Min Kang,et al.  One-step modification of superhydrophobic surfaces by a mussel-inspired polymer coating. , 2010, Angewandte Chemie.

[20]  Lei Jiang,et al.  Fabrication and Characterization of Superhydrophobic Surfaces with Dynamic Stability , 2010 .

[21]  A. Arenillas,et al.  A comparison of physical activation of carbon xerogels with carbon dioxide with chemical activation using hydroxides , 2010 .

[22]  F. J. Maldonado-Hódar,et al.  Textural and mechanical characteristics of carbon aerogels synthesized by polymerization of resorcinol and formaldehyde using alkali carbonates as basification agents. , 2010, Physical chemistry chemical physics : PCCP.

[23]  J. A. Menéndez,et al.  Ni-doped carbon xerogels for H2 storage , 2010 .

[24]  Pradip B. Sarawade,et al.  Preparation of hydrophobic mesoporous silica powder with a high specific surface area by surface modification of a wet-gel slurry and spray-drying , 2010 .

[25]  P. Carrott,et al.  New carbon materials with high porosity in the 1―7 nm range obtained by chemical activation with phosphoric acid of resorcinol―formaldehyde aerogels , 2009 .

[26]  Meikun Yang,et al.  Structural characteristics and thermal conductivity of ambient pressure dried silica aerogels with one-step solvent exchange/surface modification , 2009 .

[27]  F. Carrasco-Marín,et al.  Adsorption of benzene, toluene, and xylenes on monolithic carbon aerogels from dry air flows. , 2007, Langmuir : the ACS journal of surfaces and colloids.

[28]  J. Pirard,et al.  Non Intrusive Mercury Porosimetry: Pyrolysis of Resorcinol‐Formaldehyde Xerogels , 2006 .

[29]  A. Takahara,et al.  Super-liquid-repellent surfaces prepared by colloidal silica nanoparticles covered with fluoroalkyl groups. , 2005, Langmuir : the ACS journal of surfaces and colloids.

[30]  Guozhong Cao,et al.  Optically transparent superhydrophobic silica-based films , 2005 .

[31]  D. Lecomte,et al.  Study of evaporative drying of treated silica gels , 2004 .

[32]  James A. Ritter,et al.  Preparation and Properties of Resorcinol–Formaldehyde Organic and Carbon Gels , 2003 .

[33]  J. Baruah,et al.  Polyphenolic Compounds: an Overview , 2002 .

[34]  O. Takai,et al.  Preparation of ultra water-repellent films by microwave plasma-enhanced CVD , 1997 .

[35]  Ying Wang,et al.  Fabricating hydrophobic nanoparticles within mesoporous channel of silica for efficient TSNA removal , 2017 .

[36]  D. Rentsch,et al.  The Surface Chemistry of Hydrophobic Silica Aerogels , 2015 .

[37]  A. Puente,et al.  Optimization of the process variables in the microwave-induced synthesis of carbon xerogels , 2014 .

[38]  C. Erkey,et al.  Three-dimensional optofluidic waveguides in hydrophobic silica aerogels via supercritical fluid processing , 2013 .

[39]  K. Kanamori.  Liquid-phase synthesis and application of monolithic porous materials based on organic–inorganic hybrid methylsiloxanes, crosslinked polymers and carbons , 2011, Journal of Sol-Gel Science and Technology.

[40]  Hyung‐Ho Park,et al.  Ambient pressure dried TEOS-based silica aerogels: good absorbents of organic liquids , 2010 .

[41]  J. A. Menéndez,et al.  Microwave heating processes involving carbon materials , 2010 .

[42]  Nathalie Job,et al.  Porous carbon xerogels with texture tailored by pH control during sol–gel process , 2004 .