Effects of tensile loading on the properties of longitudinal-mode elastic-wave propagation in a 1.52-cm-diam, seven-wire strand used for prestressed concrete structures were investigated experimentally. In an unloaded state, the wave propagation properties in strand matched those seen in individual wires comprising the strand, namely, straight center wire and helical outer wires. In the strand, however, extraneous signals were found to be produced from the propagating wave due to physical interactions between the adjacent wires. Under tensile loading, it was observed that a certain portion of the frequency components of the wave became highly attenuative and, thus, absent in the frequency spectrum of the wave. The center frequency of this missing portion, called notch frequency, was found to increase linearly with log N, where N is the applied tensile load. In addition, on both sides of the notch frequency, the wave exhibited a large dispersion in a manner similar to the behavior near a cutoff frequency. ...
[1]
Dispersion Curves for Longitudinal and Flexural Waves in Solid Circular Cylinders
,
1958
.
[2]
H. Kwun,et al.
Detection of fractured wires in steel cables using magnetorestrictive sensors
,
1994
.
[3]
G. J. Kynch.
The fundamental modes of vibration of uniform beams for medium wavelengths
,
1957
.
[4]
K. A. Bartels,et al.
Experimental observation of elastic‐wave dispersion in bounded solids of various configurations
,
1996
.
[5]
J. Zemanek,et al.
An Experimental and Theoretical Investigation of Elastic Wave Propagation in a Cylinder
,
1962
.
[6]
Allen H. Meitzler,et al.
Mode Coupling Occurring in the Propagation of Elastic Pulses in Wires
,
1961
.
[7]
G. Mott,et al.
Elastic waveguide propagation in an infinite isotropic solid cylinder that is subjected to a static axial stress and strain
,
1973
.