The influence of operating condition on acoustic emission (AE) generation during meshing of helical and spur gear

The application of high-frequency acoustic emission (AE) technology to condition monitoring of gears is still in its infancy. Understanding the influence of gear operating parameters on the generation of AE is essential in applying the AE technology to gear condition monitoring. This paper presents experimental findings on the influence of speed and load in generating AE for operating helical and spur gears. The experimental findings suggest that any percentage reduction in specific film thickness (gimel), a direct consequence of a change in load condition, results in a nine- and four-fold percentage change in AE rms for the spur and helical gear sets, respectively. A numerical model representing changes in AE rms with variation in load and speed under near isothermal conditions for spur and helical gears was also established. In conclusion, it is postulated that the AE technology could offer a means of measuring in situ the effectiveness of a lubricant for operational spur and helical gears thereby establishing if the correct lubricating conditions are present to ensure optimal life usage.

[1]  R. Larsson.  Transient non-Newtonian elastohydrodynamic lubrication analysis of an involute spur gear , 1997 .

[2]  David Mba,et al.  Development of Acoustic Emission Technology for Condition Monitoring andDiagnosis of Rotating Machines; Bearings, Pumps, Gearboxes, Engines and RotatingStructures. , 2006 .

[3]  R. J. Boness,et al.  Adhesive and abrasive wear studies using acoustic emission techniques , 1991 .

[4]  John J. Coy,et al.  Dynamic Capacity and Surface Fatigue Life for Spur and Helical Gears , 1976 .

[5]  Duncan Dowson,et al.  Elastohydrodynamic and micro-elastohydrodynamic lubrication , 1995 .

[6]  R. J. Boness,et al.  Wear studies using acoustic emission techniques , 1990 .

[7]  David,et al.  Identification of the acoustic emission source during a comparative study on diagnosis of a spur gearbox , 2005 .

[8]  Arthur W. Lees,et al.  Detection of severe sliding and pitting fatigue wear regimes through the use of broadband acoustic emission , 2005 .

[9]  David,et al.  Application of acoustic emission to seeded gear fault detection , 2005 .

[10]  Linilson Rodrigues Padovese,et al.  Effect of lubricant viscosity grade on mechanical vibration of roller bearings , 2007 .

[11]  Masayasu Ohtsu,et al.  Acoustic Emission Testing , 2006, Advanced Materials Research.

[12]  David,et al.  Observations of acoustic emission activity during gear defect diagnosis , 2003 .

[13]  D. Dowson,et al.  Past, present and future studies in elastohydrodynamics , 1999 .

[14]  D Mba,et al.  Experimentally Established Correlation between Acoustic Emission Activity, Load, Speed, and Asperity Contact of Spur Gears Under Partial Elastohydrodynamic Lubrication , 2005 .

[15]  Paul McIntire,et al.  Acoustic emission testing , 1987 .