The last years saw a renewal of interest for hypersonic research in general and regenerative cooling specifically, with a large increase of the number of dedicated facilities and technical studies. In order to quantify the heat transfer in the cooled structures and the composition of the cracked fuel entering the combustor, an accurate model of the thermal decomposition of the fuel is required. This model should be able to predict the fuel chemical composition and physical properties for a broad range of pressures, temperatures and cooling geometries. For this purpose, an experimental and modeling study of the thermal decomposition of generic molecules (long-chain or polycyclic alkanes) that could be good surrogates of real fuels, has been started at the DCPR laboratory located in Nancy (France). This successful effort leads to several versions of a complete kinetic model. These models do not assume any effect from the material that constitutes the cooling channel. A specific experimental study was performed with two different types of steel (regular: E37, stainless: 316L). Some results are given in the present paper.
[1]
F. Billaud,et al.
Coke Formation During Hydrocarbons Pyrolysis. Part One: Steam Cracking
,
1992
.
[2]
R. Fournet,et al.
Influence of surface on chemical kinetic of pyrocarbon deposition obtained by propane pyrolysis
,
2005
.
[3]
P. Marquaire,et al.
Detailed Kinetic Study of the Partial Oxidation of Methane over La2O3 Catalyst. Part 1: Experimental Results
,
2007
.
[4]
F. Battin‐Leclerc,et al.
Thermal decomposition of n-dodecane: Experiments and kinetic modeling
,
2007
.
[5]
Marc Bouchez,et al.
CONTRIBUTION TO SCRAMJET ACTIVE COOLING ANALYSIS USING N-DODECANE DECOMPOSITION MODEL AS A GENERIC ENDOTHERMIC FUEL
,
2003
.