Densification mechanism and microstructural evolution in selective laser sintering of Al-12Si powders

Abstract The role of processing parameters on the densification mechanism and microstructural evolution in laser sintered Al–12Si powder has been explored. It was established that both the densification mechanism and microstructural evolution in laser sintered Al–12Si powder were controlled by the specific laser energy input. Analysis of the cross-section of laser sintered microstructures of Al–12Si powders indicated that the tops of the grains in the previous layer are partially re-melted and then undergo epitaxial growth in the next layer where the heat affected zones (HAZ) grain boundaries and solidification grain boundaries (SGBs) are continuous along the fusion boundary.

[1]  M. Loretto,et al.  The influence of thermal processing route on the microstructure of some TiAl-based alloys , 1999 .

[2]  D. StJohn,et al.  Dendrite coherency of Al-Si-Cu alloys , 2001 .

[3]  T. Sercombe,et al.  On the role of magnesium and nitrogen in the infiltration of aluminium by aluminium for rapid prototyping applications , 2004 .

[4]  Sanjay Kumar,et al.  An experimental design approach to selective laser sintering of low carbon steel , 2003 .

[5]  Abdolreza Simchi,et al.  Effects of laser sintering processing parameters on the microstructure and densification of iron powder , 2003 .

[6]  I. Chang,et al.  Liquid phase sintering of M3/2 high speed steel by selective laser sintering , 1998 .

[7]  L. Arnberg,et al.  Determination of dendritic coherency in solidifying melts by rheological measurements , 1993 .

[8]  Direct selective laser sintering of aluminium alloy powders , 2008 .

[9]  M. H. Loretto,et al.  The effect of process parameters and heat treatment on the microstructure of direct laser fabricated TiAl alloy samples , 2001 .

[10]  Mustafa Gündüz,et al.  Directional solidification of aluminium -copper alloys , 2002 .

[11]  S. Das.  Physical Aspects of Process Control in Selective Laser Sintering of Metals , 2003 .

[12]  I. Chang,et al.  Selective laser sintering of gas atomized M2 high speed steel powder , 2000 .

[13]  Christopher J. Sutcliffe,et al.  Effect of direct laser re-melting processing parameters and scanning strategies on the densification of tool steels , 2005 .

[14]  Yifu Shen,et al.  Balling phenomena in direct laser sintering of stainless steel powder: Metallurgical mechanisms and control methods , 2009 .

[15]  J. Lippold,et al.  Nature and evolution of the fusion boundary in ferritic-austenitic dissimilar weld metals : Part 1 - Nucleation and growth , 1999 .

[16]  C. S. Wright,et al.  Processing conditions and mechanical properties of high-speed steel parts fabricated using direct selective laser sintering , 2003 .