A 3D edge detection technique for surface extraction in computed tomography for dimensional metrology applications

Abstract Many factors influence the measurement uncertainty when using computed tomography for dimensional metrology applications. One of the most critical steps is the surface extraction phase. An incorrect determination of the surface may significantly increase the measurement uncertainty. This paper presents an edge detection method for the surface extraction based on a 3D Canny algorithm with sub-voxel resolution. The advantages of this method are shown in comparison with the most commonly used technique nowadays, i.e. the local threshold definition. Both methods are applied to reference standards and industrial parts and the comparison of the uncertainties obtained by both methods is presented.

[1]  Frank Welkenhuyzen,et al.  A test object with parallel grooves for calibration and accuracy assessment of industrial computed tomography (CT) metrology , 2011 .

[2]  Enrico Savio,et al.  Metrological performance of optical coordinate measuring machines under industrial conditions , 2010 .

[3]  Y. J. Zhang.  Quantitative study of 3D gradient operators , 1993, Image Vis. Comput..

[4]  S. Carmignato,et al.  Accuracy of industrial computed tomography measurements: Experimental results from an international comparison , 2012 .

[5]  Robert Schmitt,et al.  Computed tomography for dimensional metrology , 2011 .

[6]  Jochen Hiller,et al.  Artefaktkorrekturen beim dimensionellen Messen mit industrieller Röntgen-ComputertomographieArtefact Correction at Coordinate Measuring with Industrial X-Ray Computed Tomography , 2009 .

[7]  José A. Yagüe-Fabra,et al.  Fundamental correction strategies for accuracy improvement of dimensional measurements obtained from a conventional micro-CT cone beam machine , 2013 .

[8]  Yutaka Ohtake,et al.  Segmentation of multi-material CT data of mechanical parts for extracting boundary surfaces , 2010, Comput. Aided Des..

[9]  Hans Nørgaard Hansen,et al.  Dimensional measurement of micro-moulded parts by computed tomography , 2012 .

[10]  Beat Schmutz,et al.  Effects of CT image segmentation methods on the accuracy of long bone 3D reconstructions. , 2011, Medical engineering & physics.

[11]  Linda G. Shapiro,et al.  Computer Vision , 2001 .

[12]  Michael A Fiddy,et al.  Combined image-processing algorithms for improved optical coherence tomography of prostate nerves. , 2010, Journal of biomedical optics.