Strengthening mechanism in fatigue of maraging steel at elevated temperature

In order to investigate fatigue properties of 18%Ni maraging steel at elevated temperature, rotating bending fatigue tests were conducted for plain and drilled specimens at room temperature (RT) and 673K in air. The specimens involved single-aged ones under an under-aging condition at 753K and double-aged ones in which the second aging was performed at 673K to the single-aged ones. Fatigue strength of the single-aged plain specimens was higher at 673K than at RT, though the static strength was inversely decreased at the elevated temperature. On the other hand, the single-aged drilled specimens exhibited nearly the same fatigue strength at both temperatures. It was found that hardness measured at RT increased with time in the single-aged plain specimens fatigued at 673K, which also appeared in the static aging at 673K. This hardness increase was considered to be attributed to precipitation hardening which might occur due to the existence of excess Mo solute atoms. On the other hand, crack observations revealed that crack initiation in the plain specimens was retarded markedly at 673K in comparison with that at RT, whereas crack propagation rate did not differ significantly between these temperatures and between the plain and drilled specimens. The marked delay of crack initiation in the plain specimens at 673K arose from the oxidation of their surfaces. It was also observed that the double-aging led to a large increase in fatigue strength at RT, but resulted in a slight increase at 673K. Based on these results, it was shown that the main reason of the increase in fatigue strength at 673K in the plain specimens was the suppression of crack initiation due to oxidation, while the increase in hardness observed at this temperature played a minor role.

[1]  Qiang Chen,et al.  Aging condition for improvement of fatigue properties of maraging steel , 2013 .

[2]  J. R. Low,et al.  The effect of microstructure and strength on the fracture toughness of an 18 ni, 300 grade maraging steel , 2013 .

[3]  N. Yan,et al.  Fatigue Strength of Maraging Steel at Elevated Temperatures , 2008 .

[4]  J. Vřešťál,et al.  Phase diagram calculations in the Co–Mo and Fe–Mo systems using first-principles results for the sigma phase , 2005 .

[5]  J. Christian,et al.  The theory of transformations in metals and alloys , 2003 .

[6]  H. Nisitani,et al.  Influence of Reversion Austenite on Notch Sensitivity of Maraging Steel , 2002 .

[7]  N. Kawagoishi,et al.  Influence of Aging Condition and Reversion Austenite on Fatigue Property of the 300 Grade 18Ni Maraging Steel. , 2000 .

[8]  S. Mazumder,et al.  Precipitation in 18 wt% Ni maraging steel of grade 350 , 2000 .

[9]  W. Karliński,et al.  Fatigue strength of nitrided 18Ni250 and 18Ni300 grade maraging steels , 1999 .

[10]  Y. Katayama,et al.  Microstructural evolution in a 17-4 PH stainless steel after aging at 400 °C , 1999 .

[11]  K. Kanazawa,et al.  Fatigue fracture of low alloy steel at ultrahighcycle region under elevated temperature condition. , 1997 .

[12]  U. Viswanathan,et al.  Precipitation hardening in 350 grade maraging steel , 1993, Metallurgical and Materials Transactions A.

[13]  C. M. Wayman,et al.  Precipitation reactions and strengthening behavior in 18 Wt Pct nickel maraging steels , 1990 .

[14]  J. Lopitaux,et al.  Caracterisation des premieres etapes de l'oxydation de l'alliage inconel 718 par spectrometrie I.R.F.T. , 1990 .

[15]  敬宜 村上,et al.  Effects of Small Defects and Inclusions on Fatigue Strength of Maraging Steel , 1987 .

[16]  N. Maruyama,et al.  A Fatigue Fracture Surface-analysis Map of the 18Ni Maraging Steel , 1982 .

[17]  R. Decker,et al.  Developments and projected trends in maraging steels , 1967 .

[18]  N. Kawagoishi,et al.  Effects of Aging Condition and Humidity on Fatigue Properties of Maraging Steel , 2012 .

[19]  M. Goto,et al.  Fatigue strength of age-hardened & extruded al alloy under high humidity (rotating bending and ultrasonic loading) , 2010 .

[20]  N. Kawagoishi,et al.  Effect of Humidity on Fatigue Strength of Maraging Steel with Different Hardness , 2009 .

[21]  N. Kawagoishi,et al.  Effect of Humidity on Fatigue Strength of Maraging Steel , 2005 .

[22]  N. Kawagoishi,et al.  Improvement of fatigue strength of maraging steel by nitriding , 2001 .

[23]  Haftirman,et al.  Fatigue Strength of Aluminum Alloys in High-Humidity Environment. , 1996 .

[24]  Haftirman,et al.  Fatigue Strength of Structural Steels in High Humidity Environment. , 1995 .

[25]  H. Nisitani,et al.  Small crack growth law at elevated temperatures in the rotating bending tests of carbon steel. , 1987 .

[26]  A. Nozue,et al.  Lath Martensite Boundary Cracking in the Vicinity of ΔK th for 18%Ni Maraging Steel , 1986 .

[27]  T. Sakai,et al.  Effect of Aging Treatment on the Fatigue Crack Propagation of 18% Ni Maraging Steel , 1978 .

[28]  M. Garwood Interpretation of tests and correlation with service , 1951 .