Rapid thermal annealing of polysilicon thin films

In comparison with conventional heat treatment, high-temperature rapid thermal annealing (RTA) in a radio frequency (RF) induction-heated system can reduce or eliminate residual stresses in thin films in a few seconds. In this work, changes in the stress level due to the RTA of polycrystalline silicon thin films were studied as a function of annealing time and temperature. The corresponding variations in the microstructure and surface layer of the thin films were experimentally investigated by a variety of analytical tools. The results suggest that the residual stress evolution during annealing is dominated by two mechanisms: 1) microstructure variations of the polysilicon thin film and 2) effects of a surface layer formed during the heat treatment. The fact that the microstructure changes are more pronounced in samples after conventional heat treatment implies that the effects of the formed surface layer may dominate the final state of the residual stress in the thin film.

[1]  R. Dutton,et al.  Kinetics of thermal nitridation processes in the study of dopant diffusion mechanisms in silicon , 1985 .

[2]  S. Hijiya,et al.  Very Thin Silicon Nitride Films Grown by Direct Thermal Reaction with Nitrogen , 1978 .

[3]  R. Howe,et al.  Lpcvd Polycrystalline Silicon Thin Films: The Evolution of Structure, Texture and Stress , 1990 .

[4]  Huajian Gao,et al.  Some general properties of stress-driven surface evolution in a heteroepitaxial thin film structure , 1994 .

[5]  Roger T. Howe,et al.  In Situ Phosphorus-doped Polysilicon For Integrated Mems , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.

[6]  J. Maibach,et al.  Variations in Young's modulus and intrinsic stress of LPCVD-polysilicon due to high-temperature annealing , 1995 .

[7]  J. W. Evans,et al.  Kinetics of the Oxidation and Nitridation of Silicon at High Temperatures , 1958 .

[8]  William D. Nix,et al.  Stresses and deformation processes in thin films on substrates , 1988 .

[9]  William D. Nix,et al.  Mechanical properties of thin films , 1989 .

[10]  Xin Zhang,et al.  Residual-stress relaxation in polysilicon thin films by high-temperature rapid thermal annealing , 1998 .

[11]  Tong-Yi Zhang,et al.  Measurements of residual stresses in thin films using micro-rotating-structures , 1998 .

[12]  H. G. Hughes,et al.  Properties of polysilicon films annealed by a rapid thermal annealing process , 1992 .

[13]  Augustin Martinez,et al.  Stress evolution and point defect generation during oxidation of silicon , 1984 .

[14]  Pasqualina M. Sarro,et al.  The development of a low-stress polysilicon process compatible with standard device processing , 1996 .

[15]  B. Leroy.  Stresses and silicon interstitials during the oxidation of a silicon substrate , 1987 .

[16]  E. Lüder,et al.  Polycrystalline silicon-based sensors , 1986 .

[17]  D. W. Burns,et al.  Fine-grained polysilicon films with built-in tensile strain , 1988 .

[18]  R. Dutton,et al.  Effect of thermal nitridation processes on boron and phosphorus diffusion in 〈100〉 silicon , 1983 .

[19]  R.S. Muller,et al.  As-deposited low-strain LPCVD polysilicon , 1988, IEEE Technical Digest on Solid-State Sensor and Actuator Workshop.

[20]  William C. Tang,et al.  Electrostatic-comb drive of lateral polysilicon resonators , 1990 .

[21]  Yu-Chong Tai,et al.  Integrated movable micromechanical structures for sensors and actuators , 1988 .

[22]  The effects of post-process techniques and sacrificial layer materials on the formation of free standing polysilicon microstructures , 1989, IEEE Micro Electro Mechanical Systems, , Proceedings, 'An Investigation of Micro Structures, Sensors, Actuators, Machines and Robots'.

[23]  R. Howe,et al.  Stress and Microstructure in Lpcvd Polycrystalline Silicon Films: Experimental Results and Closed Form Modeling of Stresses , 1991 .

[24]  R. Howe,et al.  Polycrystalline Silicon Micromechanical Beams , 1983 .

[25]  G. Borionetti,et al.  The Behavior of Polysilicon Thin Film Stress and Structure Under Rapid Thermal Processing Conditions , 1988 .

[26]  Roger T. Howe,et al.  Process Integration for active polysilicon resonant microstructures , 1989 .