Control design considerations for voltage regulator modules

Fast response to load current switching is the most important requirement for voltage regulator modules (VRM). This paper addresses several aspects of VRM control design in order to meet this requirement. A comparison between voltage-mode control and peak-current control is presented first to highlight the advantages of voltage-mode control in terms of transient response to load variations. A simple mathematical model is then presented to facilitate sequential design of the power stage and the controller. The concept of critical inductance is examined and the proposed model is shown to provide a more reliable basis for the inductor design. The analyses are supported by numerical simulation as well as experimental results from a 100 W, 3.3 V-output half-bridge converters.

[1]  R. M. Bass,et al.  Simultaneous design of power stage and controller for switching power supplies , 1997 .

[2]  Abraham Pressman,et al.  Switching Power Supply Design , 1997 .

[3]  R. Redl,et al.  Optimizing the load transient response of the buck converter , 1998, APEC '98 Thirteenth Annual Applied Power Electronics Conference and Exposition.

[4]  Tadahiro Kuroda,et al.  Variable supply-voltage scheme for low-power high-speed CMOS digital design , 1998, IEEE J. Solid State Circuits.

[5]  Thomas D. Burd,et al.  Design issues for Dynamic Voltage Scaling , 2000, ISLPED'00: Proceedings of the 2000 International Symposium on Low Power Electronics and Design (Cat. No.00TH8514).

[6]  W. Huang.  A new control for multi-phase buck converter with fast transient response , 2001, APEC 2001. Sixteenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.01CH37181).

[7]  Peng Xu,et al.  Critical inductance in voltage regulator modules , 2002 .

[8]  Jian Sun,et al.  Ultra compact DC-DC converters for the digital age , 2002, IEEE 2002 28th Annual Conference of the Industrial Electronics Society. IECON 02.

[9]  Jian Sun,et al.  An improved current-doubler rectifier with integrated magnetics , 2002, APEC. Seventeenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.02CH37335).

[10]  S. A. Chickamenahalli,et al.  Effect of target impedance and control loop design on VRM stability , 2002, APEC. Seventeenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.02CH37335).

[11]  Seth R. Sanders,et al.  Architecture and IC implementation of a digital VRM controller , 2003 .

[12]  P.T. Krein,et al.  Design and control of sensorless current mode DC-DC converters , 2003, Eighteenth Annual IEEE Applied Power Electronics Conference and Exposition, 2003. APEC '03..

[13]  F.C. Lee,et al.  A novel control method for multiphase voltage regulators , 2003, Eighteenth Annual IEEE Applied Power Electronics Conference and Exposition, 2003. APEC '03..