Identification of damping in a bridge using a moving instrumented vehicle

Abstract In recent years, there has been a significant increase in the number of bridges which are being instrumented and monitored on an ongoing basis. This is in part due to the introduction of bridge management systems designed to provide a high level of protection to the public and early warning if the bridge becomes unsafe. This paper investigates a novel alternative; a low-cost method consisting of the use of a vehicle fitted with accelerometers on its axles to monitor the dynamic behaviour of bridges. A simplified half-car vehicle-bridge interaction model is used in theoretical simulations to test the effectiveness of the approach in identifying the damping ratio of the bridge. The method is tested for a range of bridge spans and vehicle velocities using theoretical simulations and the influences of road roughness, initial vibratory condition of the vehicle, signal noise, modelling errors and frequency matching on the accuracy of the results are investigated.

[1]  Arturo González,et al.  Detection of Bridge Dynamic Parameters Using an Instrumented Vehicle , 2010 .

[2]  Eugene J. O'Brien,et al.  Theoretical investigation of the use of a moving vehicle to identify bridge dynamic parameters , 2009 .

[3]  Charles R. Farrar,et al.  Damage identification and health monitoring of structural and mechanical systems from changes in their vibration characteristics: A literature review , 1996 .

[4]  Chul-Woo Kim,et al.  Feasibility investigation for identifying bridge's fundamental frequencies from vehicle vibrations , 2010 .

[5]  A. P. Jeary,et al.  The description and measurement of nonlinear damping in structures , 1996 .

[6]  Filipe Magalhães,et al.  Damping Estimation Using Free Decays and Ambient Vibration Tests , 2010 .

[7]  Eugene J. O'Brien,et al.  Modelling the vehicle in vehicle—infrastructure dynamic interaction studies , 2010 .

[8]  K. C. Chang,et al.  Extraction of bridge frequencies from the dynamic response of a passing vehicle enhanced by the EMD technique , 2009 .

[9]  Chul-Woo Kim,et al.  Three-dimensional dynamic analysis for bridge-vehicle interaction with roadway roughness , 2005 .

[10]  O. S. Salawu Detection of structural damage through changes in frequency: a review , 1997 .

[11]  Keith Worden,et al.  An introduction to structural health monitoring , 2007, Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences.

[12]  Chul-Woo Kim,et al.  Pseudo-static approach for damage identification of bridges based on coupling vibration with a moving vehicle , 2008 .

[13]  Gouri Dhatt,et al.  An Efficient Algorithm for Dynamic Analysis of Bridges Under Moving Vehicles Using a Coupled Modal and Physical Components Approach , 1998 .

[14]  Arturo González,et al.  Vehicle-bridge dynamic interaction using finite element modelling , 2010 .

[15]  Claudio Modena,et al.  Damage Localization in Reinforced Concrete Structures by Using Damping Measurements , 1999 .

[16]  Yeong-Bin Yang,et al.  Use of a passing vehicle to scan the fundamental bridge frequencies: An experimental verification , 2005 .

[17]  William Weaver,et al.  Structural dynamics by finite elements , 1987 .

[18]  J. W. Tedesco,et al.  Structural Dynamics: Theory and Applications , 1998 .

[19]  Arturo González,et al.  Comparison of Bridge Dynamic Amplifications due to Articulated 5-Axle Trucks and Large Cranes , 2011 .

[20]  Arturo González,et al.  Determination of Bridge Natural Frequencies Using a Moving Vehicle Instrumented with Accelerometers and GPS , 2008 .

[21]  Eugene J. O'Brien,et al.  Reduction of bridge dynamic amplification through adjustment of vehicle suspension damping , 2007 .

[22]  Yeong-Bin Yang,et al.  EXTRACTING BRIDGE FREQUENCIES FROM THE DYNAMIC RESPONSE OF A PASSING VEHICLE , 2002 .

[23]  H. Wenzel,et al.  Sensitivity Studies on Damping Estimation , 2022 .

[24]  David P. Thambiratnam,et al.  Development of an analytical model for treating bridge-vehicle interaction , 1998 .

[25]  Edward L. Wilson,et al.  Numerical methods in finite element analysis , 1976 .

[26]  Cheng-Wu Chen,et al.  RETRACTED: Identification and monitoring of bridge health from ambient vibration data , 2011 .

[27]  Ruichong Zhang,et al.  Modal parameter identification of Tsing Ma suspension bridge under Typhoon Victor : EMD-HT method , 2004 .

[28]  L. G. Jaeger,et al.  Dynamics of structures , 1990 .

[29]  Yi-Qing Ni,et al.  A new approach to identification of structural damping ratios , 2007 .

[30]  David Cebon,et al.  Handbook of vehicle-road interaction , 1999 .

[31]  Ki-Tae Park,et al.  The determination of bridge displacement using measured acceleration , 2005 .

[32]  John E. Mottershead,et al.  Finite Element Model Updating in Structural Dynamics , 1995 .

[33]  Yoshinobu Oshima,et al.  Eigenfrequency estimation for bridges using the response of a passing vehicle with excitation system , 2008 .

[34]  Hoon Sohn,et al.  A review of structural health monitoring literature 1996-2001 , 2002 .

[35]  Jorge Daniel Riera,et al.  Damage detection by means of structural damping identification , 2008 .

[36]  Andrew D. Dimarogonas,et al.  Vibration of cracked structures: A state of the art review , 1996 .

[37]  J M W Brownjohn,et al.  Structural health monitoring of civil infrastructure , 2007, Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences.

[38]  G. Kawiecki Modal damping measurement for damage detection , 2001 .

[39]  James G. MacGregor,et al.  Reinforced Concrete: Mechanics and Design , 1996 .

[40]  Alison B. Flatau,et al.  Review Paper: Health Monitoring of Civil Infrastructure , 2003 .

[41]  J. Doltsinis Structural dynamics , 1987 .

[42]  C. Williams,et al.  Damping as a damage indication parameter , 1997 .

[43]  E. Peter Carden,et al.  Vibration Based Condition Monitoring: A Review , 2004 .

[44]  Eugene J. O'Brien,et al.  Characterisation of pavement profile heights using accelerometer readings and a combinatorial optimisation technique , 2010 .

[45]  David P. Thambiratnam,et al.  Vibration based structural damage detection in flexural members using multi-criteria approach , 2009 .