Robustness and reliability of BiCMOS embedded RF-MEMS switch

Robustness and reliability of an embedded RF-MEMS switch are analyzed. Changes of key switch parameters, such as COFF, CON, and pull-in voltage, with the ambient temperature are investigated in the range of −30°C to 150°C. The biggest temperature effect, a decrease by a factor of 2 between −30°C and 150°C, is observed for COFF, while CON weakly increases by only about 6% in this temperature range. For the pull-in voltage, practically no T-effect is observed. The power handling performance is also analyzed. A DC self-actuation voltage of 20V was estimated. To hold the membrane in down position, an 1.2V DC voltage drop or 15dBm RF power was found to be necessary. Finally, a new reliability test was applied, using Laser-Doppler (LD) Vibrometry technique to analyze the change in the switch dynamic behavior after billion times of operation. The measurement results show that this behavior hardly changes for up to 50 billion times operation.

[1]  K. Schmalz,et al.  A 122 GHz receiver in SiGe technology , 2009, 2009 IEEE Bipolar/BiCMOS Circuits and Technology Meeting.

[2]  M. Kaynak,et al.  BEOL embedded RF-MEMS switch for mm-wave applications , 2009, 2009 IEEE International Electron Devices Meeting (IEDM).

[3]  D. Knoll,et al.  SiGe HBT module with 2.5 ps gate delay , 2008, 2008 IEEE International Electron Devices Meeting.

[4]  D. Knoll,et al.  High-performance BiCMOS technologies without epitaxially-buried subcollectors and deep trenches , 2006, 2006 International SiGe Technology and Device Meeting.

[5]  M. Kaynak,et al.  Characterization of an embedded RF-MEMS switch , 2010, 2010 Topical Meeting on Silicon Monolithic Integrated Circuits in RF Systems (SiRF).

[6]  V. Ermolov,et al.  Design of a temperature-stable RF MEM capacitor , 2004, Journal of Microelectromechanical Systems.

[7]  J.C.M. Hwang,et al.  Performance of molybdenum as a mechanical membrane for RF MEMS switches , 2009, 2009 IEEE MTT-S International Microwave Symposium Digest.