Optimal orientation with variable slicing in stereolithography
暂无分享,去创建一个
Han Tong Loh | Yoke San Wong | T. Miyazawa | Jerry Y. H. Fuh | F. Xu | Y. Wong | H. Loh | J. Fuh | T. Miyazawa | F. Xu
[1] Debasish Dutta,et al. An accurate slicing procedure for layered manufacturing , 1996, Comput. Aided Des..
[2] Tony C. Woo,et al. Dimensional measurement of surfaces and their sampling , 1993, Comput. Aided Des..
[3] Michael Ian Shamos,et al. Computational geometry: an introduction , 1985 .
[4] Georges Fadel,et al. Expert system-based selection of the preferred direction of build for rapid prototyping processes , 1995, J. Intell. Manuf..
[5] Andrew Y. C. Nee,et al. Multi‐objective optimization of part‐ building orientation in stereolithography , 1995 .
[6] Jean-Pierre Kruth,et al. Material incress manufacturing by rapid prototyping techniques , 1991 .
[7] Paul F. Jacobs,et al. Stereolithography and Other Rp&m Technologies: From Rapid Prototyping to Rapid Tooling , 1995 .
[8] Paul F. Jacobs,et al. Rapid Prototyping & Manufacturing: Fundamentals of Stereolithography , 1992 .
[9] B. J. Davies,et al. Surface Engineering Geometry for Computer Aided Design and Manufacture , 1987 .
[10] Ron Jamieson,et al. Direct slicing of CAD models for rapid prototyping , 1995 .
[11] Ketan Mulmuley,et al. Computational geometry : an introduction through randomized algorithms , 1993 .
[12] Seth Allen,et al. On the Computation Of Part Orientation Using Support Structures in Layered Manufacturing , 1994 .
[13] André Dolenc,et al. Slicing procedures for layered manufacturing techniques , 1994, Comput. Aided Des..