Synergistically Enhanced Thermoelectric and Mechanical Performance of Bi2te3 Via Industrial Scalable Hot Extrusion Method for Cooling and Power Generation Applications

[1]  Qian Zhang,et al.  Design of N‐Type Textured Bi2Te3 with Robust Mechanical Properties for Thermoelectric Micro‐Refrigeration Application , 2022, Advanced science.

[2]  Xin Qian,et al.  Simultaneous enhancement in electrical conductivity and Seebeck coefficient by single- to double-valley transition in a Dirac-like band , 2022, npj Computational Materials.

[3]  R. Ang,et al.  Comprehensive Insight into p-Type Bi2Te3-Based Thermoelectrics near Room Temperature. , 2022, ACS applied materials & interfaces.

[4]  Hao Liang,et al.  Tunable Electrical Conductivity and Simultaneously Enhanced Thermoelectric and Mechanical Properties in n‐type Bi2Te3 , 2022, Advancement of science.

[5]  K. Nielsch,et al.  Micro-thermoelectric devices , 2022, Nature Electronics.

[6]  Fusheng Liu,et al.  Antisite defect manipulation enables the high thermoelectric performance of p-type Bi2-Sb Te3 alloys for solid-state refrigeration , 2022, Materials Today Physics.

[7]  Jianbo Zhu,et al.  Mediating Point Defects Endows n-Type Bi2 Te3 with High Thermoelectric Performance and Superior Mechanical Robustness for Power Generation Application. , 2022, Small.

[8]  Huaizhou Zhao,et al.  Highly efficient thermoelectric air conditioner with kilowatt capacity realized by ground source heat-exchanging system , 2022, iScience.

[9]  Qian Zhang,et al.  Nanotwins Strengthening High Thermoelectric Performance Bismuth Antimony Telluride Alloys , 2022, Advanced science.

[10]  Zihang Liu,et al.  Maximizing the performance of n-type Mg3Bi2 based materials for room-temperature power generation and thermoelectric cooling , 2022, Nature communications.

[11]  Yonggao Y. Yan,et al.  Large-scale SHS based 3D printing of high-performance n-type BiTeSe: comprehensive development from materials to modules , 2022, Materials Today Physics.

[12]  S. Song,et al.  Synergistic Optimization of the Thermoelectric and Mechanical Properties of Large-Size Homogeneous Bi0.5Sb1.5Te3 Bulk Samples via Carrier Engineering for Efficient Energy Harvesting. , 2022, ACS applied materials & interfaces.

[13]  Yubo Luo,et al.  Cold-Sintered Bi2Te3-Based Materials for Engineering Nanograined Thermoelectrics , 2022, ACS Applied Energy Materials.

[14]  Xin-yu Chen,et al.  Broadening temperature plateau of high zTs in PbTe doped Bi0.3Sb1.7Te3 through defect carrier regulation and multi-scale phonon scattering , 2022, Materials Today Physics.

[15]  K. Nielsch,et al.  A robust thermoelectric module based on MgAgSb/Mg 3 (Sb,Bi) 2 with a conversion efficiency of 8.5% and a maximum cooling of 72 K † , 2022 .

[16]  Zhengshang Wang,et al.  Direct ink writing of high-performance Bi2Te3-based thermoelectric materials by quasi-inorganic inks and interface engineering , 2022, Journal of Materials Chemistry A.

[17]  F. Guo,et al.  BiSbTe alloy with high thermoelectric and mechanical performance for power generation , 2022, Scripta Materialia.

[18]  Jiaqing He,et al.  The Roles of Grain Boundaries in Thermoelectric Transports , 2022, Materials Lab.

[19]  Hai Hu,et al.  High ZT in p-Type Thermoelectric (Bi,Sb)2Te3 with Built-in Nanopores , 2022, Energy & Environmental Science.

[20]  G. J. Snyder,et al.  Durable, stretchable and washable inorganic-based woven thermoelectric textiles for power generation and solid-state cooling , 2022, Energy & Environmental Science.

[21]  Huaizhou Zhao,et al.  Next-generation thermoelectric cooling modules based on high-performance Mg3(Bi,Sb)2 material , 2021, Joule.

[22]  Lidong Chen,et al.  Optimized Thermoelectric Properties of Bi0.48Sb1.52Te3 through AgCuTe Doping for Low-Grade Heat Harvesting. , 2021, ACS applied materials & interfaces.

[23]  B. Ge,et al.  Enhancing the Room Temperature Thermoelectric Performance of n-Type Bismuth-Telluride-Based Polycrystalline Materials by Low-Angle Grain Boundaries , 2021, Materials Today Physics.

[24]  Hao Liang,et al.  Highly Enhanced Thermoelectric and Mechanical Properties of Bi-Sb-Te Compounds by Carrier Modulation and Microstructure Adjustment. , 2021, ACS applied materials & interfaces.

[25]  M. Wuttig,et al.  Boron-Mediated Grain Boundary Engineering Enables Simultaneous Improvement of Thermoelectric and Mechanical Properties in N-Type Bi2 Te3. , 2021, Small.

[26]  Jeong Soo Lee,et al.  Superior thermoelectric cooling performance by suppressing bipolar diffusion effect and enhancing anisotropic texture in p-/n-type Bi2Te3 based compounds , 2021 .

[27]  Jiaqing He,et al.  Point Defect Engineering: Co-Doping Synergy Realizing Superior Performance in n-Type Bi2 Te3 Thermoelectric Materials. , 2021, Small.

[28]  M. Maksymuk,et al.  Development of a solid-state multi-stage thermoelectric cooler , 2021 .

[29]  Wentao Hu,et al.  Porous bismuth antimony telluride alloys with excellent thermoelectric and mechanical properties , 2021 .

[30]  G. J. Snyder,et al.  Thermoelectric Performance Enhancement in BiSbTe Alloy by Microstructure Modulation via Cyclic Spark Plasma Sintering with Liquid Phase , 2021, Advanced Functional Materials.

[31]  G. J. Snyder,et al.  Significant Enhancement of Thermoelectric Figure of Merit in BiSbTe‐Based Composites by Incorporating Carbon Microfiber , 2021, Advanced Functional Materials.

[32]  Kyu Hyoung Lee,et al.  Isovalent sulfur substitution to induce a simultaneous increase in the effective mass and weighted mobility of a p-type Bi-Sb-Te alloy: an approach to enhance the thermoelectric performance over a wide temperature range , 2020 .

[33]  S. Morito,et al.  Effect of the crystal alignment and grain size on the thermoelectric properties of Bi0.4Sb1.6Te3 sintered materials , 2020 .

[34]  Y. Qiu,et al.  Realizing record high performance in n-type Bi2Te3-based thermoelectric materials , 2020 .

[35]  Zhenhua Ge,et al.  Achieving a fine balance in mechanical properties and thermoelectric performance in commercial Bi2Te3 materials , 2020 .

[36]  Heping Xie,et al.  n-Bi2-xSbxTe3: A Promising Alternative to Mainstream Thermoelectric Material n-Bi2Te3-xSex near Room Temperature. , 2020, ACS applied materials & interfaces.

[37]  W. Goddard,et al.  Synergetic Evolution of Sacrificial Bonds and Strain-Induced Defects Facilitating Large Deformation of the Bi2Te3 Semiconductor , 2020 .

[38]  Qingjie Zhang,et al.  Magnetism-induced huge enhancement of the room-temperature thermoelectric and cooling performance of p-type BiSbTe alloys , 2020 .

[39]  Q. Yan,et al.  Thermal Stability and Mechanical Response of Bi2Te3-Based Materials for Thermoelectric Applications , 2020, ACS Applied Energy Materials.

[40]  M. Kanatzidis,et al.  3D Printing of highly textured bulk thermoelectric materials: mechanically robust BiSbTe alloys with superior performance , 2019, Energy & Environmental Science.

[41]  Haijun Wu,et al.  High thermoelectric performance in low-cost SnS0.91Se0.09 crystals , 2019, Science.

[42]  Xinbing Zhao,et al.  Liquid‐Phase Hot Deformation to Enhance Thermoelectric Performance of n‐type Bismuth‐Telluride‐Based Solid Solutions , 2019, Advanced science.

[43]  Gang Chen,et al.  High thermoelectric cooling performance of n-type Mg3Bi2-based materials , 2019, Science.

[44]  Lidong Chen,et al.  Enhanced Thermoelectric Performance in n-Type Bi2Te3-Based Alloys via Suppressing Intrinsic Excitation. , 2018, ACS applied materials & interfaces.

[45]  Byungkyu Kim,et al.  Impurity-free, mechanical doping for the reproducible fabrication of the reliable n-type Bi2Te3-based thermoelectric alloys , 2018 .

[46]  K. Ng,et al.  Crystallographically Textured Nanomaterials Produced from the Liquid Phase Sintering of Bi xSb2- xTe3 Nanocrystal Building Blocks. , 2018, Nano letters.

[47]  Xianli Su,et al.  High thermoelectric performance of p-BiSbTe compounds prepared by ultra-fast thermally induced reaction , 2017 .

[48]  M. Wuttig,et al.  Simultaneous optimization of electrical and thermal transport properties of Bi0.5Sb1.5Te3 thermoelectric alloy by twin boundary engineering , 2017 .

[49]  Xinbing Zhao,et al.  The effect of texture degree on the anisotropic thermoelectric properties of (Bi,Sb)2(Te,Se)3 based solid solutions , 2016 .

[50]  Ping Lu,et al.  High efficiency Bi2Te3-based materials and devices for thermoelectric power generation between 100 and 300 °C , 2016 .

[51]  Hyun Jae Kim,et al.  Free-electron creation at the 60° twin boundary in Bi2Te3 , 2016, Nature Communications.

[52]  B. Ryu,et al.  Enhanced thermoelectric properties and development of nanotwins in Na-doped Bi0.5Sb1.5Te3 alloy , 2016, Electronic Materials Letters.

[53]  G. Yoon,et al.  Direct Contact Resistance Evaluation of Thermoelectric Legs , 2016 .

[54]  G. J. Snyder,et al.  Dense dislocation arrays embedded in grain boundaries for high-performance bulk thermoelectrics , 2015, Science.

[55]  Kenneth McEnaney,et al.  High thermoelectric conversion efficiency of MgAgSb-based material with hot-pressed contacts , 2015 .

[56]  T. Liang,et al.  High thermoelectric performance of mechanically robust n-type Bi2Te3−xSex prepared by combustion synthesis , 2015 .

[57]  Xianli Su,et al.  Mechanically Robust BiSbTe Alloys with Superior Thermoelectric Performance: A Case Study of Stable Hierarchical Nanostructured Thermoelectric Materials , 2015 .

[58]  Soon-Mok Choi,et al.  Nanograined thermoelectric Bi2Te2.7Se0.3 with ultralow phonon transport prepared from chemically exfoliated nanoplatelets , 2013 .

[59]  Kenneth E. Goodson,et al.  Thermal Cycling, Mechanical Degradation, and the Effective Figure of Merit of a Thermoelectric Module , 2013, Journal of Electronic Materials.

[60]  Xinbing Zhao,et al.  Enhancement in thermoelectric performance of bismuth telluride based alloys by multi-scale microstructural effects , 2012 .

[61]  K. Paraskevopoulos,et al.  Efficiency Study of a Commercial Thermoelectric Power Generator (TEG) Under Thermal Cycling , 2010 .

[62]  R. Srinivasan,et al.  Improvement in thermoelectric properties of an n-type bismuth telluride (Bi2Se0.3Te2.7) due to texture development and grain refinement during hot deformation , 2010 .

[63]  Weishu Liu,et al.  Enhanced thermoelectric and mechanical properties in textured n-type Bi2Te3 prepared by spark plasma sintering , 2008 .

[64]  M. Dresselhaus,et al.  High-Thermoelectric Performance of Nanostructured Bismuth Antimony Telluride Bulk Alloys , 2008, Science.

[65]  K. Fukuda,et al.  Texture and thermoelectric properties of hot-extruded Bi2Te3 compound , 2000 .

[66]  D. Cortie,et al.  Enhanced thermoelectric performance and mechanical strength of n-type BiTeSe materials produced via a composite strategy , 2022 .