Effects of exhaust gas recirculation on diesel particulate matter morphology and NO x emissions

Abstract Diesel particulate morphology and nitrogen oxides (NO x ) emissions were investigated in detail to reveal the effects of exhaust gas recirculation (EGR). The different rates of EGR were precisely controlled by using a customized engine control unit in a 1.7 l turbocharged common-rail direct-injection diesel engine. The tests, which combined two different EGR modes (i.e. constant boost pressure (CBP) and constant oxygen-to-fuel ratio (COFR)), were designed to decouple the effects of EGR thermal and dilution processes. Particulate samples were collected directly from the raw engine exhaust by using a novel thermophoretic soot-sampling system. The samples were examined and imaged with a high-resolution transmission electron microscope and quantitatively analysed by using a customized image-processing/data-acquisition system. Results showed that the particulate dimensions, number density of primary particles, and soot yield all changed significantly under various EGR rates. The NO x emissions also varied significantly as the EGR rate changed, showing a typical trade-off with respect to the data measured for particulate emissions. At low EGR rates, the thermal effect was the dominant phenomenon that affected the changes of the measured morphological characters, while at higher EGR rates the dilution effect became more important. However, the fractal geometry of diesel particulates did not change significantly between the two EGR modes, suggesting that the influence of EGR dilution was less than that of the thermal process. EGR operation providing a COFR at the same EGR rate yielded a significant benefit in particulate emissions and engine power output, while still maintaining the reduction of NO x emissions at a satisfactory level.

[1]  Craig F. Habeger,et al.  An Investigation of Particulate Morphology, Microstructures, and Fractal Geometry for ael Diesel Engine-Simulating Combustor , 2004 .

[2]  Constantine M. Megaridis,et al.  Morphological Description of Flame-Generated Materials , 1990 .

[3]  R. Hurt,et al.  Equilibrium nanostructure of primary soot particles , 2000 .

[4]  R. Dobbins,et al.  Crystallogenesis of Particles Formed in Hydrocarbon Combustion , 2000 .

[5]  Michael Frenklach,et al.  Reaction mechanism of soot formation in flames , 2002 .

[6]  Hongsheng Guo,et al.  The chemical effects of carbon dioxide as an additive in an ethylene diffusion flame: implications for soot and NOx formation , 2001 .

[7]  Dale W. Schaefer,et al.  Fractal Models and the Structure of Materials , 1988 .

[8]  John M. E. Storey,et al.  Implications of Particulate and Precursor Compounds Formed During High-Efficiency Clean Combustion in a Diesel Engine , 2005 .

[9]  M. Choi,et al.  Effects of engine operating conditions on morphology, microstructure, and fractal geometry of light-duty diesel engine particulates , 2005 .

[10]  D'arcy W. Thompson.  On Growth and Form , 1945 .

[11]  Paul Meakin,et al.  Computer Simulation of Growth and Aggregation Processes , 1986 .

[12]  Mun Young Choi,et al.  MEASUREMENT OF FRACTAL PROPERTIES OF SOOT AGGLOMERATES IN LAMINAR COFLOW DIFFUSION FLAMES USING THERMOPHORETIC SAMPLING IN CONJUNCTION WITH TRANSMISSION ELECTRON MICROSCOPY AND IMAGE PROCESSING , 2001 .

[13]  Juhun Song,et al.  Impact of Biodiesel Blending on Diesel Soot and the Regeneration of Particulate Filters , 2005 .

[14]  Konstantinos Boulouchos,et al.  Influence of EGR on Combustion and Exhaust Emissions of Heavy Duty DI-Diesel Engines Equipped with Common-Rail Injection Systems , 2001 .

[15]  John M. E. Storey,et al.  Simultaneous Low Engine-Out NOx and Particulate Matter with Highly Diluted Diesel Combustion , 2003 .

[16]  José M. Desantes,et al.  Influence of the EGR Rate, Oxygen Concentration and Equivalent Fuel/Air Ratio on the Combustion Behaviour and Pollutant Emissions of a Heavy-Duty Diesel Engine , 2000 .

[17]  C. Law,et al.  The influence of carbon dioxide and oxygen as additives on soot formation in diffusion flames , 1991 .

[18]  Fouad Ammouri,et al.  Soot formation effects of oxygen concentration in the oxidizer stream of laminar coannular nonpremixed methane/air flames , 2000 .

[19]  Charles J. Mueller,et al.  Investigation of Fuel Effects on Dilute, Mixing-Controlled Combustion in an Optical Direct-Injection Diesel Engine , 2007 .

[20]  Raj Sekar,et al.  Morphological investigation of the microstructure, dimensions, and fractal geometry of diesel particulates , 2002 .

[21]  Dimitrios T. Hountalas,et al.  The Effect of EGR on the Performance and Pollutant Emissions of Heavy Duty Diesel Engines Using Constant and Variable AFR , 2001 .

[22]  Susan T. Bagley,et al.  A Study of the Effects of Exhaust Gas Recirculation on Heavy-Duty Diesel Engine Emissions , 1998 .

[23]  Hua Zhao,et al.  The Dilution, Chemical, and Thermal Effects of Exhaust Gas Recirculation on Diesel Engine Emissions - Part 1: Effect of Reducing Inlet Charge Oxygen , 1996 .

[24]  Stephen Ciatti,et al.  Sizes, graphitic structures and fractal geometry of light-duty diesel engine particulates , 2003 .

[25]  Hua Zhao,et al.  The Dilution, Chemical, and Thermal Effects of Exhaust Gas Recirculation on Diesel Engine Emissions - Part 3: Effects of Water Vapour , 1996 .

[26]  Rolf Egnell,et al.  The Influence of EGR on Heat Release Rate and NO Formation in a DI Diesel Engine , 2000 .

[27]  N Ladommatos,et al.  The dilution, chemical, and thermal effects of exhaust gas recirculation on diesel engine emissions-part 2: Effects of carbon dioxide , 1996 .

[28]  Timothy V. Johnson,et al.  Diesel emission control in review: The last 12 months , 2003 .