This article deals with the time interval measurement device, which is based on a surface acoustic wave (SAW) filter as a time interpolator. The operating principle is based on the fact that a transversal SAW filter excited by a short pulse can generate a finite signal with highly suppressed spectra outside a narrow frequency band. If the responses to two excitations are sampled at clock ticks, they can be precisely reconstructed from a finite number of samples and then compared so as to determine the time interval between the two excitations. We have designed and constructed a two-channel time interval measurement device which allows independent timing of two events and evaluation of the time interval between them. The device has been constructed using commercially available components. The experimental results proved the concept. We have assessed the single-shot time interval measurement precision of 1.3 ps rms that corresponds to the time of arrival precision of 0.9 ps rms in each channel. The temperature drift of the measured time interval on temperature is lower than 0.5 ps/K, and the long term stability is better than +/-0.2 ps/h. These are to our knowledge the best values reported for the time interval measurement device. The results are in good agreement with the error budget based on the theoretical analysis.
[1]
J. Kostamovaara,et al.
An integrated time-to-digital converter with 30-ps single-shot precision
,
2000,
IEEE Journal of Solid-State Circuits.
[2]
D. Porat,et al.
Review of Sub-Nanosecond Time-Interval Measurements
,
1973
.
[3]
Ivan Prochazka,et al.
Optical signal path delay fluctuations caused by atmospheric turbulence.
,
2005,
Optics letters.
[4]
Józef Kalisz,et al.
Review of methods for time interval measurements with picosecond resolution
,
2004
.
[5]
M. Mota,et al.
A high-resolution time interpolator based on a delay locked loop and an RC delay line
,
1999,
IEEE J. Solid State Circuits.