Process Simulation of Aluminium Sheet Metal Deep Drawing at Elevated Temperatures

Lightweight design is essential for an economic and environmentally friendly vehicle. Aluminium sheet metal is well known for its ability to improve the strength to weight ratio of lightweight structures. One disadvantage of aluminium is that it is less formable than steel. Therefore complex part geometries can only be realized by expensive multi-step production processes. One method for overcoming this disadvantage is deep drawing at elevated temperatures. In this way the formability of aluminium sheet metal can be improved significantly, and the number of necessary production steps can thereby be reduced. This paper introduces deep drawing of aluminium sheet metal at elevated temperatures, a corresponding simulation method, a characteristic process and its optimization. The temperature and strain rate dependent material properties of a 5xxx series alloy and their modelling are discussed. A three dimensional thermomechanically coupled finite element deep drawing simulation model and its validation are presented. Based on the validated simulation model an optimised process strategy regarding formability, time and cost is introduced.

[1]  Ken-ichiro Mori,et al.  Finite element simulation of warm deep drawing of aluminium alloy sheet when accounting for heat conduction , 2002 .

[2]  Luigi Tricarico,et al.  Numerical and experimental investigations on the Warm Deep Drawing process of circular aluminum alloy specimens , 2007 .

[3]  B. Zhang,et al.  Optimisation of the superplastic forming of aluminium alloys , 2006 .

[4]  R. Pearce,et al.  Warm forming of aluminium/magnesium alloy sheet☆ , 1978 .

[5]  M. L. Wenner,et al.  Strain and strain-rate hardening effects in punch stretching of 5182-0 aluminum at elevated temperatures , 1979 .

[6]  F. Pourboghrat,et al.  Forming of AA 5182-O and AA 5754-O at elevated temperatures using coupled thermo-mechanical finite element models , 2007 .

[7]  Raja K. Mishra,et al.  Simulations of Forming Limit Diagrams for the Aluminum Sheet Alloy 5754CC , 2010 .

[8]  Shi-Hong Zhang,et al.  Hydroforming Highlights: Sheet Hydroforming and Tube Hydroforming , 2004 .

[9]  P. Tebbe,et al.  Warm forming of aluminium alloys: an overview and future directions , 2004 .

[10]  David Lorenz,et al.  Recent Advances and New Developments in Hot Forming Simulation with LS-DYNA , 2008 .

[11]  Amit K. Ghosh,et al.  Biaxial warm forming behavior of aluminum sheet alloys , 2003 .

[12]  Arthur B. Shapiro.  Using LS-DYNA for Hot Forming , 2007 .

[13]  Fahrettin Ozturk,et al.  Review of warm forming of aluminum-magnesium alloys , 2008 .

[14]  Dong-Yol Yang,et al.  Mechanical properties and microstructure of AA1050 after ECAE (Equal Channel Angular Extrusion) , 2010 .

[15]  Han Huetink,et al.  A planar isotropic yield criterion based on mechanical testing at multi-axial stress states , 1995 .

[16]  John E. Carsley,et al.  Forming of AA5182-O and AA5754-O at elevated temperatures using coupled thermo-mechanical finite element models , 2007 .