Improvement of fuel economy of a direct-injection spark-ignition methanol engine under light loads

Abstract The effects of ignition system, compression ratio, and methanol injector configuration on the brake thermal efficiency (BTE) and combustion of a high-compression direct-injection spark-ignition methanol engine under light loads were investigated experimentally, and its BTE was compared with its diesel counterpart. The experimental results showed that these factors significantly affect the fuel economy under light load. The BTE of a methanol engine using a high-energy multi-spark-ignition system is on average 25% higher than that of one using a single-spark-ignition system at a brake mean effective pressures (BMEP) of 0.11–0.29 MPa and an engine speed of 1600 rpm. Decreasing the compression ratio of the methanol engine from 16:1 to 14:1 markedly increases the BTE under low loads and decreases the BTE at high loads. For the methanol engine, using an injector of a 10-hole × 0.30 mm nozzle decreases the ignition delay and improves the fuel economy compared to when an injector of a 7-hole × 0.45 mm nozzle is used. The combustion duration using an injector of a 7-hole × 0.45 mm nozzle is much longer than that with one of a 10-hole × 0.30 mm nozzle under light loads. As a result, the BTE for a methanol engine with optimal parameters is improved by 27% compared to that for a methanol engine without optimized parameters at a BMEP of 0.17 MPa and an engine speed of 1600 rpm, but the BTE of the optimized methanol engine is 20% lower than that of its diesel counterpart under these operating conditions.

[1]  G. W. Rogers,et al.  Influence of the methanol fuel composition on performance and exhaust emissions of diesel-derived alcohol engines , 1988 .

[2]  Moh'd Abu-Qudais,et al.  The effect of alcohol fumigation on diesel engine performance and emissions , 2000 .

[3]  M. Ściążko,et al.  Co-gasification of biomass and coal for methanol synthesis , 2003 .

[4]  T. Chan,et al.  Experimental investigation on regulated and unregulated emissions of a diesel/methanol compound combustion engine with and without diesel oxidation catalyst. , 2010, The Science of the total environment.

[5]  Ruizhi Song,et al.  Performance and Emissions of a Diesel Engine Fuelled with Methanol , 2008 .

[6]  I. Yamaguchi,et al.  Combustion Exhaust Emissions of the Spark-Assisted Methanol Diesel Engine , 1986 .

[7]  Bing Liu,et al.  Combustion behaviors of a compression-ignition engine fueled with diesel/methanol blends under various fuel delivery advance angles. , 2004, Bioresource technology.

[8]  Charles J. Mueller,et al.  Glow Plug Assisted Ignition and Combustion of Methanol in an Optical DI Diesel Engine , 2001 .

[9]  Effect of Preheating on Firing Behavior of a Spark-Ignition Methanol-Fueled Engine during Cold Start , 2009 .

[10]  Mustafa Canakci,et al.  The influence of operating parameters on the performance and emissions of a DI diesel engine using methanol-blended-diesel fuel , 2010 .

[11]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[12]  Naeim A. Henein,et al.  Combustion phenomena of alcohols in C.I. engines , 1989 .

[13]  Hakan Bayraktar,et al.  An experimental study on the performance parameters of an experimental CI engine fueled with diesel-methanol-dodecanol blends , 2008 .

[14]  J Q Zhang,et al.  Engine performance and emissions of a compression ignition engine operating on the diesel-methanol blends , 2004 .

[15]  S. A. Faulkner,et al.  Injection Timing and Rate Control - A Solution for Low Emissions , 1990 .

[16]  Zuo-hua Huang,et al.  Characterization of laminar premixed methanol-air flames , 2006 .

[17]  Zunqing Zheng,et al.  Study on the controlling strategies of homogeneous charge compression ignition combustion with fuel of dimethyl ether and methanol , 2006 .

[18]  Mustafa Canakci,et al.  Effect of Injection Pressure on the Combustion, Performance, and Emission Characteristics of a Diesel Engine Fueled with Methanol-blended Diesel Fuel , 2009 .

[19]  T. Chan,et al.  Comparison of emissions of a direct injection diesel engine operating on biodiesel with emulsified and fumigated methanol , 2008 .

[20]  M. Canakci,et al.  Exhaust Emissions and Combustion Characteristics of a Direct Injection (DI) Diesel Engine Fueled with Methanol−Diesel Fuel Blends at Different Injection Timings , 2008 .

[21]  Jun Li,et al.  Effect of injection and ignition timings on performance and emissions from a spark-ignition engine fueled with methanol , 2010 .

[22]  Mingfa Yao,et al.  Experimental and Numerical Study of Methanol/Dimethyl Ether Dual-Fuel Compound Combustion , 2009 .