Bioenergy, material, and nutrients recovery from household waste: Advanced material, substance, energy, and cost flow analysis of a waste refinery process

Energy, materials, and resource recovery from mixed household waste may contribute to reductions in fossil fuel and resource consumption. For this purpose, legislation has been enforced to promote energy recovery and recycling. Potential solutions for separating biogenic and recyclable materials are offered by waste refineries where a bioliquid is produced from enzymatic treatment of mixed waste. In this study, potential flows of materials, energy, and substances within a waste refinery were investigated by combining sampling, analyses, and modeling. Existing material, substance, and energy flow analysis was further advanced by development of a mathematical optimization model for determination of the theoretical recovery potential. The results highlighted that the waste refinery may recover ca. 56% of the dry matter input as bioliquid, yielding 6.2GJ biogas-energy. The potential for nitrogen, phosphorous, potassium, and biogenic carbon recovery was estimated to be between 81% and 89% of the input. Biogenic and fossil carbon in the mixed household waste input was determined to 63% and 37% of total carbon based on 14C analyses. Additional recovery of metals and plastic was possible based on further process optimization. A challenge for the process may be digestate quality, as digestate may represent an emission pathway when applied on land. Considering the potential variability of local revenues for energy outputs, the costs for the waste refinery solution appeared comparable with alternatives such as direct incineration.

[1]  Eva Thorin,et al.  Performance optimization of the Växtkraft biogas production plant , 2011 .

[2]  J la Cour Jansen,et al.  Need for improvements in physical pretreatment of source-separated household food waste. , 2013, Waste management.

[3]  M N Cruz Bournazou,et al.  Model based optimization of the intermittent aeration profile for SBRs under partial nitrification. , 2013, Water research.

[4]  Atsushi Terazono,et al.  Fate of metals contained in waste electrical and electronic equipment in a municipal waste treatment process. , 2012, Waste management.

[5]  B. Bilitewski,et al.  Mechanical Biological Treatment , 2010 .

[6]  H. Belevi,et al.  Factors Determining the Element Behavior in Municipal Solid Waste Incinerators. 1. Field Studies , 2000 .

[7]  J. Kiefer,et al.  Sequential minimax search for a maximum , 1953 .

[8]  T Astrup,et al.  Life-cycle assessment of a waste refinery process for enzymatic treatment of municipal solid waste. , 2012, Waste management.

[9]  Medardo Serna-González,et al.  Optimal planning for the sustainable utilization of municipal solid waste. , 2013, Waste management.

[10]  Jan Van Impe,et al.  Mathematical modelling of anaerobic digestion of biomass and waste: Power and limitations , 2013 .

[11]  Pragasen Pillay,et al.  Optimisation of biomass waste to energy conversion systems for rural grid-connected applications , 2013 .

[12]  Jacob Møller,et al.  Miljø- og samfundsøkonomisk vurdering af muligheder for øget genanvendelse af papir, pap, plast, metal og organisk affald fra dagrenovation , 2013 .

[13]  G. Ø. Rønsch,et al.  Enzymatic processing of municipal solid waste. , 2010, Waste management.

[14]  Utilization of Biologically Treated Organic Waste on Land , 2010 .

[15]  M. Mastellone,et al.  Scenarios of Waste Management for a Waste Emergency Area , 2009 .

[16]  Francesco Di Maria,et al.  Optimization of Solid State Anaerobic Digestion by inoculum recirculation: The case of an existing Mechanical Biological Treatment plant , 2012 .

[17]  C. Montejo,et al.  Analysis of the presence of improper materials in the composting process performed in ten MBT plants. , 2010, Bioresource technology.

[18]  Arthur Charpentier,et al.  the Dirichlet distribution , 2012 .

[19]  Christian Riber,et al.  Method for fractional solid-waste sampling and chemical analysis , 2007 .

[20]  Brian Vad Mathiesen,et al.  Energy system analysis of 100% renewable energy systems-The case of Denmark in years 2030 and 2050 , 2009 .

[21]  Jiří Jaromír Klemeš,et al.  Design and operation of efficient energy systems: Biorefineries, waste to energy, enhanced heat transfer and fuel cell applications , 2011 .

[22]  H. Wenzel,et al.  Bioenergy production from perennial energy crops: a consequential LCA of 12 bioenergy scenarios including land use changes. , 2012, Environmental science & technology.

[23]  Antoine P. Trzcinski,et al.  Determination of the hydrolysis constant in the biochemical methane potential test of municipal solid waste , 2012 .

[24]  A. Lagerkvist,et al.  Waste Characterization: Approaches and Methods , 2011 .

[25]  François Maréchal,et al.  Energy efficiency in waste water treatments plants: Optimization of activated sludge process coupled with anaerobic digestion , 2012 .

[26]  T. H. Christensen,et al.  Chemical composition of material fractions in Danish household waste. , 2009, Waste management.

[27]  B. Jaumard,et al.  Threshold herd size for commercial viability of biomass waste to energy conversion systems on rural farms , 2012 .

[28]  Sunwon Park,et al.  Optimization of a waste heat utilization network in an eco-industrial park , 2010 .

[29]  Helmut Rechberger,et al.  Material Flow Analysis with Software STAN , 2008, EnviroInfo.

[30]  A. Guwy,et al.  Defining the biomethane potential (BMP) of solid organic wastes and energy crops: a proposed protocol for batch assays. , 2009, Water science and technology : a journal of the International Association on Water Pollution Research.

[31]  Davide Tonini,et al.  LCA of biomass-based energy systems: A case study for Denmark , 2012 .

[32]  Veronica Martinez-Sanchez,et al.  Material resources, energy, and nutrient recovery from waste: are waste refineries the solution for the future? , 2013, Environmental science & technology.

[33]  Roland Pomberger,et al.  Current issues on the production and utilization of medium-calorific solid recovered fuel: a case study on SRF for the HOTDISC technology , 2012, Waste management & research : the journal of the International Solid Wastes and Public Cleansing Association, ISWA.

[34]  Giovanna Barigozzi,et al.  Wet and dry cooling systems optimization applied to a modern waste-to-energy cogeneration heat and power plant , 2011 .

[35]  S. Skutan,et al.  Analysis of total copper, cadmium and lead in refuse-derived fuels (RDF): study on analytical errors using synthetic samples , 2012, Waste management & research : the journal of the International Solid Wastes and Public Cleansing Association, ISWA.

[36]  Davide Tonini,et al.  Mechanical-biological treatment: performance and potentials. An LCA of 8 MBT plants including waste characterization. , 2013, Journal of environmental management.

[37]  Carlos Costa,et al.  Analysis and comparison of municipal solid waste and reject fraction as fuels for incineration plants , 2011 .

[38]  Jes la Cour Jansen,et al.  Anaerobic Digestion: Mass Balances and Products , 2010 .

[39]  Mikael Larsson,et al.  Optimisation of a centralised recycling system for steel plant by-products, a logistics perspective , 2013 .

[40]  Guangming Li,et al.  The integrated design and optimization of a WEEE collection network in Shanghai, China , 2013, Waste management & research : the journal of the International Solid Wastes and Public Cleansing Association, ISWA.

[41]  Thomas H. Christensen,et al.  Heavy metal content of combustible municipal solid waste in Denmark , 2005, Waste management & research : the journal of the International Solid Wastes and Public Cleansing Association, ISWA.

[42]  Paul H. Brunner,et al.  Substance Flow Analysis , 2012 .

[43]  M. Aroua,et al.  Optimization and modeling of extraction of solid coconut waste oil , 2013 .

[44]  Ni-Bin Chang,et al.  Solid waste management in European countries: a review of systems analysis techniques. , 2011, Journal of environmental management.

[45]  G. Ronning Maximum likelihood estimation of dirichlet distributions , 1989 .

[46]  Zaneta Stasiskiene,et al.  Application of material flow analysis to estimate the efficiency of e-waste management systems: the case of Lithuania , 2011, Waste management & research : the journal of the International Solid Wastes and Public Cleansing Association, ISWA.

[47]  Xiaohua Xia,et al.  Modeling and energy efficiency optimization of belt conveyors , 2011 .

[48]  Charlotte Scheutz,et al.  Mass balances and life-cycle inventory for a garden waste windrow composting plant (Aarhus, Denmark) , 2010, Waste management & research : the journal of the International Solid Wastes and Public Cleansing Association, ISWA.

[49]  Mahmoud M. El-Halwagi,et al.  Optimal integration of organic Rankine cycles with industrial processes , 2013 .