Self-Humidification of a Polymer Electrolyte Membrane Fuel Cell System With Cathodic Exhaust Gas Recirculation

[1]  Jianqiu Li,et al.  Modeling and analysis of internal water transfer behavior of PEM fuel cell of large surface area , 2017 .

[2]  Liangfei Xu,et al.  Faults diagnosis for PEM fuel cell system based on multi-sensor signals and principle component analysis method , 2017 .

[3]  Jianqiu Li,et al.  Experimental study on dual recirculation of polymer electrolyte membrane fuel cell , 2017 .

[4]  Liangfei Xu,et al.  Comparison of daily operation strategies for a fuel cell/battery tram , 2017 .

[5]  Jianqiu Li,et al.  Nonlinear observation of internal states of fuel cell cathode utilizing a high-order sliding-mode algorithm , 2017 .

[6]  Werner Lehnert,et al.  Robust control of internal states in a polymer electrolyte membrane fuel cell air-feed system by considering actuator properties , 2017 .

[7]  Liangfei Xu,et al.  Optimal warm-up control strategy of the PEMFC system on a city bus aimed at improving efficiency , 2017 .

[8]  Jianqiu Li,et al.  Sliding-mode-based temperature regulation of a proton exchange membrane fuel cell test bench , 2017 .

[9]  Werner Lehnert,et al.  Parameter extraction of polymer electrolyte membrane fuel cell based on quasi-dynamic model and periphery signals , 2017 .

[10]  Liangfei Xu,et al.  Optimization for a fuel cell/battery/capacity tram with equivalent consumption minimization strategy , 2017 .

[11]  Werner Lehnert,et al.  Parameter extraction and uncertainty analysis of a proton exchange membrane fuel cell system based on Monte Carlo simulation , 2017 .

[12]  Jianqiu Li,et al.  Comparison study on life-cycle costs of different trams powered by fuel cell systems and others , 2016 .

[13]  Jianqiu Li,et al.  Analytical calculation and evaluation of water transport through a proton exchange membrane fuel cell based on a one-dimensional model , 2016 .

[14]  Jianqiu Li,et al.  Fuel cell system degradation analysis of a Chinese plug-in hybrid fuel cell city bus , 2016 .

[15]  Jianqiu Li,et al.  Development of a PEM Fuel Cell City Bus with a Hierarchical Control System , 2016 .

[16]  Joachim Horn,et al.  Modeling, state estimation and nonlinear model predictive control of cathode exhaust gas mass flow for PEM fuel cells , 2016 .

[17]  Horng-Wen Wu.  A review of recent development: Transport and performance modeling of PEM fuel cells , 2016 .

[18]  Jianqiu Li,et al.  Modeling and simulation of parallel DC/DC converters for online AC impedance estimation of PEM fuel cell stack , 2016 .

[19]  Søren Knudsen Kær,et al.  Modeling and experimental validation of water mass balance in a PEM fuel cell stack , 2016 .

[20]  Jianqiu Li,et al.  Model-based fuel pressure regulation algorithm for a hydrogen-injected PEM fuel cell engine , 2015 .

[21]  Liangfei Xu,et al.  Energy flow modeling and real-time control design basing on mean values for maximizing driving mileage of a fuel cell bus , 2015 .

[22]  Jianqiu Li,et al.  Model-based estimation of liquid saturation in cathode gas diffusion layer and current density difference under proton exchange membrane fuel cell flooding , 2015 .

[23]  Jianqiu Li,et al.  Model-based temperature regulation of a PEM fuel cell system on a city bus , 2015 .

[24]  I. Eroglu,et al.  Development and modeling for process control purposes in PEMs , 2015 .

[25]  Koichi Kojima,et al.  Toyota MIRAI Fuel Cell Vehicle and Progress Toward a Future Hydrogen Society , 2015 .

[26]  Jianqiu Li,et al.  Air supply system model with exhaust gas recirculation for improving the life of fuel cell , 2014, 2014 IEEE Conference and Expo Transportation Electrification Asia-Pacific (ITEC Asia-Pacific).

[27]  Xu Liangfei,et al.  Water management in a self-humidifying PEM fuel cell system by exhaust gas recirculation , 2014, 2014 IEEE Conference and Expo Transportation Electrification Asia-Pacific (ITEC Asia-Pacific).

[28]  E. Afshari,et al.  Analysis of design parameters in anodic recirculation system based on ejector technology for PEM fuel cells: A new approach in designing , 2014 .

[29]  Alfredo Iranzo,et al.  Validation of a three dimensional PEM fuel cell CFD model using local liquid water distributions measured with neutron imaging , 2014 .

[30]  Jianqiu Li,et al.  Multi-mode control strategy for fuel cell electric vehicles regarding fuel economy and durability , 2014 .

[31]  Li Jianqi,et al.  Current status and trends of the research and development for fuel cell vehicles , 2014 .

[32]  Li Yin.  Numerical analysis of steady state self-humidification performance of PEMFC , 2014 .

[33]  Giorgio Rizzoni,et al.  Modeling the cathode pressure dynamics in the Buckeye Bullet II 540 kW hydrogen PEM fuel cell system , 2013 .

[34]  Chaoyang Wang,et al.  Validation of a two-phase multidimensional polymer electrolyte membrane fuel cell computational model using current distribution measurements , 2013 .

[35]  Jianqiu Li,et al.  Application of Pontryagin's Minimal Principle to the energy management strategy of plugin fuel cell electric vehicles , 2013 .

[36]  Li Chen,et al.  Multi-scale modeling of proton exchange membrane fuel cell by coupling finite volume method and lattice Boltzmann method , 2013 .

[37]  Jianqiu Li,et al.  Optimal sizing of plug-in fuel cell electric vehicles using models of vehicle performance and system cost , 2013 .

[38]  Jianqiu Li,et al.  Real time optimal energy management strategy targeting at minimizing daily operation cost for a plug-in fuel cell city bus , 2012 .

[39]  A. Morin,et al.  Impact of gas stoichiometry on water management and fuel cell performance of a sulfonated Poly(Ether Ether Ketone) membrane , 2012 .

[40]  Søren Knudsen Kær,et al.  Low stoichiometry operation of a proton exchange membrane fuel cell employing the interdigitated flow field – A modeling study , 2012 .

[41]  Marco Badami,et al.  Leakage effects on the performance characteristics of a regenerative blower for the hydrogen recirculation of a PEM fuel cell , 2012 .

[42]  Min-Soo Kim,et al.  Studies on the cathode humidification by exhaust gas recirculation for PEM fuel cell , 2012 .

[43]  B. Wetton,et al.  A simple, analytic model of polymer electrolyte membrane fuel cell anode recirculation at operating , 2011 .

[44]  Michael C. Georgiadis,et al.  Modeling, simulation and experimental validation of a PEM fuel cell system , 2011, Comput. Chem. Eng..

[45]  S. Kær,et al.  Water balance simulations of a polymer-electrolyte membrane fuel cell using a two-fluid model , 2011 .

[46]  W. Bessler,et al.  Multi-scale simulation of fuel cells: From the cell to the system , 2011 .

[47]  Masatoshi Uno,et al.  Reactant recirculation system utilizing pressure swing for proton exchange membrane fuel cell , 2011 .

[48]  Mehdi Soltani,et al.  Development of an empirical dynamic model for a Nexa PEM fuel cell power module , 2010 .

[49]  Huaneng Su,et al.  Self-humidification of a PEM fuel cell using a novel Pt/SiO2/C anode catalyst , 2010 .

[50]  Sung Il Kim,et al.  Humidification of Air Using Water Injector and Cyclonic Separator , 2010 .

[51]  Marco Badami,et al.  Theoretical model with experimental validation of a regenerative blower for hydrogen recirculation in a PEM fuel cell system , 2010 .

[52]  Alejandro A. Franco,et al.  Multi-scale Modeling-based Prediction of PEM Fuel Cells MEA Durability under Automotive Operating Conditions , 2009 .

[53]  Jun Shen,et al.  A review of PEM fuel cell durability: Degradation mechanisms and mitigation strategies , 2008 .

[54]  Luis A. M. Riascos,et al.  Relative humidity control in polymer electrolyte membrane fuel cells without extra humidification , 2008 .

[55]  Ilya Kolmanovsky,et al.  On the dynamics and control of through-plane water distributions in PEM fuel cells , 2008 .

[56]  C. Bordons,et al.  Development and experimental validation of a PEM fuel cell dynamic model , 2007 .

[57]  Min Soo Kim,et al.  Experimental study of gas humidification with injectors for automotive PEM fuel cell systems , 2007 .

[58]  M. Ouyang,et al.  Modeling and control of air stream and hydrogen flow with recirculation in a PEM fuel cell system - I. Control-oriented modeling , 2006 .

[59]  C. Du,et al.  Study on self-humidified PEMFC with reactant circulation , 2006 .

[60]  Anna G. Stefanopoulou,et al.  Control-Oriented Modeling and Analysis for Automotive Fuel Cell Systems , 2004 .

[61]  J. Pukrushpan.  Modeling and control of fuel cell systems and fuel processors , 2003 .

[62]  Anna G. Stefanopoulou,et al.  Modeling and control for PEM fuel cell stack system , 2002, Proceedings of the 2002 American Control Conference (IEEE Cat. No.CH37301).

[63]  Trung Van Nguyen,et al.  A Two-Dimensional, Two-Phase, Multicomponent, Transient Model for the Cathode of a Proton Exchange Membrane Fuel Cell Using Conventional Gas Distributors , 2001 .

[64]  James Larminie,et al.  Fuel Cell Systems Explained , 2000 .

[65]  Felix N. Büchi,et al.  Operating Proton Exchange Membrane Fuel Cells Without External Humidification of the Reactant Gases Fundamental Aspects , 1997 .

[66]  C. Gardner,et al.  Studies on ion-exchange membranes. Part 1. Effect of humidity on the conductivity of Nafion® , 1996 .

[67]  T. Springer,et al.  Modeling and Experimental Diagnostics in Polymer Electrolyte Fuel Cells , 1993 .

[68]  Mark W. Verbrugge,et al.  A Mathematical Model of the Solid‐Polymer‐Electrolyte Fuel Cell , 1992 .

[69]  T. Springer,et al.  Polymer Electrolyte Fuel Cell Model , 1991 .