Robust Tolerance Design of Mechanical Assemblies Using a Multi-Objective Optimization Formulation

[1]  J. Peters.  Tolerancing the Components of an Assembly for Minimum Cost , 1970 .

[2]  Yimin Zhang,et al.  Robust tolerance design for function generation mechanisms with joint clearances , 2010 .

[3]  D. B. Parkinson.  Assessment and optimization of dimensional tolerances , 1985 .

[4]  Jean-Yves Dantan,et al.  Improved algorithm for tolerance allocation based on Monte Carlo simulation and discrete optimization , 2009, Comput. Ind. Eng..

[5]  Yu Zhao,et al.  Simultaneous Optimization of Robust Parameter and Tolerance Design Based on Generalized Linear Models , 2013, Qual. Reliab. Eng. Int..

[6]  T. C. Woo,et al.  Tolerances: Their Analysis and Synthesis , 1990 .

[7]  S. Khodaygan,et al.  Fuzzy-small degrees of freedom representation of linear and angular variations in mechanical assemblies for tolerance analysis and allocation , 2011 .

[8]  S. A. Irani,et al.  Tolerance chart optimization , 1989 .

[9]  P. Asokan,et al.  Sensitivity-based conceptual design and tolerance allocation using the continuous ants colony algorithm (CACO) , 2005 .

[10]  L. F. Hauglund,et al.  Least Cost Tolerance Allocation for Mechanical Assemblies with Automated Process Selection , 1990 .

[11]  Man-Hee Park,et al.  Optimal tolerance allocation with loss functions , 2000 .

[12]  Angus Jeang,et al.  Robust Tolerance Design by Response Surface Methodology , 1999 .

[13]  Chun Zhang,et al.  Robust design of assembly and machining tolerance allocations , 1998 .

[14]  Yu Wang,et al.  Study on the tolerance allocation optimization by fuzzy-set weight-center evaluation method , 2007 .