Numerical investigation and thermodynamic analysis of the effect of electrolyte flow rate on performance of all vanadium redox flow batteries

Abstract In flow batteries, electrolyte flow rate plays a crucial role on the minimizing mass transfer polarization which is at the compensation of higher pressure drop. In this work, a two-dimensional numerical method is applied to investigate the effect of electrolyte flow rate on cell voltage, maximum depth of discharge and pressure drop a six-cell stack of VRFB. The results show that during the discharge process, increasing electrolyte flow rate can raise the voltage of each cell up to 50 mV on average. Moreover, the maximum depth of discharge dramatically increases with electrolyte flow rate. On the other hand, the pressure drop also positively correlates with electrolyte flow rate. In order to investigate all these effects simultaneously, average energy and exergy efficiencies are introduced in this study for the transient process of VRFB. These efficiencies give insight into choosing an appropriate strategy for the electrolyte flow rate. Finally, the energy efficiency of electricity storage using VRFB is investigated and compared with other energy storage systems. The results illustrate that this kind of battery has at least 61% storage efficiency based on the second law of thermodynamics, which is considerably higher than that of their counterparts.

[1]  R. Roshandel,et al.  Thermodynamic analysis of application of organic Rankine cycle for heat recovery from an integrated DIR-MCFC with pre-reformer , 2013 .

[2]  Dongjiang You,et al.  A simple model for the vanadium redox battery , 2009 .

[3]  P. Marconi,et al.  Recovery of pickling effluents by electrochemical oxidation of ferrous to ferric chloride , 1996 .

[4]  Frank C. Walsh,et al.  Non-isothermal modelling of the all-vanadium redox flow battery , 2009 .

[5]  B. Dunn,et al.  Electrical Energy Storage for the Grid: A Battery of Choices , 2011, Science.

[6]  David Sinton,et al.  High-performance microfluidic vanadium redox fuel cell , 2007 .

[7]  Lidiya Komsiyska,et al.  Modeling a vanadium redox flow battery system for large scale applications , 2013 .

[8]  Qian Xu,et al.  Numerical investigations of flow field designs for vanadium redox flow batteries , 2013 .

[9]  M. Gattrell,et al.  Study of the Mechanism of the Vanadium 4+/5+ Redox Reaction in Acidic Solutions , 2004 .

[10]  Megan Jobson,et al.  Energy Management Strategies for Process Site CO2 Emissions Reduction , 2012 .

[11]  Nanfang Wang,et al.  Influence of organic additives on electrochemical properties of the positive electrolyte for all-vanadium redox flow battery , 2012 .

[12]  Xinping Qiu,et al.  Nafion/organically modified silicate hybrids membrane for vanadium redox flow battery , 2009 .

[13]  Maria Skyllas-Kazacos,et al.  Progress in Flow Battery Research and Development , 2011 .

[14]  Tomoo Yamamura,et al.  Electron-Transfer Kinetics of Np3 + ∕ Np4 + , NpO2 + ∕ NpO2 2 + , V2 + ∕ V3 + , and VO2 + ∕ VO2 + at Carbon Electrodes , 2005 .

[15]  Christian Blanc.  Modeling of a vanadium redox flow battery electricity storage system , 2009 .

[16]  Michael Vynnycky,et al.  Analysis of a model for the operation of a vanadium redox battery , 2011 .

[17]  Frank C. Walsh,et al.  A dynamic performance model for redox-flow batteries involving soluble species , 2008 .

[18]  Rodolfo Taccani,et al.  Simulation of process for electrical energy production based on molten carbonate fuel cells , 2003 .

[19]  Ibrahim Dincer,et al.  Energy and exergy analyses of a hybrid molten carbonate fuel cell system , 2008 .

[20]  Chao-Yang Wang,et al.  Fundamental models for fuel cell engineering. , 2004, Chemical reviews.

[21]  Dan Gao,et al.  An integrated energy storage system based on hydrogen storage: Process configuration and case studies with wind power , 2014 .

[22]  Nan Zhang,et al.  Techno-Economic Optimization of IGCC Integrated with Utility System for CO2 Emissions Reduction , 2012 .

[23]  G. Graff,et al.  A Stable Vanadium Redox‐Flow Battery with High Energy Density for Large‐Scale Energy Storage , 2011 .

[24]  Jianguo Liu,et al.  A multilayered membrane for vanadium redox flow battery , 2012 .

[25]  M. Skyllas-Kazacos,et al.  The vanadium redox battery for emergency back-up applications , 1997, Proceedings of Power and Energy Systems in Converging Markets.

[26]  K. Sundmacher,et al.  A Mass Integration Concept for High Temperature Fuel Cell Plants , 2011 .

[27]  Arvind R. Kalidindi,et al.  A Transient Vanadium Flow Battery Model Incorporating Vanadium Crossover and Water Transport through the Membrane , 2012 .

[28]  Gang Qiu,et al.  3-D pore-scale resolved model for coupled species/charge/fluid transport in a vanadium redox flow battery , 2012 .

[29]  Katarzyna Sobotka.  A wind-power fuel cell hybrid system study: Model of energy conversion for wind energy system with hydrogen storage , 2010 .

[30]  Shu-Jyuan Yang,et al.  Preparation and electrochemical activities of iridium-decorated graphene as the electrode for all-vanadium redox flow batteries , 2012 .

[31]  D. Schmal,et al.  Mass transfer at carbon fibre electrodes , 1986 .

[32]  Xindong Wang,et al.  Investigation of Ir-modified carbon felt as the positive electrode of an all-vanadium redox flow battery , 2007 .