Emulation of anamorphic imaging on the SHARP extreme ultraviolet mask microscope

Abstract. The SHARP high-numerical aperture actinic reticle review project is a synchrotron-based, extreme ultraviolet (EUV) microscope dedicated to photomask research. SHARP emulates the illumination and imaging conditions of current EUV lithography scanners and those several generations into the future. An anamorphic imaging optic with increased mask-side numerical aperture (NA) in the horizontal and increased demagnification in the vertical direction has been proposed to overcome limitations of current multilayer coatings and extend EUV lithography beyond 0.33 NA. Zoneplate lenses with an anamorphic 4×/8× NA of 0.55 are fabricated and installed in the SHARP microscope to emulate anamorphic imaging. SHARP’s Fourier synthesis illuminator with a range of angles exceeding the collected solid angle of the newly designed elliptical zoneplates can produce arbitrary angular source spectra matched to anamorphic imaging. A target with anamorphic dense features down to 50-nm critical dimension is fabricated using 40 nm of nickel as the absorber. In a demonstration experiment, anamorphic imaging at 0.55 4×/8× NA and 6 deg central ray angle (CRA) is compared with conventional imaging at 0.5 4× NA and 8 deg CRA. A significant contrast loss in horizontal features is observed in the conventional images. The anamorphic images show the same image quality in the horizontal and vertical directions.

[1]  Takeshi Isogawa,et al.  Learning from native defects on EUV mask blanks , 2014, Photomask and Next Generation Lithography Mask Technology.

[2]  Kenneth A. Goldberg,et al.  EUV actinic brightfield mask microscopy for predicting printed defect images , 2015, SPIE Photomask Technology.

[3]  Iacopo Mochi,et al.  Actinic mask imaging: recent results and future directions from the SHARP EUV microscope , 2014, Advanced Lithography.

[4]  Bernhard Kneer,et al.  EUV lithography optics for sub-9nm resolution , 2015, Advanced Lithography.

[5]  Kenneth A. Goldberg,et al.  Demonstration of 22-nm half pitch resolution on the SHARP EUV microscope , 2015 .

[6]  Eric M. Gullikson,et al.  Understanding EUV mask blank surface roughness induced LWR and associated roughness requirement , 2015, Advanced Lithography.

[7]  Bernhard Kneer,et al.  Anamorphic high-NA EUV lithography optics , 2015, European Mask and Lithography Conference.

[8]  Martin Burkhardt,et al.  Best focus shift mechanism for thick masks , 2015, Advanced Lithography.

[9]  Erik R. Hosler,et al.  EUV and optical lithographic pattern shift at the 5nm node , 2016, SPIE Advanced Lithography.

[10]  Kenneth A. Goldberg,et al.  Enhancing defect detection with Zernike phase contrast in EUV multilayer blank inspection , 2015, Advanced Lithography.

[11]  Jeffrey Bokor,et al.  Fourier-synthesis custom-coherence illuminator for extreme ultraviolet microfield lithography. , 2003, Applied optics.

[12]  Takeshi Isogawa,et al.  Repairing native defects on EUV mask blanks , 2014, Photomask Technology.

[13]  Sudhar Raghunathan,et al.  Imaging impact of multilayer tuning in EUV masks, experimental validation , 2014, Photomask Technology.

[14]  Kenneth A. Goldberg,et al.  Experimental measurements of telecentricity errors in high-numerical-aperture extreme ultraviolet mask images , 2014 .

[15]  Sascha Migura,et al.  EUV lithography scanner for sub-8nm resolution , 2015, Advanced Lithography.

[16]  Winfried Kaiser,et al.  Mask effects for high-NA EUV: impact of NA, chief-ray-angle, and reduction ratio , 2013, Advanced Lithography.