Groundwall insulation damage localization of large generator stator bar using an active Lamb waves method

Condition monitoring of stator insulation is significant for reliable operation of large generators. However, locating groundwall insulation damage in a stator bar using existing methods is difficult. A new groundwall insulation damage localization method based on active Lamb waves is proposed in this study to address this issue. Two piezoelectric (PZT) transducers are mounted on the surface of a stator bar; one PZT works as an actuator to generate Lamb waves and the other works as a receiver to capture the propagated Lamb waves. The Hilbert transform associated with a cross-correlation function is then used to extract the time of flight of the damage-scattered wave. Consequently, a one-dimensional location model is established to determine the insulation damage position in stator bar. The proposed method has been experimentally verified by detecting insulation damages in both the slot and end-winding stator bars dismantled from a 18 kV/300 MW generator. Results show that the proposed method can effectively locate insulation damage in stator bars with high precision. In addition, the proposed method exhibits good noise robustness to avoid interference.

[1]  Jiancheng Song,et al.  Diagnosis of stator winding insulation of large generator based on partial discharge measurement , 2006 .

[2]  Bo Hu,et al.  Application of guided waves and probability imaging approach for insulation damage detection of large generator stator bar , 2015, IEEE Transactions on Dielectrics and Electrical Insulation.

[3]  T. Weiers,et al.  Significance of Defects Inside In-Service Aged Winding Insulations , 2008, IEEE Transactions on Energy Conversion.

[4]  Z. Su,et al.  Identification of Damage Using Lamb Waves , 2009 .

[5]  Bo Hu,et al.  Research on damage detection of large generator stator insulation using guided waves , 2013, 2013 Annual Report Conference on Electrical Insulation and Dielectric Phenomena.

[6]  Klaus Fröhlich,et al.  Insulation Failure Mechanisms of Power Generators , 2008 .

[7]  G.C. Stone,et al.  Partial discharge diagnostics and electrical equipment insulation condition assessment , 2005, IEEE Transactions on Dielectrics and Electrical Insulation.

[8]  M. Runde,et al.  A Review of Results From Thermal Cycling Tests of Hydrogenerator Stator Windings , 2011, IEEE Transactions on Energy Conversion.

[9]  Peter Cawley,et al.  Guided wave attenuation in coated pipes buried in sand , 2016 .

[10]  H. Lamb.  On waves in an elastic plate , 1917 .

[11]  K. Frohlich,et al.  Insulation Failure Mechanisms of Power Generators [Feature Article] , 2008, IEEE Electrical Insulation Magazine.

[12]  J. Rose.  Ultrasonic Waves in Solid Media , 1999 .

[13]  G.C. Stone.  Recent important changes in IEEE motor and generator winding insulation diagnostic testing standards , 2005, IEEE Transactions on Industry Applications.

[14]  K. Balasubramaniam,et al.  Modelling of attenuation of Lamb waves using Rayleigh damping: Numerical and experimental studies , 2011 .

[15]  G. Stone,et al.  A perspective on online partial discharge monitoring for assessment of the condition of rotating machine stator winding insulation , 2012, IEEE Electrical Insulation Magazine.

[16]  L. Ye,et al.  Quantitative assessment of through-thickness crack size based on Lamb wave scattering in aluminium plates , 2008 .

[17]  Thomas M. Wolbank,et al.  Induction Machine Insulation Health State Monitoring Based on Online Switching Transient Exploitation , 2015, IEEE Transactions on Industrial Electronics.

[18]  N. Taylor,et al.  Dielectric and physico-chemical properties of epoxy-mica insulation during thermoelectric aging , 2015, IEEE Transactions on Dielectrics and Electrical Insulation.

[19]  M. A. R. M. Fernando,et al.  Condition assessment of stator insulation during drying, wetting and electrical ageing , 2013, IEEE Transactions on Dielectrics and Electrical Insulation.

[20]  C. Sumereder,et al.  Statistical lifetime of hydro generators and failure analysis , 2008, IEEE Transactions on Dielectrics and Electrical Insulation.

[21]  Lin Ye,et al.  Guided Lamb waves for identification of damage in composite structures: A review , 2006 .

[22]  G. C. Stone,et al.  Condition monitoring and diagnostics of motor and stator windings – A review , 2013, IEEE Transactions on Dielectrics and Electrical Insulation.

[23]  Kazuro Kageyama,et al.  Dispersion analysis of Lamb waves and damage detection for aluminum structures using ridge in the time-scale domain , 2009 .

[24]  R. Bozzo,et al.  PD detection and localization by means of acoustic measurements on hydrogenerator stator bars , 1995 .

[25]  H Zhu,et al.  Acoustic monitoring of stator winding delaminations during thermal cycling testing , 2010, IEEE Transactions on Dielectrics and Electrical Insulation.

[26]  Z. Jia,et al.  Evaluation of the Degradation of Generator Stator Ground Wall Insulation Under Multistresses Aging , 2008, IEEE Transactions on Energy Conversion.

[27]  Ye Lu,et al.  Conjunctive and compromised data fusion schemes for identification of multiple notches in an aluminium plate using lamb wave signals , 2010, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[28]  T.G. Habetler,et al.  A Survey of Methods for Detection of Stator-Related Faults in Induction Machines , 2007, IEEE Transactions on Industry Applications.

[29]  Martin Veidt,et al.  A Lamb-wave-based technique for damage detection in composite laminates , 2009 .

[30]  Kazuro Kageyama,et al.  A Fiber Optic Doppler Sensor and Its Application in Debonding Detection for Composite Structures , 2010, Sensors.

[31]  R. M. Tallam,et al.  A survey of methods for detection of stator related faults in induction machines , 2003, 4th IEEE International Symposium on Diagnostics for Electric Machines, Power Electronics and Drives, 2003. SDEMPED 2003..

[32]  Yoshiharu Kaneda,et al.  The role of microscopic defects in multistress aging of micaceous insulation , 1995 .