A parametric study on the thermal performance of cross-corrugated solar air collectors

A comprehensive parametric study has been carried out in this paper on the thermal performance of cross-corrugated solar air collectors. These collectors consists of a wavelike absorbing plate and a wavelike bottom plate which are crosswise positioned to form the air flow channel. Two types of these collectors are considered. For the Type 1 collector, the wavelike shape of the absorbing plate is along the flow direction and that of the bottom plate is perpendicular to the flow direction, while for the Type 2 collector it is the wavelike shape of the bottom plate that is along the flow direction and that of the absorbing plate is perpendicular to the flow direction. The aim of the use of the cross-corrugated absorbing plate and bottom plate is to enhance the turbulence and the heat transfer rate inside the air flow channel which are crucial to the improvement of efficiencies of solar air collectors. To quantify the achievable improvements with the cross-corrugated absorbing and bottom plates, a flat-plate solar air collector which has both a flat absorbing plate and a flat bottom plate, is also considered. The thermal performance of these three types of solar air collector are analyzed and compared under various configurations and operating conditions. The results show that although the thermal performance of the Type 2 collector is just slightly superior to that of the Type 1 collector both of these cross-corrugated solar air collectors have a significantly superior thermal performance to that of the flat-plate one. It is also found that to achieve a higher collector efficiency, it is essential to construct the collectors having slender configurations along the air flow direction, to maintain a small mean gap between the absorbing plate and bottom plate, to use selected coatings on the absorbing plate and glass cover, to maintain a higher air mass flow rate, and to operate the collectors with the inlet fluid temperature close to that of the ambient fluid.

[1]  J. Richard Williams.  Design and installation of solar heating and hot water systems , 1983 .

[2]  E. G. Hauptmann,et al.  Forced Convective Heat Transfer in Cross-Corrugated Solar Air Heaters , 1994 .

[3]  E. Sparrow,et al.  Heat/mass transfer characteristics for flow in a corrugated wall channel. , 1977 .

[4]  T. Unny,et al.  Free convective heat transfer across inclined air layers , 1976 .

[5]  J. Stasiek,et al.  Experimental studies of heat transfer and fluid flow across corrugated-undulated heat exchanger surfaces , 1998 .

[6]  John W. Mitchell,et al.  Convective heat transfer in vee-trough linear concentrators , 1982 .

[7]  R. E. Bolz,et al.  CRC Handbook of tables for Applied Engineering Science , 1970 .

[8]  P. A. Sheppard,et al.  Long-wave radiation from clear skies , 1964 .

[9]  Enrong Lu,et al.  Numerical study on natural convection inside the channel between the flat-plate cover and sine-wave absorber of a cross-corrugated solar air heater , 2000 .

[10]  E. Sparrow,et al.  Experiments on the Transfer Characteristics of a Corrugated Fin and Tube Heat Exchanger Configuration , 1976 .

[11]  W. Beckman,et al.  Solar Engineering of Thermal Processes , 1985 .

[12]  Ruzhu Wang,et al.  Comparison of heating and natural ventilation in a solar house induced by two roof solar collectors , 2005 .

[13]  E. K. Glakpe,et al.  Natural Convection in a Corrugated Enclosure With Mixed Boundary Conditions , 1996 .

[14]  E. W. Dickinson,et al.  Solar Energy Technology Handbook Part B Applications, systems Design, and Economics , 1980 .

[15]  H. Gurney.  Heat Transmission , 1909, Nature.

[16]  Y. Piao,et al.  Natural, forced and mixed convection in a vertical cross-corrugated channel , 1992 .

[17]  Paul N. Cheremisinoff,et al.  Solar Energy Technology Handbook/Part A: Engineering Fundamentals , 1977 .

[18]  J. Whitelaw,et al.  Convective heat and mass transfer , 1966 .