Ground-Based Simulation of Low-Earth Orbit Plasma Conditions: Plasma Generation and Characterization

A 16-cm diameter plasma source operated on argon is described that is capable of producing a plasma environment that closely simulates the low Earth orbit (LEO) conditions experienced by satellites in the altitude range between 300 to 500 km. The plasma source uses a transverse-field magnetic filter, and has been successful in producing low electron temperature plasmas that contain streaming ion populations. Both of these characteristics are important because the plasma in LEO is relatively cold (e.g., Te approx. 0.1 eV) and the ram energy of the ions due to the motion of the satellite relative to the LEO plasma is high (e.g., 7,800 m/s which corresponds to approx. 5 eV for O+ ions). Plasma source operational conditions of flow rate and discharge power are presented that allow the electron temperature to be adjusted over a range from 0.14 to 0.4 eV. The expanding plasma flow field downstream of the source contains both low-energy, charge-exchange ions and streaming ions with energies that are adjustable over a range from 4 eV to 6 eV. At low flow rates and low facility pressures, the streaming ion component of the ion population comprises over 90% of the total plasma density. In the work described herein, a large area retarding potential analyzer was used to measure both electron and ion energy distribution functions in the low density, expanding plasma produced downstream of the plasma source. The benefits of using this type of plasma diagnostic tool in easily perturbed, low-density plasma are identified, and techniques are also discussed that can be used to perform real-time measurements of electron temperature. Finally, recommendations are made that may enable lower electron temperatures to be produced while simultaneously decreasing the plasma source flow rate below 1 to 2 sccm.

[1]  Sven G. Bilen,et al.  Measurement of Cross-Section Geometry Effects on Electron Collection to Long Probes in Mesosonic Flowing Plasmas , 2003 .

[2]  Sven G. Bilen,et al.  Model of Current Collection to Small Breaches in Electrodynamic-Tether Insulation , 2003 .

[3]  D. Ferguson,et al.  ISS FPP Ionospheric Electron Density and Temperature Measurements: Results, Comparison with the IRI-90 Model, and Implications for ISS Charging , 2003 .

[4]  Masayuki Hikita,et al.  Plasma Response to Arcing in Ionospheric Plasma Environment: Laboratory Experiment , 2002 .

[5]  M. Williams,et al.  CO-AXIAL MULTICUSP SOURCE FOR LOW AXIAL ENERGY SPREAD ION BEAM PRODUCTION , 1999 .

[6]  C. V. Doreswamy,et al.  Electrical breakdown of anodized coatings in low-density plasmas , 1999 .

[7]  J. Matossian.  Plasma ion implantation technology at Hughes Research Laboratories , 1994 .

[8]  I. Katz,et al.  Electrical Breakdown Currents on Large Spacecraft in Low Earth Orbit , 1994 .

[9]  K. Leung,et al.  Production of atomic nitrogen ion beams , 1990 .

[10]  B. Banks,et al.  The NASA atomic oxygen effects test program , 1988 .

[11]  M. Akiba,et al.  3D computer simulation of the primary electron orbits in a magnetic multipole plasma source , 1987 .

[12]  A. Potter,et al.  Experimental studies of scaling laws for plasma collection at high voltages , 1984 .

[13]  Hiroshi Horiike,et al.  High magnetic field, large-volume magnetic multipole ion source producing hydrogen ion beams with high proton ratio , 1984 .

[14]  K. W. Ehlers,et al.  Effect of a magnetic filter on hydrogen ion species in a multicusp ion source , 1981 .

[15]  P. Gill,et al.  Electron energy distributions in the negative glow and their relevance to hollow cathode lasers , 1977 .

[16]  E. P. Szuszczewicz,et al.  Surface contamination of active electrodes in plasmas: Distortion of conventional Langmuir probe measurements , 1975 .

[17]  Bill G. Herron,et al.  High-Voltage Solar Array Technology , 1972 .