All-Optical 500-Mb/s UWB Transceiver:An Experimental Demonstration

We propose and demonstrate experimentally, for the first time, a prototype for all-optical ultra-wideband (UWB) transceiver at 500 Mb/s. We report 1) UWB pulse optimization that takes into account the transmitter RF front end and the U.S. federal communications commission (FCC) spectral mask, 2) a new approximate match filter receiver using optical signal processing, and 3) modulation at 500 Mb/s. Our previous optimization of UWB pulse shapes was based only on the FCC spectral mask, without taking into account the frequency response of the RF components (amplifier and antenna) in the UWB transmitter. Here, we modify our pulse optimization technique to ensure that the equivalent isotropic radiated power (EIRP) from the transmitter meets FCC specifications. For the RF hardware used, we achieve 63.6% efficiency over the FCC mask, which yields an 11.6- and a 5.9-dB improvement over Gaussian monocycle and doublet pulses, respectively. We also introduce simple optical signal processing at the receiver that allows the incoming RF signal to be matched against a square pulse whose duration is adapted to the channel. The exact matched filter would require a new optimized pulse that would include not only hardware frequency response but channel effects that vary with antenna placement as well. The proposed approximation allows a simple variation of the pulse duration: an increase to account for pulse expansion in the channel but an upper limit to combat multipath effects. Finally, we demonstrate the optimized pulse and approximate match filter receiver at 500 M/s. We attain a 10-6bit error rate at a 65-cm separation line of sight (LOS) link with simple on-off keying and no forward error correction.

[1]  Georgios B. Giannakis,et al.  Optimal waveform design for UWB radios , 2006, IEEE Trans. Signal Process..

[2]  Umberto Mengali,et al.  M-PPM noncoherent receivers for UWB applications , 2006, IEEE Transactions on Wireless Communications.

[3]  J.D. McKinney,et al.  Shaping the Power Spectrum of Ultra-Wideband Radio-Frequency Signals , 2006, IEEE Transactions on Microwave Theory and Techniques.

[4]  Stephen P. Boyd,et al.  FIR filter design via semidefinite programming and spectral factorization , 1996, Proceedings of 35th IEEE Conference on Decision and Control.

[5]  Chao Wang,et al.  All-Fiber Ultrawideband Pulse Generation Based on Spectral Shaping and Dispersion-Induced Frequency-to-Time Conversion , 2007, IEEE Photonics Technology Letters.

[6]  L.A. Rusch,et al.  Wideband antenna EIRP measurements for various UWB waveforms , 2008, 2008 IEEE International Conference on Ultra-Wideband.

[7]  D. Pozar Microwave Engineering , 1990 .

[8]  Fei Zeng,et al.  All-optical UWB impulse generation based on cross-phase modulation and frequency discrimination , 2007 .

[9]  I. Lin,et al.  Photonic synthesis of broadband microwave arbitrary waveforms applicable to ultra-wideband communication , 2005, IEEE Microwave and Wireless Components Letters.

[10]  V. Srinivasa Somayazulu,et al.  Ultrawideband radio design: the promise of high-speed, short-range wireless connectivity , 2004, Proceedings of the IEEE.

[11]  J.D. Brunett,et al.  On measurements for EIRP compliance of UWB devices , 2005, 2005 International Symposium on Electromagnetic Compatibility, 2005. EMC 2005..

[12]  B. Jalali,et al.  Adaptive RF-photonic arbitrary waveform generator , 2003, IEEE Photonics Technology Letters.

[13]  S. LaRochelle,et al.  Generation of Power-Efficient FCC-Compliant UWB Waveforms Using FBGs: Analysis and Experiment , 2008, Journal of Lightwave Technology.

[14]  S. LaRochelle,et al.  Ultra-Wideband Waveform Generator Based on Optical Pulse-Shaping and FBG Tuning , 2008, IEEE Photonics Technology Letters.

[15]  Jos F. Sturm,et al.  A Matlab toolbox for optimization over symmetric cones , 1999 .