Due to the length of the mill, accurate modelling of stationary solution of continuous cold roll forming by the finite element method using the classical Lagrangian formulation usually requires a very large mesh leading to huge CPU times. In order to model industrial forming lines including many tools in a reasonable time, the sheet has to be shortened or the element size has to be increased leading to inaccurate results. On top of this, applying loads and boundary conditions on this smaller sheet is usually more difficult than in the continuous case. Moreover, transient dynamic vibrations, which are unnecessarily computed, may appear when the sheet hits each tool, decreasing the convergence rate of the numerical simulation. Beside this classical Lagrangian approach, an alternative method is given by the Arbitrary Lagrangian Eulerian (ALE) formalism which consists in decoupling the motion of the material and the mesh. Starting from an initial guess of the sheet geometry between the rolls, the numerical simulation is performed until the stationary state is reached with a mesh, the nodes of which are fixed in the rolling direction but are free to move on perpendicular plane, following the geometrical boundary of the sheet. The whole forming line can then be modelled using a limited number of brick and contact elements because the mesh is only refined near the tools where bending and contact occur. In this paper, ALE results are compared to previous Lagrangian simulations and experimental measurement on a U-channel, including springback. Advantages of the ALE method are finally demonstrated by the simulation of a tubular rocker panel on a 16-stands forming mill.
[1]
Naksoo Kim,et al.
A parametric study on forming length in roll forming
,
2001
.
[2]
Jean-Philippe Ponthot,et al.
Application of the Arbitrary Lagrangian Eulerian formulation to the numerical simulation of cold roll forming process
,
2006
.
[3]
Michael Lindgren,et al.
Cold roll forming of a U-channel made of high strength steel
,
2007
.
[4]
D. Benson.
An efficient, accurate, simple ALE method for nonlinear finite element programs
,
1989
.
[5]
Jean-Philippe Ponthot,et al.
Finite element simulation of lubricated contact in rolling using the arbitrary Lagrangian–Eulerian formulation
,
2004
.
[6]
Jean-Philippe Ponthot,et al.
Numerical simulation of springback using enhanced assumed strain elements
,
2004
.
[7]
George Halmos,et al.
Roll Forming Handbook
,
2005
.
[8]
Michel Brunet,et al.
Modelling of a roll-forming process with a combined 2D and 3D FEM code
,
1998
.
[9]
David J. Benson,et al.
Momentum advection on unstructured staggered quadrilateral meshes
,
2008
.
[10]
Taylan Altan,et al.
Simulation of roll forming process with the 3-D FEM code PAM-STAMP
,
1996
.