Air-Side Heat-Transfer Enhancement by a New Winglet-Type Vortex Generator Array in a Plain-Fin Round-Tube Heat Exchanger

The impact of a vortex-generation technique for air-side heat-transfer improvement is experimentally investigated through full-scale wind-tunnel testing of a plain-fin round-tube heat exchanger under dry-surface conditions. Inspired by the formation locomotion of animals in nature, a new vortex generator (VG) array deployed in a "V" is proposed in the present work, aiming to create constructive interference between vortices. The array is composed of two delta-winglet pairs and placed at an attack angle of 10 deg or 30 deg. Its effectiveness is compared with a baseline configuration and two conventional single-pair designs placed at 30 deg, a small pair with half the area of the array and a large pair with the same area as the array. The frontal air velocity considered ranges from 2.3 m/s to 5.5 m/s, corresponding to a Reynolds number range based on the hydraulic diameter of 1400―3400. The experimental results show little impact of the 10 deg array and a moderate heat-transfer improvement of up to 32% for the small pair, both introducing additional pressure loss of approximately 20―40%. For the 30 deg array and the large pair, similar augmentation of 25―55% in air-side heat-transfer coefficient is obtained accompanied by average pressure drop penalties of 90% and 140%, respectively. Performance evaluation using the criteria of the modified area goodness factor and the volume goodness factor indicates the superiority of the heat exchanger enhanced by the 30 deg array among all the investigated VGs. The VG array is found more effective at comparatively low Reynolds numbers, representative of many heating, ventilation, air-conditioning, and refrigeration applications and compact heat-exchanger designs.

[1]  Patrice Tochon,et al.  Intensification of heat-transfer and mixing in multifunctional heat exchangers by artificially generated streamwise vorticity , 2006 .

[2]  Martin Fiebig,et al.  Wing-type vortex generators for fin-and-tube heat exchangers , 1993 .

[3]  Anthony M. Jacobi,et al.  Heat transfer enhancement by winglet-type vortex generator arrays in compact plain-fin-and-tube heat exchangers , 2008 .

[4]  D. M. Bushnell,et al.  DRAG REDUCTION IN NATURE , 1991 .

[5]  R. Shah,et al.  Heat transfer surface enhancement through the use of longitudinal vortices: a review of recent progress , 1995 .

[6]  M. Fiebig.  Vortices, Generators and Heat Transfer , 1998 .

[7]  Anthony M. Jacobi,et al.  Rational approaches for combining redundant, independent measurements to minimize combined experimental uncertainty , 2010 .

[8]  Jamal Saleh,et al.  Fluid Flow Handbook , 2002 .

[9]  P. Lissaman,et al.  Formation Flight of Birds , 1970, Science.

[10]  A. Jacobi,et al.  Air-Side Surface Wettability Effects on the Performance of Slit-Fin-and-Tube Heat Exchangers Operating Under Wet-Surface Conditions , 2009 .

[11]  Anthony M. Jacobi,et al.  Impact of leading edge delta-wing vortex generators on the thermal performance of a flat tube, louvered-fin compact heat exchanger , 2005 .

[12]  H. Weimerskirch,et al.  Energy saving in flight formation , 2001, Nature.

[13]  Anthony M. Jacobi,et al.  The Thermal-Hydraulic Impact of Delta-Wing Vortex Generators on the Performance of a Plain-Fin-and-Tube Heat Exchanger , 2002 .

[14]  Jiin-Yuh Jang,et al.  Heat transfer and fluid flow analysis in plate-fin and tube heat exchangers with a pair of block shape vortex generators , 2004 .

[15]  Koichi Nishino,et al.  Heat transfer enhancement accompanying pressure-loss reduction with winglet-type vortex generators for fin-tube heat exchangers. , 2002 .

[16]  Pan Chu,et al.  Three-Dimensional Numerical Study of Flow and Heat Transfer Enhancement Using Vortex Generators in Fin-and-Tube Heat Exchangers , 2009 .

[17]  Shantanu Biswas,et al.  Generation of Longitudinal Streamwise Vortices—A Device for Improving Heat Exchanger Design , 1994 .

[18]  Anthony M. Jacobi,et al.  A Numerical Study of Flow and Heat Transfer Enhancement Using an Array of Delta-Winglet Vortex Generators in a Fin-and-Tube Heat Exchanger , 2007 .

[19]  Anthony M. Jacobi,et al.  Air-side heat transfer enhancement of a refrigerator evaporator using vortex generation , 2005 .

[20]  Chi-Chuan Wang,et al.  Data reduction for air-side performance of fin-and-tube heat exchangers , 2000 .

[21]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[22]  D. Weihs.  Hydromechanics of Fish Schooling , 1973, Nature.

[23]  D. Siveter,et al.  Collective Behavior in an Early Cambrian Arthropod , 2008, Science.

[24]  Barry N. Taylor,et al.  Guidelines for Evaluating and Expressing the Uncertainty of Nist Measurement Results , 2017 .

[25]  M. Fiebig.  Embedded vortices in internal flow: heat transfer and pressure loss enhancement , 1995 .

[26]  W. Herrnkind,et al.  Drag Reduction by Formation Movement in Spiny Lobsters , 1976, Science.

[27]  Jiangbo Wu,et al.  Investigation on laminar convection heat transfer in fin-and-tube heat exchanger in aligned arrangement with longitudinal vortex generator from the viewpoint of field synergy principle , 2007 .