Construction of the JT-60SA tokamak was completed on schedule in March 2020. Manufacture and assembly of all the main tokamak components satisfied technical requirements, including dimensional accuracy and functional performances. Development of the plasma heating systems and diagnostics have also progressed, including the demonstration of the favourable electron cyclotron range of frequency (ECRF) transmission at multiple frequencies and the achievement of long sustainment of a high-energy intense negative ion beam. Development of all the tokamak operation control systems has been completed, together with an improved plasma equilibrium control scheme suitable for superconducting tokamaks including ITER. For preparation of the tokamak operation, plasma discharge scenarios have been established using this advanced equilibrium controller. Individual commissioning of the cryogenic system and the power supply system confirmed that these systems satisfy design requirements including operational schemes contributing directly to ITER, such as active control of heat load fluctuation of the cryoplant, which is essential for dynamic operation in superconducting tokamaks. The integrated commissioning (IC) is started by vacuum pumping of the vacuum vessel and cryostat, and then moved to cool-down of the tokamak and coil excitation tests. Transition to the super-conducting state was confirmed for all the TF, EF and CS coils. The TF coil current successfully reached 25.7 kA, which is the nominal operating current of the TF coil. For this nominal toroidal field of 2.25 T, ECRF was applied and an ECRF plasma was created. The IC was, however, suspended by an incident of over current of one of the superconducting equilibrium field coil and He leakage caused by insufficient voltage holding capability at a terminal joint of the coil. The unique importance of JT-60SA for H-mode and high-β steady-state plasma research has been confirmed using advanced integrated modellings. These experiences of assembly, IC and plasma operation of JT-60SA contribute to ITER risk mitigation and efficient implementation of ITER operation.
[1]
S. Mizumaki,et al.
Achievement of precise assembly of the JT-60SA superconducting tokamak
,
2021,
Fusion Engineering and Design.
[2]
L. Grisham,et al.
100 s negative ion accelerations for the JT-60SA negative-ion-based neutral beam injector
,
2021,
Nuclear Fusion.
[3]
N. Hayashi,et al.
Development of a novel integrated model GOTRESS+ for predictions and assessment of JT-60SA operation scenarios including the pedestal
,
2021,
Nuclear Fusion.
[4]
C. Sozzi,et al.
Thermo-mechanical assessment of the JT-60SA fast-ion loss detector
,
2021
.
[5]
L. Giudicotti,et al.
Design of JT-60SA core Thomson scattering diagnostic system.
,
2021,
The Review of scientific instruments.
[6]
E. Takada,et al.
Conceptual design of a collimator for the neutron emission profile monitor in JT-60SA using Monte Carlo simulations.
,
2020,
The Review of scientific instruments.
[7]
S. Pelli,et al.
Conceptual design of JT-60SA edge Thomson scattering diagnostic
,
2020,
Journal of Instrumentation.
[8]
Y. Kamada,et al.
Design of the Massive Gas Injection system for JT-60SA
,
2019
.
[9]
C. Sozzi,et al.
Physics requirements for the VUV survey spectrometer intended for the divertor radiation monitoring on JT-60SA
,
2019
.
[10]
S. Coda,et al.
EC assisted start-up experiment and predictions for the next generation fusion experiments
,
2019
.
[11]
C. Day,et al.
Assessment of the JT-60SA divertor cryopump performance
,
2018,
Fusion Engineering and Design.