Characteristics of convective heat transport in a packed pebble-bed reactor

Abstract Obtaining more precise results and a better understanding of the heat transport mechanism in the dynamic core of packed pebble-bed reactors is needed because this mechanism poses extreme challenges to the reliable design and efficient operation of these reactors. This mechanism can be quantified in terms of a solid-to-gas convective heat transfer coefficient. Therefore, in this work, the local convective heat transfer coefficients and their radial profiles were measured experimentally in a separate effect pilot-plant scale and cold-flow experimental setup of 0.3 m in diameter, using a sophisticated noninvasive heat transfer probe of spherical type. The effect of gas velocity on the heat transfer coefficient was investigated over a wide range of Reynolds numbers of practical importance. The experimental investigations of this work include various radial locations along the height of the bed. It was found that an increase in coolant gas flow velocity causes an increase in the heat transfer coefficient and that effect of the gas flow rate varies from laminar to turbulent flow regimes at all radial positions of the studied packed pebble-bed reactor. The results show that the local heat transfer coefficient increases from the bed center to the wall due to the change in the bed structure, and hence, in the flow pattern of the coolant gas. The findings clearly indicate that one value of an overall heat transfer coefficient cannot represent the local heat transfer coefficients within the bed; therefore, correlations are needed to predict the radial and axial profiles of the heat transfer coefficient.

[1]  Hee Cheon No,et al.  Thermal hydraulic behavior in the deteriorated turbulent heat transfer regime for a gas-cooled reactor , 2010 .

[2]  P. G. Rousseau,et al.  Introduction to the PBMR heat transfer test facility , 2008 .

[3]  M. Al-Dahhan,et al.  Heat transfer coefficients in a high-pressure bubble column , 2007 .

[4]  Henri Fenech,et al.  Heat transfer and fluid flow in nuclear systems , 1981 .

[5]  H. Li,et al.  Heat Transfer and Hydrodynamics in a Three-Phase Slurry Bubble Column , 1997 .

[6]  Andrew Grief,et al.  Development of Local Heat Transfer Models for Safety Assessment of High Temperature Gas-Cooled Reactor Cores—Part I: Pebble Bed Reactors , 2010 .

[7]  M. Kaviany.  Principles of heat transfer in porous media , 1991 .

[8]  Andrew Grief,et al.  Development of Local Heat Transfer Models for the Safety Assessment of High Temperature Gas-Cooled Reactor Cores—Part II: Prismatic Modular Reactors , 2010 .

[9]  V. Gnielinski,et al.  Equations for the calculation of heat and mass transfer during flow through stationary spherical packings at moderate and high Peclet numbers , 1981 .

[10]  Y. Hassan,et al.  Flow visualization in a pebble bed reactor experiment using PIV and refractive index matching techniques , 2008 .

[11]  Kwang-Yong Kim,et al.  Numerical treatment of pebble contact in the flow and heat transfer analysis of a pebble bed reactor core , 2007 .

[12]  Eugenijus Uspuras,et al.  Experimental investigation of pebble beds thermal hydraulic characteristics , 2008 .

[13]  P. Rousseau,et al.  Modeling the flow and heat transfer in a packed bed high temperature gas-cooled reactor in the context of a systems CFD approach , 2012 .

[14]  Andrew Grief,et al.  Development of Local Heat Transfer Models for Safety Assessment of Pebble Bed High Temperature Gas-Cooled Reactor Cores , 2008 .

[15]  Teunis Adrianus Hoogenboezem.  Heat transfer phenomena in flow through packed beds , 2006 .

[16]  Elmar Achenbach.  HEAT TRANSFER AND PRESSURE DROP OF PEBBLE BEDS UP TO HIGH REYNOLDS NUMBER , 1982 .

[17]  Hans D. Gougar,et al.  Conceptual Design of a Very High Temperature Pebble-Bed Reactor , 2003 .

[18]  A. Koster,et al.  PBMR design for the future , 2003 .

[19]  E. Schröder,et al.  Measurements of heat transfer between particles and gas in packed beds at low to medium Reynolds numbers , 2006 .

[20]  A. J. Goodjohn.  Summary of Gas-Cooled reactor programs , 1991 .

[21]  Sascha Becker,et al.  Three-Dimensional Numerical Simulation of Flow and Heat Transport in High-Temperature Nuclear Reactors , 2003 .

[22]  H. Johnstone,et al.  Heat and mass transfer in packed beds , 1955 .

[23]  E. Achenbach.  Heat and flow characteristics of packed beds , 1993 .