A new discrete circuit for readout of resistive sensor arrays

Abstract In this paper, we present a method that simplifies the interconnect complexity of N × M resistive sensor arrays from N × M to N + M. In this method, we propose to use two sets of interconnection lines in row–column fashion with all the sensor elements having one of their ends connected to a row line and other end to a column line. This interconnection overloading results in crosstalk among all the elements. This crosstalk causes the spreading of information over the whole array. The proposed circuit in this method takes care of this effect by minimizing the crosstalk. The circuit makes use of the concept of virtual same potential at the inputs of an operational amplifier in negative feedback to obtain a sufficient isolation among various elements. We theoretically present the suitability of the method for small/moderate sized sensor arrays and experimentally verify the predicted behavior by lock-in-amplifier based measurements on a light dependent resistor (LDR) in a 4 × 4 resistor array. Finally, we present a successful implementation of this method on a 16 × 16 imaging array of LDR.

[1]  Mircea Arcan,et al.  Dynamic contact stress analysis using a compliant sensor array , 1993 .

[2]  Andrea Baschirotto,et al.  A high-precision wide-range front-end for resistive gas sensors arrays , 2005 .

[3]  A. Kingon,et al.  Flexible thin film temperature and strain sensor array utilizing a novel sensing concept , 2007 .

[4]  Yan Lu,et al.  The new generation of BMW child seat and occupant detection system SBE2 , 2002 .

[5]  A. Flammini,et al.  A New Low-Cost Electronic System to Manage Resistive Sensors for Gas Detection , 2007, IEEE Sensors Journal.

[6]  Arun Ross,et al.  An introduction to biometric recognition , 2004, IEEE Transactions on Circuits and Systems for Video Technology.

[7]  M. Caria,et al.  Characterization of a silicon pixel detector for imaging with low energy radiation , 2002 .

[8]  P. Sarro,et al.  High-speed wavefront sensor compatible with standard CMOS technology , 2004 .

[9]  T. Tanaka,et al.  Infrared focal plane array incorporating silicon IC process compatible bolometer , 1996 .

[10]  M. Dijkstra,et al.  Micromachined two dimensional resistor arrays for determination of gas parameters , 2003, TRANSDUCERS '03. 12th International Conference on Solid-State Sensors, Actuators and Microsystems. Digest of Technical Papers (Cat. No.03TH8664).

[11]  A. la Cour-Harbo.  Geometrical modeling of a two-dimensional sensor array for determining spatial position of a passive object , 2004 .

[12]  J. Gardner,et al.  Polymeric resistive bridge gas sensor array driven by a standard cell CMOS current drive chip , 1999 .

[13]  C. R. Jalwania,et al.  A Novel Test Structure for Process Control Monitor for Un-Cooled Bolometer Area Array Detector Technology , 2006 .

[14]  Kun-Tae Kim,et al.  Prototype demonstration of low cost uncooled infrared focal plane arrays by using simple readout circuit , 2004 .

[15]  Julian W. Gardner,et al.  Thermal modelling and characterisation of micropower chemoresistive silicon sensors , 1997 .

[16]  V. Jayashankar,et al.  A Lock-in Technique for PD Measurement during Impulse Tests , 2007, IEEE Transactions on Dielectrics and Electrical Insulation.

[17]  S. Nelson,et al.  Radiation imaging with 2D a-Si sensor arrays , 1991, Conference Record of the 1991 IEEE Nuclear Science Symposium and Medical Imaging Conference.

[18]  Tayfun Akin,et al.  Low-cost uncooled infrared detectors in CMOS process , 2003 .

[19]  D. Choudhury.  Networks and Systems , 1988 .

[20]  Carlos A. Marqués,et al.  Digital lock in amplifier: study, design and development with a digital signal processor , 2004, Microprocess. Microsystems.

[21]  A. Sedra.  Microelectronic circuits , 1982 .

[22]  J. V. Hatfield,et al.  Current-mode multiplexer for interrogating resistive sensor arrays , 1994 .

[23]  German Vergara,et al.  Polycrystalline PbSe x-y addressed uncooled FPAs , 2003, SPIE Defense + Commercial Sensing.

[24]  C. R. Jalwania,et al.  Characterization of area arrays of microbolometer-based un-cooled IR detectors without using ROIC , 2008 .