Frictional properties of shale reservoir rocks

[1] We performed laboratory friction experiments on shale samples from three hydrocarbon reservoirs to assess compositional controls on fault slip behavior accompanying hydraulic stimulation. The samples span a range of clay and total organic content from ~10 to 60% by weight and demonstrate fine-scale heterogeneity within each reservoir. Friction measurements demonstrate strong dependence of strength and rate-state constitutive properties on shale composition. Shale samples with clay and organic content above ~30% by weight show coefficient of friction ~0.4 and consistently velocity-strengthening behavior, while those below this threshold show increased strength and velocity-weakening behavior. This transition in frictional strength and stability suggests a change in the shale grain packing framework from rigid clast supported to clay mineral and organic matter supported. Measurements of gouge dilatancy further support these relationships, showing a negative correlation with clay and organic content. Critical slip evolution distance exhibits similar dependence on composition, implying common micromechanical mechanisms for the observed transition in frictional behavior. We performed microstructural characterization of the experimental samples and observe changes in the gouge load-bearing framework and shear localization features consistent with these mechanical data. While these results can be applied generally to infer slip stability on faults in clay-bearing sedimentary rock, we employ the experimental data to place constraints on microearthquake magnitudes and the occurrence of slow shear slip on preexisting faults during hydraulic stimulation in shale reservoirs.

[1]  G. Mandl,et al.  Shear zones in granular material , 1977 .

[2]  Ben A. van der Pluijm,et al.  Mineralogical characterization of protolith and fault rocks from the SAFOD Main Hole , 2006 .

[3]  J. Dieterich.  Modeling of rock friction: 1. Experimental results and constitutive equations , 1979 .

[4]  D. Elsworth,et al.  Shear-induced dilatancy of fluid-saturated faults: Experiment and theory , 2009 .

[5]  C. Curtis.  Diagenetic alteration in black shales , 1980, Journal of the Geological Society.

[6]  Chris Marone,et al.  Frictional behavior and constitutive modeling of simulated fault gouge , 1990 .

[7]  K. Mair,et al.  Laboratory results indicating complex and potentially unstable frictional behavior of smectite clay , 2001 .

[8]  C. Dengo,et al.  Chapter 2 Fabrics of Experimental Fault Zones: Their Development and Relationship to Mechanical Behavior , 1992 .

[9]  D. Lockner,et al.  Quantitative measure of the variation in fault rheology due to fluid‐rock interactions , 1998 .

[10]  Brian Kilgore,et al.  Scaling of the critical slip distance for seismic faulting with shear strain in fault zones , 1993, Nature.

[11]  L. Cathles.  Assessing the greenhouse impact of natural gas , 2012 .

[12]  Mark D. Zoback,et al.  Reservoir Geomechanics: Index , 2007 .

[13]  G. Mandl,et al.  Fully Developed Plastic Shear Flow of Granular Materials , 1970 .

[14]  Quinn R. Passey,et al.  From Oil-Prone Source Rock to Gas-Producing Shale Reservoir - Geologic and Petrophysical Characterization of Unconventional Shale Gas Reservoirs , 2010 .

[15]  G. Beroza,et al.  Deep Tremors and Slow Quakes , 2009, Science.

[16]  C. Marone,et al.  Comparison of smectite- and illite-rich gouge frictional properties: application to the updip limit of the seismogenic zone along subduction megathrusts , 2003 .

[17]  D. Faulkner,et al.  Strength, porosity, and permeability development during hydrostatic and shear loading of synthetic quartz-clay fault gouge , 2008 .

[18]  Chris Marone,et al.  Particle-size distribution and microstructures within simulated fault gouge , 1989 .

[19]  Powering the low-carbon economy : the once and future roles of renewable energy and natural gas , 2010 .

[20]  Paul Anderson,et al.  It's a matter of size: Magnitude and moment estimates for microseismic data , 2010 .

[21]  J. Rice,et al.  Dilatant strengthening as a mechanism for slow slip events , 2010 .

[22]  D. Lockner,et al.  Frictional strengths of talc-serpentine and talc-quartz mixtures , 2011 .

[23]  G. Beroza,et al.  Non-volcanic tremor and low-frequency earthquake swarms , 2007, Nature.

[24]  T. Wong,et al.  Development of shear localization in simulated quartz gouge: Effect of cumulative slip and gouge particle size , 1994 .

[25]  F. Chester,et al.  Integrated Ocean Drilling Program Expedition 343/343T Preliminary Report, Japan Trench Fast Drilling Project (JFAST), 1 April–24 May 2012 and 5–19 July 2012 , 2012 .

[26]  J. Vermylen,et al.  Hydraulic Fracturing, Microseismic Magnitudes, and Stress Evolution in the Barnett Shale, Texas, USA , 2011 .

[27]  P. Bird.  Hydration-phase diagrams and friction of montmorillonite under laboratory and geologic conditions, with implications for shale compaction, slope stability, and strength of fault gouge , 1984 .

[28]  R. Marc Bustin,et al.  The importance of shale composition and pore structure upon gas storage potential of shale gas reservoirs , 2009 .

[29]  James P. Evans,et al.  Internal structure and weakening mechanisms of the San Andreas Fault , 1993 .

[30]  Zhigang Peng,et al.  An integrated perspective of the continuum between earthquakes and slow-slip phenomena , 2010 .

[31]  Ramil Ahmadov.  Elastic Properties of Source Rocks , 2010 .

[32]  C. Marone,et al.  Effect of hydration state on the frictional properties of montmorillonite-based fault gouge , 2007 .

[33]  A. Rubin,et al.  Role of fault gouge dilatancy on aseismic deformation transients , 2010 .

[34]  A. Skempton.  Long-Term Stability of Clay Slopes , 1964 .

[35]  D. Grauls,et al.  Mechanical compaction of sand/clay mixtures , 2002 .

[36]  J. Dieterich,et al.  Direct observation of frictional contacts: New insights for state-dependent properties , 1994 .

[37]  P. Vrolijk.  On the mechanical role of smectite in subduction zones , 1990 .

[38]  C. F. Moon.  The microstructure of clay sediments , 1972 .

[39]  M. Underwood.  Strike-parallel variations in clay minerals and fault vergence in the Cascadia subduction zone , 2002 .

[40]  J. Brune.  Tectonic stress and the spectra of seismic shear waves from earthquakes , 1970 .

[41]  R. Summers,et al.  A note on the effect of fault gouge composition on the stability of frictional sliding , 1977 .

[42]  P. R. Vaughan,et al.  The drained residual strength of cohesive soils , 1981 .

[43]  C. Marone.  LABORATORY-DERIVED FRICTION LAWS AND THEIR APPLICATION TO SEISMIC FAULTING , 1998 .

[44]  A. Ruina.  Slip instability and state variable friction laws , 1983 .

[45]  C. Marone,et al.  On the relation between fault strength and frictional stability , 2011 .

[46]  T. Wong,et al.  Effect of clay content and mineralogy on frictional sliding behavior of simulated gouges: Binary and ternary mixtures of quartz, illite, and montmorillonite , 2010 .

[47]  Toshihiko Shimamoto,et al.  Effects of simulated clay gouges on the sliding behavior of Tennessee sandston , 1981 .

[48]  D. Moos,et al.  Predicting Shale Reservoir Response to Stimulation: the Mallory 145 Multi-Well Project , 2011 .

[49]  G. Dresen,et al.  Source Parameters of Picoseismicity Recorded at Mponeng Deep Gold Mine, South Africa: Implications for Scaling Relations , 2011 .

[50]  M. Zoback,et al.  Long Period, Long Duration Seismic Events During Hydraulic Fracture Stimulation of a Shale Gas Reservoir , 2011 .

[51]  Mark W. McClure,et al.  The Importance of Slow Slip on Faults During Hydraulic Fracturing Stimulation of Shale Gas Reservoirs , 2012 .

[52]  C. Peach,et al.  Frictional properties of megathrust fault gouges at low sliding velocities: new data on effects of normal stress and temperature , 2012 .

[53]  J. Weeks,et al.  Determination of rock friction constitutive parameters using an iterative least squares inversion method , 1993 .

[54]  Kazushige Obara,et al.  Nonvolcanic Deep Tremor Associated with Subduction in Southwest Japan , 2002, Science.

[55]  L. Warr,et al.  Nanocoatings of clay and creep of the San Andreas fault at Parkfield, California , 2010 .

[56]  J. Dieterich.  Earthquake nucleation on faults with rate-and state-dependent strength , 1992 .

[57]  K. Masuda,et al.  Effects of clay content on the frictional strength and fluid transport property of faults , 2007 .

[58]  Mark D. Zoback,et al.  Long-period, long-duration seismic events during hydraulic fracture stimulation of a shale gas reservoir , 2011 .

[59]  J. Rice,et al.  Dilatancy, compaction, and slip instability of a fluid‐infiltrated fault , 1995 .

[60]  C. Sammis,et al.  The apparent friction of granular fault gouge in sheared layers , 1994 .

[61]  M. Underwood,et al.  Abundance of smectite and the location of a plate-boundary fault, Barbados accretionary prism , 2001 .

[62]  Norman R. Warpinski,et al.  Measurements of Hydraulic-Fracture-Induced Seismicity in Gas Shales , 2012 .