A Case Study on Lightning Protection, Current Injection Measurements, and Model

A newly built pharmaceutical plant has been investigated by measurements. Currents of 0.3 kA were injected in the lightning protection grid on the roof. Inside the building, test cables of 100 m length followed a path typical for cables belonging to the installation. We measured induced cable currents and voltages. A reduced model of the building incorporated most of the designed current paths. Measurements and model showed that the roof steel skeleton carried about 80% of the current and the intended lightning conductors 20%. The calculated current through a cable support was larger than measured. This is explained by also considering a nearby nonintended conductor. For three types of cables, we determined the transfer impedances. The measurements and model have been combined and extrapolated to actual lightning.

[1]  F. Heidler,et al.  Magnetic fields and induced voltages in case of a direct strike—comparison of results obtained from measurements at a scaled building to those of IEC 62305-4 , 2007 .

[2]  W. Zischank,et al.  Laboratory simulation of direct lightning strokes to a modeled building: measurement of magnetic fields and induced voltages , 2004 .

[3]  H.T. Steenstra,et al.  Reduction of Conducted Interference by Steel Armor in Buried Cables: Measurements and Modeling , 2008, IEEE Transactions on Electromagnetic Compatibility.

[4]  I.A. Metwally,et al.  Magnetic fields and loop Voltages inside reduced- and full-scale structures produced by direct lightning strikes , 2006, IEEE Transactions on Electromagnetic Compatibility.

[5]  Vladimir A. Rakov,et al.  Transient response of a tall object to lightning , 2001 .

[7]  A.P.J. van Deursen,et al.  A self-optimizing discretization scheme for 2D boundary element calculations , 2001 .

[8]  Alex P. J. van Deursen,et al.  Differentiating/integrating measurement setup applied to railway environment , 2006, IEEE Transactions on Instrumentation and Measurement.

[9]  A.P.J. van Deursen,et al.  Finding weak spots in lightning protection , 2008, 2008 International Symposium on Electromagnetic Compatibility - EMC Europe.

[10]  Guido Ala,et al.  A simulation model for electromagnetic transients in lightning protection systems , 2002 .

[11]  S. Miyazaki,et al.  Role of Steel Frames of Buildings for Mitigation of Lightning-Induced Magnetic Fields , 2008, IEEE Transactions on Electromagnetic Compatibility.

[12]  G. Andrieu,et al.  Extension of the “Equivalent Cable Bundle Method” for Modeling Electromagnetic Emissions of Complex Cable Bundles , 2009, IEEE Transactions on Electromagnetic Compatibility.

[13]  T. Sarkar,et al.  Analysis of Time Response of Lossy Multiconductor Transmission Line Networks , 1987 .

[14]  Carl E. Baum,et al.  From the electromagnetic pulse to high-power electromagnetics , 1992, Proc. IEEE.

[15]  A.P.J. van Deursen,et al.  Reliable protection of electronics against lightning: some practical applications , 1998 .