A numerical and experimental study of mass transfer in spacer-filled channels: Effects of spacer geometrical characteristics and Schmidt number

A systematic study is presented on the effect of both Reynolds (Re) and Schmidt (Sc) numbers on Sherwood (Sh) number, for narrow channels with spacers, closely simulating conditions of feed-side channels in spiral-wound modules. Results of direct numerical simulations performed for the three-dimensional geometries resulting from non-woven cylindrical filament (net-type) spacers show the significant influence of spacer geometry on local Sh distributions. These distributions exhibit a tendency to be displaced towards lower values for more sparse spacer geometries, and towards higher values as the angle between crossing filaments is increased. Additionally, the distribution of the local time-averaged mass transfer coefficients is generally similar to the corresponding distribution of shear stresses at the channel walls, with a tendency to exhibit closer similarity with increasing Sc, as one would expect. To validate the results of numerical simulation, a significant amount of mass transfer data is reported for nine different prototype spacer geometries, plus a common commercial spacer, and three Sc numbers in each case. Correlations of average Sh are obtained for each geometry, in terms of Re and Sc numbers; the exponent of Sh dependence on Sc is near 0.4, as is also obtained from the numerical simulations. Moreover, in agreement with the numerical results, the experimental data reveal a similar trend in the dependence of the average Sh number on spacer geometrical characteristics, namely decreasing with increasing ratio L/D (of cell side L over filament diameter D) and increasing with the filaments crossing angle β. A mass transfer correlation is also proposed for the square-cell commercial spacer commonly used in RO/NF modules.

[1]  Anthony G. Fane,et al.  Implications of critical flux and cake enhanced osmotic pressure (CEOP) on colloidal fouling in reverse osmosis: Experimental observations , 2008 .

[2]  Sandeep K. Karode,et al.  Flow visualization through spacer filled channels by computational fluid dynamics I. , 2001 .

[3]  Thomas J. Hanratty,et al.  A study of turbulence at a wall using an electrochemical wall shear-stress meter , 1966, Journal of Fluid Mechanics.

[4]  E. Sparrow,et al.  Fully Developed Flow and Heat Transfer in Ducts Having Streamwise-Periodic Variations of Cross-Sectional Area , 1977 .

[5]  J. Robert Selman,et al.  Mass-Transfer Measurements by the Limiting-Current Technique , 1978 .

[6]  S. G. Yiantsios,et al.  Direct numerical simulation of flow in spacer-filled channels: Effect of spacer geometrical characteristics , 2007 .

[7]  F. Li,et al.  Experimental validation of CFD mass transfer simulations in flat channels with non-woven net spacers , 2004 .

[8]  Matthias Wessling,et al.  Multi-layer spacer geometries with improved mass transport , 2006 .

[9]  Kuo-Lun Tung,et al.  CFD simulation of fluid flow through spacer-filled membrane module : selecting suitable cell types for periodic boundary conditions , 2008 .

[10]  Viriato Semiao,et al.  The effect of the ladder-type spacers configuration in NF spiral-wound modules on the concentration boundary layers disruption☆ , 2002 .

[11]  Osamu Kuroda,et al.  Characteristics of flow and mass transfer rate in an electrodialyzer compartment including spacer , 1983 .

[12]  Viriato Semiao,et al.  Flow management in nanofiltration spiral wound modules with ladder-type spacers , 2002 .

[13]  A. B. de Haan,et al.  Optimization of commercial net spacers in spiral wound membrane modules , 2002 .

[14]  C. C. Zimmerer,et al.  Effects of spacer geometry on pressure drop, mass transfer, mixing behavior, and residence time distribution , 1996 .

[15]  Anthony G. Fane,et al.  Optimal channel spacer design for ultrafiltration , 1991 .

[16]  Study of pulsing flow in a trickle bed using the electrodiffusion technique , 1994 .

[17]  Dianne E. Wiley,et al.  Numerical study of mass transfer in three-dimensional spacer-filled narrow channels with steady flow , 2007 .

[18]  Vítor Geraldes,et al.  Generalized mass-transfer correction factor for nanofiltration and reverse osmosis , 2006 .

[19]  Thomas J. Hanratty,et al.  An experimental study of the unsteady nature of the viscous sublayer , 1963 .

[20]  David F. Fletcher,et al.  Spiral wound modules and spacers - Review and analysis , 2004 .

[21]  A. Gosman,et al.  Solution of the implicitly discretised reacting flow equations by operator-splitting , 1986 .

[22]  J.L.C. Santos,et al.  Investigation of flow patterns and mass transfer in membrane module channels filled with flow-aligned spacers using computational fluid dynamics (CFD) , 2007 .

[23]  Vítor Geraldes,et al.  Nanofiltration mass transfer at the entrance region of a slit laminar flow , 1998 .

[24]  M. Elimelech,et al.  Cake-enhanced concentration polarization: a new fouling mechanism for salt-rejecting membranes. , 2003, Environmental science & technology.

[25]  S. G. Yiantsios,et al.  Colloidal fouling of RO membranes: an overview of key issues and efforts to develop improved prediction techniques , 2005 .

[26]  B. Mikic,et al.  Minimum-dissipation transport enhancement by flow destabilization: Reynolds’ analogy revisited , 1988, Journal of Fluid Mechanics.

[27]  Vítor Geraldes,et al.  Flow and mass transfer modelling of nanofiltration , 2001 .

[28]  A. B. de Haan,et al.  Optimization of non-woven spacers by CFD and validation by experiments , 2002 .

[29]  A. B. de Haan,et al.  Novel spacers for mass transfer enhancement in membrane separations , 2005 .

[30]  Viriato Semiao,et al.  The effect on mass transfer of momentum and concentration boundary layers at the entrance region of a slit with a nanofiltration membrane wall , 2002 .

[31]  P. Moin,et al.  The minimal flow unit in near-wall turbulence , 1991, Journal of Fluid Mechanics.

[32]  G. Schock,et al.  Mass transfer and pressure loss in spiral wound modules , 1987 .

[33]  T. J. Hanratty,et al.  Measurement of instantaneous rates of mass transfer to a small sink on a wall , 1962 .

[34]  T. J. Hanratty,et al.  Flow pattern in a close packed cubic array of spheres near the critical Reynolds number , 1973 .

[35]  S. G. Yiantsios,et al.  Numerical simulation of the flow in a plane-channel containing a periodic array of cylindrical turbulence promoters , 2004 .