Three, single-phase power factor correction (PFC) boost converters for use with three-phase, 3-wire variable frequency drive systems

Diode rectifier front ends with large DC bus capacitors used in Variable Frequency Drives (VFDs) draw discontinuous current from the power system resulting in poor input power factor and high input current distortion. In case of single-phase AC to DC rectifiers, the single-phase boost converter is popular and effective in improving the input power factor and reducing the input current harmonics. However, the same topology does not lend itself for easy use with three-phase 3-wire system since there is no neutral in the system and the boosted voltage necessary for satisfactory operation is beyond the safe voltage level for Variable Frequency Drives (VFDs). This paper discusses a novel idea of using 3, single-phase boost converters in a three-phase, 3-wire system, commonly found in many commercial and industrial locations. To resolve the high DC bus voltage associated with boosting line-line voltage, the method relies on boosting line-neutral voltage instead. The neutral point for the proposed topology is obtained from a zigzag autotransformer rated at only 0.1pu of rated load VA. Experimental results from a 480V, 15hp system are given to prove the concept.

[1]  H. Li,et al.  High active mode efficiency switching mode power supply , 2008, 2008 Twenty-Third Annual IEEE Applied Power Electronics Conference and Exposition.

[2]  Sewan Choi A three-phase unity-power-factor diode rectifier with active input current shaping , 2005, IEEE Trans. Ind. Electron..

[3]  Jaehong Hahn,et al.  A new three-phase power-factor correction (PFC) scheme using two single-phase PFC modules , 2002 .

[4]  I. Barbi,et al.  An improved high power factor and low cost three-phase rectifier , 1995, Proceedings of 1995 IEEE Applied Power Electronics Conference and Exposition - APEC'95.

[5]  M. S. Elmore Input current ripple cancellation in synchronized, parallel connected critically continuous boost converters , 1996, Proceedings of Applied Power Electronics Conference. APEC '96.

[6]  Johann W. Kolar,et al.  A novel three-phase utility interface minimizing line current harmonics of high-power telecommunications rectifier modules , 1997, IEEE Trans. Ind. Electron..

[7]  J. Salmon Circuit topologies for single-phase voltage-doubler boost rectifiers , 1992, [Proceedings] APEC '92 Seventh Annual Applied Power Electronics Conference and Exposition.

[8]  R. Steigerwald,et al.  An AC to DC converter with high quality input waveforms , 1982 .

[9]  Mahesh M. Swamy An electronically isolated 12 pulse autotransformer rectification scheme to improve input power factor and lower harmonic distortion in variable frequency drives , 2014 .

[10]  Fred C. Lee,et al.  Implementation of single-phase boost power-factor-correction circuits in three-phase applications , 1997, IEEE Trans. Ind. Electron..

[11]  Robert L. Steigerwald,et al.  An AC-to-DC Converter with High Quality Input Waveforms , 1983, IEEE Transactions on Industry Applications.