Health condition monitoring of insulated joints based on axle box acceleration measurements

This paper presents a health condition monitoring system for insulated rail joints (IRJs) based on axle box acceleration (ABA) measurements. The ABA signals from all the wheels of the measuring train are processed to extract those characteristics that better represent the quality of the IRJ. Then, different indicators are used for damage assessment, the most relevant being a set of frequency bands in the ABA power spectrum. A detection algorithm is proposed based on the derived frequency characteristics of the ABA signal. We compared the responses of IRJs in good condition with those in poor condition. Track inspections were performed to validate the health condition monitoring methodology in different IRJs of the Dutch railway network. The hit rate of IRJs detection was 84% for two validated tracks. The damage assessment procedure allowed to prioritize the IRJs that require maintenance. This information is useful for the railway inframanagers as it allows to predict where safety compromises will be faced. plants.

[1]  Nirmal Kumar Mandal,et al.  Sub-modelling for the ratchetting failure of insulated rail joints , 2013 .

[2]  Zili Li,et al.  Identification of characteristic frequencies of damaged railway tracks using field hammer test measurements , 2015 .

[3]  D Lyon,et al.  THE EFFECT OF TRACK AND VEHICLE PARAMETERS ON WHEEL/RAIL VERTICAL DYNAMIC FORCES , 1974 .

[4]  K. L. Johnson,et al.  The Dynamic Response of Railway Track to High Frequency Vertical Excitation , 1982 .

[5]  Elena Kabo,et al.  Deterioration of insulated rail joints – a three-year field study , 2012 .

[6]  Rolf Dollevoet,et al.  Validation of a finite element model for axle box acceleration at squats in the high frequency range , 2014 .

[7]  C. Esveld,et al.  An investigation into the causes of squats—Correlation analysis and numerical modeling , 2008 .

[8]  Ra Mayville,et al.  Numerical analysis of a railroad bolt hole fracture problem , 1995 .

[9]  Luis E. Suarez,et al.  Applications of wavelet transforms to damage detection in frame structures , 2004 .

[10]  Ingrid Daubechies,et al.  The wavelet transform, time-frequency localization and signal analysis , 1990, IEEE Trans. Inf. Theory.

[11]  Johannes O. Royset,et al.  Engineering Decisions under Risk Averseness , 2015 .

[12]  K. M. Liew,et al.  Application of Wavelet Theory for Crack Identification in Structures , 1998 .

[13]  Aditya Parida,et al.  Development of an integrity index for benchmarking and monitoring rail infrastructure: application of composite indicators , 2015 .

[14]  Rolf Dollevoet,et al.  Differential wear and plastic deformation as causes of squat at track local stiffness change combined with other track short defects , 2008 .

[15]  T. X. Wu,et al.  On the impact noise generation due to a wheel passing over rail joints , 2003 .

[16]  Rolf Dollevoet,et al.  Experimental Investigation Into the Condition of Insulated Rail Joints by Impact Excitation , 2015 .

[17]  Xuesong Jin,et al.  Contact-impact stress analysis of rail joint region using the dynamic finite element method , 2005 .

[18]  Rolf Dollevoet,et al.  Improvements in Axle Box Acceleration Measurements for the Detection of Light Squats in Railway Infrastructure , 2015, IEEE Transactions on Industrial Electronics.

[19]  Jens C. O. Nielsen,et al.  Rail corrugation in The Netherlands—measurements and simulations , 2002 .

[20]  Jao-Hwa Kuang,et al.  Contact stress variations near the insulated rail joints , 2002 .

[21]  Manicka Dhanasekar,et al.  Performance of square and inclined insulated rail joints based on field strain measurements , 2011 .

[22]  Etienne Côme,et al.  Combined use of sensor data and structural knowledge processed by Bayesian network: Application to a railway diagnosis aid scheme , 2008 .

[23]  Mark Dougherty,et al.  Condition monitoring of wooden railway sleepers , 2009 .

[24]  Arnold D. Kerr,et al.  Analysis and tests of boned insulted rail joints subjected to vertical wheel loads , 1999 .

[25]  Xiaomin Deng,et al.  Damage detection with spatial wavelets , 1999 .

[26]  A. Ibanez,et al.  Railway wheel-flat detection and measurement by ultrasound , 2011 .

[27]  Nirmal Kumar Mandal,et al.  Impact forces at dipped rail joints , 2016 .

[28]  Anders Ekberg,et al.  Numerical study of the mechanical deterioration of insulated rail joints , 2009 .

[29]  Sakdirat Kaewunruen,et al.  Experimental Investigation on Dynamic Railway Sleeper/Ballast Interaction , 2006 .

[30]  David A. Dillard,et al.  Finite element analysis of bonded insulated rail joints , 2008 .

[31]  C. Torrence,et al.  A Practical Guide to Wavelet Analysis. , 1998 .

[32]  David D Davis,et al.  Improved Insulated Rail Joints for High Tonnage Lines with Heavy-Axle Loads , 2007 .

[33]  Nirmal Kumar Mandal,et al.  On the low cycle fatigue failure of insulated rail joints (IRJs) , 2014 .

[34]  Manicka Dhanasekar,et al.  Dynamic finite element analysis of the wheel rail interaction adjacent to the insulated rail joints , 2006 .

[35]  R H Plaut,et al.  Analysis of tapered, adhesively bonded, insulated rail joints , 2007 .

[36]  Sakdirat Kaewunruen,et al.  An Alternative Rail Pad Tester for Measuring Dynamic Properties of Rail Pads Under Large Preloads , 2008 .

[37]  Rolf Dollevoet,et al.  Parametric study of axle box acceleration at squats , 2015 .

[38]  D D Davis,et al.  IMPROVING THE PERFORMANCE OF BONDED INSULATED JOINTS , 2005 .

[39]  Jens C. O. Nielsen,et al.  Prediction of dynamic train–track interaction and subsequent material deterioration in the presence of insulated rail joints , 2006 .

[40]  Michael N. Grussing,et al.  Beyond mandated track safety inspections using a mission-focused, knowledge-based approach , 2013 .

[41]  Manicka Dhanasekar,et al.  Service Condition of Railroad Corridors around the Insulated Rail Joints , 2013 .