Stress and Strain Analysis of Pipelines with Localized Metal Loss

This paper presents the analysis of stress and strain data acquired with the finite element method and with tests that used post-yielding strain gages bonded onto the external surface of pipes that suffered thickness metal loss and that had been loaded with internal pressure. These metal loss areas were produced by three different processes: actual internal corrosion, careful machining of external patches by spark-erosion, and milling of internal or external patches to simulate limited or extensive strip corrosion defects with depths up to 70% of the pipe’s thickness. Results show that: (1) the extensive longitudinal internal or external defect areas behave as extensive strips with a high degree of freedom to deform elastically and plastically in the circumferential and thickness directions, and (2) large restraints are offered to the longitudinal strains by the non-corroded thick walls parallel to the strip. Using the above experimental observation, a simple mathematical model was developed to predict the burst pressure of pipes with longitudinal extensive and reasonably constant depths of metal loss. This model employed thin-pipe-strength-of-material equations associated to a bulging correction factor, the material’s uniaxial ultimate strength and the von Mises criterion. The onset of plastic collapse predicted by the simple model was successfully compared with results determined from actual hydrostatic tests that were carried out with full scale pipe specimens and from finite element results generated by the use of a commercial program. The developed model was also helpful in showing that the yield and burst behaviors of new or corroded pipeline specimens under laboratory test conditions can be directly compared and extended to the yield and burst behaviors of buried pipeline in field operation.