Study on the structure and property of lead tellurium alloy as the positive grid of lead-acid batteries

Abstract A series of novel Pb–Te binary alloys with different contents of tellurium (0.01–1.0 wt.%) were investigated as the positive grid of a lead acid battery. The microstructure of Pb–Te alloys was observed using a polarizing microscope. The morphology of the corrosion layers and corroded surfaces of Pb and Pb–Te alloy electrodes were analyzed by scanning electron microscopy (SEM) following the corrosion test. The electrochemical properties of Pb–Te alloys and Pb–Te–Sn alloy in sulfuric acid solution were investigated by cyclic voltammetry (CV), open circuit potential (OCP), electrochemical impedance spectroscopy (EIS), alternating current voltammetry (ACV), and linear sweeping voltammetry (LSV). The results indicate that the introduction of tellurium results in grain refinement, increased corrosion resistance, and an accelerated oxygen evolution reaction for the Pb–Te binary alloys. The passive films formed on Pb–Te–Sn alloy shows improved performances in comparison to those on Pb–Ca–Sn alloy.

[1]  Hou-Tian Liu,et al.  Comparison of Pb–Sm–Sn and Pb–Ca–Sn alloys for the positive grids in a lead acid battery , 2004 .

[2]  A. Hollenkamp,et al.  Premature capacity-loss mechanisms in lead/acid batteries , 1992 .

[3]  R. David Prengaman,et al.  Challenges from corrosion-resistant grid alloys in lead acid battery manufacturing , 2001 .

[4]  S. Dou,et al.  Influence of silver on electrochemical and corrosion behaviours of Pb–Ca–Sn–Al grid alloys Part I: Potentiodynamic and potentiostatic studies , 1999 .

[5]  Hongyu Chen,et al.  Oxygen evolution reaction on lead–bismuth alloys in sulfuric acid solution , 2006 .

[6]  E. Bashtavelova,et al.  The PbO2 agglomerate-of-spheres: investigation of four grid materials , 1997 .

[7]  Jun Furukawa,et al.  Development of new positive-grid alloy and its application to long-life batteries for automotive industry , 2004 .

[8]  M. A. El-Galil,et al.  Role of minor alloying elements on the performance of lead/acid battery grids. Part 2. Corrosion of lead-arsenic alloys , 1996 .

[9]  P. Steyer,et al.  Analysis of tin in lead oxide by Mössbauer spectrometry and transmission electron microscopy , 1997 .

[10]  D. Pavlov.  Effect of corrosion layer on phenomena that cause premature capacity loss in lead/acid batteries , 1994 .

[11]  J. E. Manders,et al.  Structure and properties of lead–calcium–tin alloys for battery grids , 1998 .

[12]  Hou-Tian Liu,et al.  Effect of cerium on the anodic corrosion of Pb–Ca–Sn alloy in sulfuric acid solution , 2001 .

[13]  B. Popov,et al.  Effect of Sn and Ca doping on the corrosion of Pb anodes in lead acid batteries , 2002 .