Managing and maximizing the output power of a triboelectric nanogenerator by controlled tip–electrode air-discharging and application for UV sensing

Abstract Using a switch has been verified as a promising strategy for managing and enhancing the output performances of a triboelectric nanogenerator (TENG). How to design a switch without external triggering is still a challenge. Here, a self-powered air discharge switch with a tip-plate configuration is developed, in which the switch's on/off state is controlled by the voltage of the TENG itself. The electric output of the TENG can be enhanced and modulated by changing the tip-plate distance of the switch. Compared with the same TENG without a switch, the instantaneous power peak and the total output energy on a load resistance lower than 2 MΩ are increased by 1600 times and 31 times, respectively, as the switch works in an arc discharge mode. It is found that the UV light can change the switch from an arc discharge mode to a corona discharge mode, which increases the equivalent resistance of the switch and decreases the output current of the TENG. The current ratio of this UV detector reaches 18.6, and the lowest detectable light intensity is 26.2 μW/cm2. Using air discharge switch is a promising route for managing TENG's output power and developing active self-powered UV sensor.

[1]  Gang Cheng,et al.  Triboelectric Nanogenerator as an Active UV Photodetector , 2014 .

[2]  Zhong Lin Wang,et al.  Single-electrode-based rotationary triboelectric nanogenerator and its applications as self-powered contact area and eccentric angle sensors , 2015 .

[3]  Morrow.  Theory of negative corona in oxygen. , 1985, Physical review. A, General physics.

[4]  Zhong Lin Wang,et al.  Segmentally structured disk triboelectric nanogenerator for harvesting rotational mechanical energy. , 2013, Nano letters.

[5]  Zhong Lin Wang,et al.  Harvesting Water Drop Energy by a Sequential Contact‐Electrification and Electrostatic‐Induction Process , 2014, Advanced materials.

[6]  Jianhui Yu,et al.  A criterion for UV detection of AC corona inception in a rod-plane air gap , 2011, IEEE Transactions on Dielectrics and Electrical Insulation.

[7]  Andrew G. Glen,et al.  APPL , 2001 .

[8]  G. Zhu,et al.  A Shape‐Adaptive Thin‐Film‐Based Approach for 50% High‐Efficiency Energy Generation Through Micro‐Grating Sliding Electrification , 2014, Advanced materials.

[9]  Jianhua Hao,et al.  Wind energy and blue energy harvesting based on magnetic-assisted noncontact triboelectric nanogenerator , 2016 .

[10]  J. Davidson,et al.  Model of the Negative DC Corona Plasma: Comparison to the Positive DC Corona Plasma , 2003 .

[11]  Zhong-Lin Wang,et al.  Increase Output Energy and Operation Frequency of a Triboelectric Nanogenerator by Two Grounded Electrodes Approach , 2014 .

[12]  Jianhua Hao,et al.  Fully self-healing and shape-tailorable triboelectric nanogenerators based on healable polymer and magnetic-assisted electrode , 2017 .

[13]  Tao Jiang,et al.  Universal power management strategy for triboelectric nanogenerator , 2017 .

[14]  Yunlong Zi,et al.  Triboelectric nanogenerators for sensitive nano-coulomb molecular mass spectrometry. , 2017, Nature nanotechnology.

[15]  Zhong Lin Wang,et al.  Sliding-triboelectric nanogenerators based on in-plane charge-separation mechanism. , 2013, Nano letters.

[16]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[17]  Jianhua Hao,et al.  Magnetic‐Assisted Noncontact Triboelectric Nanogenerator Converting Mechanical Energy into Electricity and Light Emissions , 2016, Advanced materials.

[18]  L. Vasilyak,et al.  Effect of the rise rate of nanosecond high-voltage pulses on the breakdown of air gaps , 1999 .

[19]  Yu Song,et al.  High efficiency power management and charge boosting strategy for a triboelectric nanogenerator , 2017 .