论文信息 - Transient velocity induced by electric injection in blade-plane geometry

Transient velocity induced by electric injection in blade-plane geometry

Electric charge injection in blade-plane geometry has been widely studied. Previous works on this geometry were carried out with a DC electrical signal. In this paper, a Heaviside step voltage is applied on the device in order to observe the liquid transient behavior. Particle Image Velocimetry (PIV) measurements are performed on negative and positive voltage steps. The transient behavior of the velocity induced by charge injection is discussed for both polarities. The influence of the frequency of an AC square signal is also investigated, and a comparison between AC and DC behaviors is presented.

[1] Jamal Seyed-Yagoobi,et al. Experimental Study of Electrohydrodynamic Pumping Through Conduction Phenomenon , 2000, Heat Transfer: Volume 4.

[2] J. Seyed-Yagoobi. Electrohydrodynamic pumping of dielectric liquids , 2005 .

[3] Jamal Seyed-Yagoobi,et al. Electrohydrodynamically induced dielectric liquid flow through pure conduction in point/plane geometry , 2003 .

[4] Alberto T. Pérez,et al. The electrohydrodynamic plume between a line source of ions and a flat plate-theory and experiment , 1992 .

[5] Jinhee Jeong,et al. On the identification of a vortex , 1995, Journal of Fluid Mechanics.

[6] P. Atten,et al. Role of EHD Motion in the Electrical Conduction of Liquids in a Blade-Plane Geometry , 1985, IEEE Transactions on Industry Applications.

[7] Electrohydrodynamical characteristics of a dielectric liquid flow induced by charge injection , 2008, 2008 IEEE International Conference on Dielectric Liquids.

[8] S. Takata,et al. Properties of liquid jet induced by electrohydrodynamic pumping in dielectric liquids , 2002 .

[9] M. Daaboul,et al. PIV measurements on charged plumes-influence of SiO2 seeding particles on the electrical behavior , 2009, IEEE Transactions on Dielectrics and Electrical Insulation.