Takagi-Sugeno PD+I fuzzy control of processes with variable moment of inertia

The paper presents aspects related to the design and implementation of a Takagi-Sugeno (TS) proportionalderivative (PD) + integral (I) fuzzy controller for processes with variable moment of inertia. A two-step design method for the TS PD+I fuzzy controller applied to position control systems is proposed. The first step concerns the Extended Symmetrical Optimum method-based tuning of the parameters of linear PID controllers organized in a parallel scheme. The second step deals first with the fuzzification of the linear PD component in the PID controller scheme resulting in the TS PD fuzzy block (TS PD FB). The modal equivalence principle is next employed to tune the parameters of TS PD FB that operates as a bump-less interpolator between separately tuned PD controllers placed in the rule consequents. The presentation is focused on the position control of a representative mechatronics application with variable moment of inertia, namely the laboratory equipment built around the Model 220 Industrial Plant Emulator. Experimental results are given to validate the PID controllers and design method in several case studies. The comparison of TS PD+I fuzzy controller versus PID controllers is supported by experimental results.

[1]  Imre J. Rudas,et al.  Active Knowledge for the Situation-driven Control of Product Definition , 2013 .

[2]  Maurizio Naldi,et al.  A traffic-based evolutionary algorithm for network clustering , 2013, Appl. Soft Comput..

[3]  László T. Kóczy,et al.  Supervised training algorithms for B-Spline neural networks and neuro-fuzzy systems , 2002, Int. J. Syst. Sci..

[4]  Napoleon H. Reyes,et al.  Use and Perspectives of Fuzzy Cognitive Maps in Robotics , 2014, Fuzzy Cognitive Maps for Applied Sciences and Engineering.

[5]  Gyo-Bum Chung,et al.  Fuzzy PID Controller for Output Regulation of Asymmetric Half-Bridge DC/DC Converter with Current Doubler , 2007, 2007 IEEE Power Electronics Specialists Conference.

[6]  Emil M. Petriu,et al.  Experiment-Based Teaching in Advanced Control Engineering , 2011, IEEE Transactions on Education.

[7]  Marius-Lucian Tomescu,et al.  Fuzzy Logic Control System Stability Analysis Based on Lyapunov's Direct Method , 2009, Int. J. Comput. Commun. Control.

[8]  Stefan Preitl,et al.  Gravitational search algorithm-based design of fuzzy control systems with a reduced parametric sensitivity , 2013, Inf. Sci..

[9]  Manuel Glez Bedia,et al.  Exploration/Exploitation in CBR Systems: A Formal Analysis , 2013 .

[10]  N. Demerdash,et al.  Application of Optimal Fuzzy PID Controller Design: PI Control for Nonlinear Induction Motor , 2006, 2006 6th World Congress on Intelligent Control and Automation.

[11]  Claudia-Adina Dragos,et al.  Novel Tensor Product Models for Automatic Transmission System Control , 2012, IEEE Systems Journal.

[12]  Shihua Li,et al.  Fuzzy Adaptive Internal Model Control Schemes for PMSM Speed-Regulation System , 2012, IEEE Transactions on Industrial Informatics.

[13]  Zhiqiang Gao,et al.  A novel motion control design approach based on active disturbance rejection , 2001 .

[14]  Zhiqiang Gao,et al.  On Validation of Extended State Observer Through Analysis and Experimentation , 2012 .

[15]  Leonardo Acho,et al.  Robust Control Design for Mechanisms with Backlash , 2013 .

[16]  Masami Saeki,et al.  Anti-windup compensator design considering behavior of controller state , 2010, 2010 IEEE International Conference on Control Applications.

[17]  Claudia-Adina Dragos,et al.  Iterative performance improvement of fuzzy control systems for three tank systems , 2012, Expert Syst. Appl..

[18]  Ngoc Thanh Nguyen,et al.  A combined negative selection algorithm-particle swarm optimization for an email spam detection system , 2015, Eng. Appl. Artif. Intell..

[19]  Horia-Nicolai Teodorescu.  On the Characteristic Functions of Fuzzy Systems , 2013, Int. J. Comput. Commun. Control.

[20]  Mohamad Fadzli Haniff,et al.  Designing an optimal Fuzzy-PID controller for speed tracking of stepper motor , 2012, 2012 IEEE Symposium on Industrial Electronics and Applications.

[21]  Christopher Hoyt.  Developing equivalent second order system models and robust controls for servo-drive related systems , 2009 .

[22]  Sylvie Galichet,et al.  Fuzzy controllers: synthesis and equivalences , 1995, IEEE Trans. Fuzzy Syst..

[23]  Masami Saeki,et al.  A Data-Driven PID Control Design by Linear Programming for Stable Plants , 2011 .

[24]  José Neves,et al.  Interactive Guiding and Localization Platform , 2014 .

[25]  Stefan Preitl,et al.  An extension of tuning relations after symmetrical optimum method for PI and PID controllers , 1999, Autom..

[26]  Drago Matko,et al.  Quadrocopter Hovering Using Position-estimation Information from Inertial Sensors and a High-delay Video System , 2012, J. Intell. Robotic Syst..

[27]  Eneko Osaba,et al.  AMCPA: A Population Metaheuristic With Adaptive Crossover Probability and Multi-Crossover Mechanism for Solving Combinatorial Optimization Problems , 2014 .

[28]  Claudia-Adina Dragos,et al.  Solutions to avoid the worst case scenario in driving systems working under continuously variable conditions , 2013, 2013 IEEE 9th International Conference on Computational Cybernetics (ICCC).

[29]  Dingyu Xue,et al.  A Novel Fuzzy Model-Reference Adaptive Control , 2006, World Congress on Intelligent Control and Automation.

[30]  Radu Calinescu,et al.  Large-scale complex IT systems , 2011, Commun. ACM.

[31]  Zhiqiang Gao,et al.  A comparison study of advanced state observer design techniques , 2003, Proceedings of the 2003 American Control Conference, 2003..

[32]  Z. Johanyák,et al.  A Hybrid Algorithm for Parameter Tuning in Fuzzy Model Identification , 2012, Acta Polytechnica Hungarica.

[33]  Robert Piotrowski,et al.  A Model-Based Improved Control of Dissolved Oxygen Concentration in Sequencing Wastewater Batch Reactor , 2014 .

[34]  Rodolfo E. Haber,et al.  Nonlinear internal model control using neural networks: an application for machining processes , 2004, Neural Computing & Applications.