Highly Stable Carbon‐Free Ag/Co3O4‐Cathodes for Lithium‐Air Batteries: Electrochemical and Structural Investigations

Lithium‐air batteries with an aqueous alkaline electrolyte promise a much higher practical energy density and capacity than conventional lithium‐ion batteries. However, high cathode overpotentials are some of the main problems during cycling. In our previous work, a catalyst combination of Ag and Co3O4 is found that reduces overpotential significantly, and is highly active and also long‐term stable. In the present investigations, X‐ray diffraction and X‐ray photoelectron spectroscopy are applied to study the structure and composition of the cathode material during oxygen reduction reaction and oxygen evolution reaction. Changes of the oxidation states during cycling are responsible for an enhanced oxygen evolution reaction current density but also for losses due to a lower electronic conductivity of the electrodes. The presence and formation of a mixed oxidation state for silver oxide (AgIAgIIIO2) at high potentials is identified. In contradiction to literature, time dependent X‐ray diffraction measurements evidence that this phase is not stable under dry conditions and progressively decays to Ag2O. Electrode mappings show a highly homogeneous oxidation of the electrodes during cycling and quantitative analysis of the observed phases is carried out by Rietveld analysis. Long‐term material behavior completes the investigations.

[1]  K. Friedrich,et al.  A Highly Efficient Bifunctional Catalyst for Alkaline Air-Electrodes Based on a Ag and Co3O4 Hybrid: RRDE and Online DEMS Insights , 2015 .

[2]  K. Friedrich,et al.  Modified carbon-free silver electrodes for the use as cathodes in lithium–air batteries with an aqueous alkaline electrolyte , 2014 .

[3]  W. Bessler,et al.  Reaction and transport in Ag/Ag2O gas diffusion electrodes of aqueous Li–O2 batteries: Experiments and modeling , 2014 .

[4]  K. S. Dhathathreyan,et al.  Bifunctional electrocatalyst for oxygen/air electrodes , 2014 .

[5]  W. Bessler,et al.  Precipitation in aqueous lithium–oxygen batteries: a model-based analysis , 2013 .

[6]  N. Imanishi,et al.  Carbon electrode with perovskite-oxide catalyst for aqueous electrolyte lithium-air secondary batteries , 2013 .

[7]  K. Friedrich,et al.  Screening and further investigations on promising bi-functional catalysts for metal–air batteries with an aqueous alkaline electrolyte , 2013, Journal of Applied Electrochemistry.

[8]  S. Shi,et al.  Exploration on the possibility of Ni foam as current collector in rechargeable lithium-air batteries , 2013 .

[9]  Y. Xing,et al.  A hybrid Li-air battery with buckypaper air cathode and sulfuric acid electrolyte , 2012 .

[10]  Zhixiang Liu,et al.  Preparation of high-capacity air electrode for lithium-air batteries , 2012 .

[11]  Guangyuan Zheng,et al.  Rechargeable Li–O2 batteries with a covalently coupled MnCo2O4–graphene hybrid as an oxygen cathode catalyst , 2012 .

[12]  K. Edström,et al.  Influence of the cathode porosity on the discharge performance of the lithiumoxygen battery , 2011 .

[13]  T. Ishihara,et al.  Mesoporous α-MnO2/Pd catalyst air electrode for rechargeable lithium–air battery , 2011 .

[14]  G. Graff,et al.  Investigation of the rechargeability of Li–O2 batteries in non-aqueous electrolyte , 2011 .

[15]  Ping He,et al.  The effect of alkalinity and temperature on the performance of lithium-air fuel cell with hybrid ele , 2011 .

[16]  Xiangwu Zhang,et al.  Lithiumoxygen batteriesLimiting factors that affect performance , 2011 .

[17]  P. Bruce,et al.  Reactions in the rechargeable lithium-O2 battery with alkyl carbonate electrolytes. , 2011, Journal of the American Chemical Society.

[18]  Haoshen Zhou,et al.  Li-air rechargeable battery based on metal-free graphene nanosheet catalysts. , 2011, ACS nano.

[19]  B. Kumar,et al.  Electrochemical performance of highly mesoporous nitrogen doped carbon cathode in lithium-oxygen batteries , 2011 .

[20]  Sanjeev Mukerjee,et al.  Rechargeable Lithium/TEGDME- LiPF6 ∕ O2 Battery , 2011 .

[21]  Yair Ein-Eli,et al.  Review on Liair batteriesOpportunities, limitations and perspective , 2011 .

[22]  Jasim Ahmed,et al.  A Critical Review of Li/Air Batteries , 2011 .

[23]  B. McCloskey,et al.  Lithium−Air Battery: Promise and Challenges , 2010 .

[24]  Jeffrey Read,et al.  Discharge characteristic of a non-aqueous electrolyte Li/O2 battery , 2010 .

[25]  Yuanyuan Xie,et al.  Ag nanowires and its application as electrode materials in electrochemical capacitor , 2010 .

[26]  Haoshen Zhou,et al.  A lithium-air battery with a potential to continuously reduce O2 from air for delivering energy , 2010 .

[27]  I. Valov,et al.  Electrocatalysts for bifunctional oxygen/air electrodes , 2008 .

[28]  D. Tudela.  Silver(II) Oxide or Silver(I,III) Oxide?. , 2008 .

[29]  E. Ticianelli,et al.  Silver-cobalt bimetallic particles for oxygen reduction in alkaline media , 2006 .

[30]  Ludwig Jörissen,et al.  Bifunctional oxygen/air electrodes , 2006 .

[31]  Geoffrey I N Waterhouse,et al.  The thermal decomposition of silver (I, III) oxide: A combined XRD, FT-IR and Raman spectroscopic study , 2001 .

[32]  R. Hesse,et al.  Peak shape analysis of core level photoelectron spectra using UNIFIT for WINDOWS , 1999 .

[33]  J. Weaver,et al.  SURFACE CHARACTERIZATION STUDY OF THE THERMAL DECOMPOSITION OF AGO , 1994 .

[34]  W. Epling,et al.  AgO XPS Spectra , 1994 .

[35]  G. Pacchioni,et al.  Chemical shifts of the core-level binding energies for the alkaline-earth oxides , 1992 .

[36]  W. Stickle,et al.  Handbook of X-Ray Photoelectron Spectroscopy , 1992 .

[37]  J. R. Vilche,et al.  Comparative voltammetric behaviour of the silver/silver oxide electrode prepared on vitreous carbon and silver substrates , 1988 .

[38]  D. R. Penn,et al.  Calculations of electron inelastic mean free paths for 31 materials , 1988 .

[39]  S. Dallek,et al.  Decomposition Kinetics of AgO Cathode Material by Thermogravimetry , 1986 .

[40]  J. R. Vilche,et al.  The electroformation and electroreduction of anodic films formed on silver in 0.1 M sodium hydroxide in the potential range of the Ag/Ag2O couple , 1984 .

[41]  J. R. Vilche,et al.  Complex potentiodynamic response of silver in alkaline Electrolytes in the potential range of the Ag/Ag2O Couple , 1982 .

[42]  A. Proctor,et al.  Data analysis techniques in x-ray photoelectron spectroscopy , 1982 .

[43]  R. A. Matula.  Electrical resistivity of copper, gold, palladium, and silver , 1979 .

[44]  D. W. Rice,et al.  Interpretation of the x-ray photoemission spectra of cobalt oxides and cobalt oxide surfaces , 1976 .

[45]  C. Swahn,et al.  ESCA STUDIES OF AG, AG2O AND AGO , 1973 .

[46]  D. A. Shirley,et al.  High-Resolution X-Ray Photoemission Spectrum of the Valence Bands of Gold , 1972 .

[47]  N. A. Hampson,et al.  The electrochemistry of oxides of silver—a short review , 1971 .

[48]  A. Tvarusko.  The Electric Resistivity of AgO , 1968 .

[49]  F. Weichman,et al.  Photoconductivity in Ag2O , 1964, 1964.

[50]  J. Mcmillan.  Higher Oxidation States of Silver. , 1962 .

[51]  P. Weidenthaler.  Chemisorption von gasen an silber(I)-oxyd , 1961 .

[52]  P. Rüetschi,et al.  The Silver‐Silver Oxide Electrode , 1960 .

[53]  J. A. McMillan.  Magnetic properties and crystalline structure of AgO , 1960 .