Site-matched assessment of structural and tissue properties of cortical bone using scanning acoustic microscopy and synchrotron radiation μCT

200 MHz scanning acoustic microscopy (SAM) and synchrotron radiation muCT (SR-muCT) were used to assess microstructural parameters and tissue properties in site-matched regions of interest in cortical bone. Anterior and postero-lateral regions of ten cross sections from human cortical radius were explored. Structural parameters, including diameter and number of Haversian canals per cortical area (Ca.Dm, N.Ca/Ar) and porosity Po were assessed with both methods using a custom-developed image fusion and analysis software. Acoustic impedance Z and degree of mineralization of bone DMB were extracted separately for osteonal and interstitial tissues from the fused images. Structural parameter estimations obtained from radiographic and acoustic images were almost identical. DMB and impedance values were in the range between 0.77 and 1.28 g cm(-3) and 5.13 and 12.1 Mrayl, respectively. Interindividual and regional variations were observed, whereas the strongest difference was found between osteonal and interstitial tissues (Z: 7.2 +/- 1.1 Mrayl versus 9.3 +/- 1.0 Mrayl, DMB: 1.06 +/- 0.07 g cm(-3) versus 1.16 +/- 0.05 g cm(-3), paired t-test, p < 0.05). Weak, but significant correlations between DMB and Z were obtained for the osteonal (R(2) = 0.174, p < 10(-4)) and for the pooled (osteonal and interstitial) data. The regression of the pooled osteonal and interstitial tissue data follows a second-order polynomial (R(2) = 0.39, p < 10(-4)). Both modalities fulfil the requirement for a simultaneous evaluation of cortical bone microstructure and material properties at the tissue level. While SAM inspection is limited to the evaluation of carefully prepared sample surfaces, SR-muCT provides volumetric information on the tissue without substantial preparation requirements. However, SAM provides a quantitative estimate of elastic properties at the tissue level that cannot be captured by SR-muCT.

[1]  M. Panjabi,et al.  Effects of freezing and freeze‐drying on the biomechanical properties of rat bone , 1984, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[2]  L Kinzl,et al.  Correlation of bone mineral density with strength and microstructural parameters of cortical bone in vitro. , 2002, Bone.

[3]  Determination of the velocity of ultrasound by short pulse switched sinusoidal excitation and phase-sensitive detection by a computer-controlled pulse-echo system , 1998 .

[4]  Françoise Peyrin,et al.  Bone microstructure and elastic tissue properties are reflected in QUS axial transmission measurements. , 2005, Ultrasound in medicine & biology.

[5]  D. Altman,et al.  STATISTICAL METHODS FOR ASSESSING AGREEMENT BETWEEN TWO METHODS OF CLINICAL MEASUREMENT , 1986, The Lancet.

[6]  Françoise Peyrin,et al.  Quantification of the degree of mineralization of bone in three dimensions using synchrotron radiation microtomography. , 2002, Medical physics.

[7]  C. Hernandez,et al.  Osteocyte density in woven bone. , 2004, Bone.

[8]  Laurent Pothuaud,et al.  Three‐Dimensional‐Line Skeleton Graph Analysis of High‐Resolution Magnetic Resonance Images: A Validation Study From 34‐μm‐Resolution Microcomputed Tomography , 2002, Journal of bone and mineral research : the official journal of the American Society for Bone and Mineral Research.

[9]  Xiaodun Wang,et al.  Determination of cortical bone porosity and pore size distribution using a low field pulsed NMR approach , 2003, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[10]  F Peyrin,et al.  How is the indentation modulus of bone tissue related to its macroscopic elastic response? A validation study. , 2003, Journal of biomechanics.

[11]  K. Raum,et al.  Multilayer analysis: quantitative scanning acoustic microscopy for tissue characterization at a microscopic scale , 2003, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[12]  F. Linde,et al.  The effect of different storage methods on the mechanical properties of trabecular bone. , 1993, Journal of biomechanics.

[13]  Françoise Peyrin,et al.  Cortical Bone in the Human Femoral Neck: Three‐Dimensional Appearance and Porosity Using Synchrotron Radiation , 2004, Journal of bone and mineral research : the official journal of the American Society for Bone and Mineral Research.

[14]  Ultrasonic characterization of articular cartilage. , 2002, Biorheology.

[15]  P. Meunier,et al.  The Degree of Mineralization of Bone Tissue Measured by Computerized Quantitative Contact Microradiography , 2002, Calcified Tissue International.

[16]  Kay Raum,et al.  Assessment of composition and anisotropic elastic properties of secondary osteon lamellae. , 2006, Journal of biomechanics.

[17]  M. Stein,et al.  An Automated Analysis of Intracortical Porosity in Human Femoral Bone Across Age , 1999, Journal of bone and mineral research : the official journal of the American Society for Bone and Mineral Research.

[18]  F. Peyrin,et al.  Synchrotron radiation microCT: a reference tool for the characterization of bone samples. , 2001, Advances in experimental medicine and biology.

[19]  D Vashishth,et al.  Determination of bone volume by osteocyte population , 2002, The Anatomical record.

[20]  Kay Raum,et al.  Frequency and resolution dependence of the anisotropic impedance estimation in cortical bone using time-resolved scanning acoustic microscopy. , 2004, Journal of biomedical materials research. Part A.

[21]  Robin O Cleveland,et al.  Derivation of elastic stiffness from site-matched mineral density and acoustic impedance maps , 2006, Physics in medicine and biology.

[22]  B. Williams,et al.  AETIOLOGY OF STRIAE GRAVIDARUM , 1974 .

[23]  S. Goldstein,et al.  Elastic modulus and hardness of cortical and trabecular bone lamellae measured by nanoindentation in the human femur. , 1999, Journal of biomechanics.

[24]  P Zioupos,et al.  The anisotropic Young's modulus of equine secondary osteones and interstitial bone determined by nanoindentation. , 2001, The Journal of experimental biology.

[25]  J. Rho,et al.  Atomic force microscopy and nanoindentation characterization of human lamellar bone prepared by microtome sectioning and mechanical polishing technique. , 2003, Journal of biomedical materials research. Part A.

[26]  P Cloetens,et al.  A synchrotron radiation microtomography system for the analysis of trabecular bone samples. , 1999, Medical physics.

[27]  L. Claes,et al.  Prediction of cortical bone porosityIn Vitro by microcomputed tomography , 2007, Calcified Tissue International.